i got a windows 7 2012 virus by downloading a picture so i wanted to use my homemade recovery disks that i made when i first purchased the laptop and i dont know how to use it. i pressed f2 to go to boot options but cds wasnt listed, also when i restarted the laptop with the cds inside it doesnt prompt me to do anything, it justs boots normally. how do i use these disks?!
View 5 RepliesIs there a repair with these disks? I am getting a BOOTMGR missing but I checked the hard drive and it is fine. I do not want to lose anything because I have a lot on it.I cloned my image about 5 days ago and I may go that route, however, I have done things since then and don't want to lose the data. Before I load the HP Recovery disks (4 of them, and I had to order them for free except pay for shipping), is there a repair option?
View 4 Replies View RelatedMy rather new Acer Predator G has been acting up lately. I tried a restore point but this doesn't seem to help. As a last resort I was going to format the disk and re-install 7, however Acer never sent me recovery disks and I don't have 7 disks (Came pre-loaded). So my question is, if I can find someone with windows 7 disks can I use them + The CD key that's on the label of my desktop? Or do I need specific ones? Acer will send me recovery disks for 20$ but If I can pull this off for cheaper, I'd like to.
View 3 Replies View RelatedI have a 2 year old Gateway laptop (NV5929u) i5 430M w/ 4GB. It came with Windows 7 Home Premium 64-bit installed. The computer crashed with a blue screen a few months ago, and I could not locate the recovery disks, so I ordered a set from Gateway (1 System disk, 2 Recovery disks, 1 Language disk). My attempts at recovery were unsuccessful and I got the msg: failure disk 0 partition 3. I replaced the HD with a brand new one yesterday. My attempts at recovery went a bit further, to the point that the computer loads the information on the various disks, but when it tries to restart.
View 1 Replies View RelatedI have the original recovery disks I made when I first got my laptop and am wondering if I could use them to install windows 7 onto my desktop?A few details if needed...laptop - toshiba satellite p755d 4 months[CODE]
View 7 Replies View RelatedI have a HP pavilion DV6 windows 7 that came with back up discs and I cannot get them to work! How do I do this?
View 2 Replies View RelatedI had to replace the hard drive. Have no recovery or windows disks. What do I need and where can I get it??
Just built a new PC, specs as follows:
3770K
32GB DDR3
ASRock Z77 Extreme6
Crucial M4 128GB (from previous build)
OCZ Vertex 4 128GB
WD 400GB (from previous previous build)
I got Windows 7 up and running on the Crucial drive (connected at SATA3_1, with the WD connected and functioning on SATA3_A1) and then decided it was time to get Xubuntu up and running on the OCZ (SATA3_0). So I installed rEFInd on the Crucial's ESP and it worked - I was able to launch Windows 7 from the rEFInd menu. I then disconnected the Crucial and connected the OCZ, and installed Xubuntu. In the UEFI, I set rEFInd as the boot device/manager, and from the rEFInd menu I can select Xubuntu and Windows 7 - great. However, I can only actually boot Xubuntu; booting Windows 7 results in a Windows Error Recovery loop.Disconnecting all but the Crucial SSD, I can get into Startup Repair. It attempts repair for several minutes, fails with the following details:Quote :Problem signature:
Problem Event Name: StartupRepairOffline
Problem Signature 01: 6.1.7600.16385
Problem Signature 02: 6.1.7600.16385
Problem Signature 03: unknown
[code]....
Trying to create the 3 recovery discs for my new computer with Windows 7. It keeps asking for a clean disc even though I am putting in new formatted disc. I was able to create the System Recovery Disk with no trouble.
View 5 Replies View RelatedMy Laptop came preloaded with Windows 7 Home Premium and I would like to create system recovery disks. I have a drive labeled RECOVERY (D. How do I create recovery disks from this drive?
View 9 Replies View Relatedi have question, where can i download original Recovery Disks for my Packard Bell Easynote TSX66-HR-263CZ notebook? i cannot find them on the original page of packard bell..
View 4 Replies View RelatedI have a toshiba satellite L740 laptop. I have created the recovery disks from recovery media creator. I am trying to reinstall windows 7 using these disks but i'm not knowing how to do that. I am not able to enter the bios settings on start up. Should i have the original windows 7 installation cd to reinstall windows or can i use the recovery disks? I was not given any windows installation cd when i bought this laptop.
View 4 Replies View RelatedNot only do I get Error Code= 1117, I also get an I/O device error, how can I reboot if there are errors?
View 1 Replies View Relatedmy 5 month old computer would no longer boot, it automatically ran start up repair, after about 6 hours said could not repair, took me to restore, but then said couldn't restore due to I/O error, tried recovery option with data back up with disks but get fail due to I/O error, tried again on the complete factory restore and got error of not enough memory to complete. can I recover my system?
View 9 Replies View RelatedHaving crashed my wife's dual-boot system, and the HP recovery section is no longer available. We have got it back up using the hp windows 7 update disk from hp. (had vista). What I need to know is best way to back up our data before I crash something again. Will windows 7 help me build "recovery" disks that also back up our personal data... or should I back up our personal data another way? We have no Windows 7 installation disk - just the upgrade disk from HP (Vista to Windows 7). Reason for asking: I have 2 corrupted partitions in linux that I need to reformat and I want our data backed up before I start.
View 4 Replies View RelatedMy hard drive crashed on my laptop. Before It crashed, It gave me a hard drive warning of imminent failure, and gave me an option to create recovery disks. I ended up creating 11 disks from the option. I installed the new hard drive and the BIOS reads that it will boot from the internal optical drive first. When I insert the first CD and start then computer, it continues to read "Operating system not found". When I look at the CD in another computer, it reads three files and one folder. The first file is an icon file which reads "Setup", the next is a "Media" bin file, and the last is an autorun setup information file. The last is a folder that contains various other backup files. My computer did not come with any copies of windows.
View 1 Replies View Relatedi am using acer 5745g, when i tried to use the recovery disks created earlier, it is unable to load even i tried everything from the boot menu..
View 1 Replies View Relatedwhich of the 5 recovery disks from geek squad has install media for device?
View 1 Replies View RelatedI purchased a upgrade version of Windows 7 with both 32 bit and 64 bit disks. I have two computers; one 64 bit and one 32 bit - can I use both disks?
View 5 Replies View RelatedI was given a Pavilion DV9000z by my sister who had purchased a replacement for herself. She wiped the two installed hard drives and clean installed windows 7. It appears that there is a 100MB systemm reserved partiion on one disk (total size 320GB, the rest of which was unpartitioned when I got it), and the operating system was loaded on the second disk (120 GB).I had a dead Vista laptop which had a 100GB SATA drive. I wanted to reformat it to have as a sppare. If I pull either one of the original drives out it won't boot. If I take out the 320 GB drive (with the 100MB partition) the laptop either goes black screen (if I move the 120 GB drive into the primary bay) or tries to boot Vista (if I put the scavanged hard drive in the primary bay), or tells me operating system files are lost (if I pull the 120 GB drive and replace it with the scavanged drive).So it appears to me that the 100MB partition on the 320 GB drive is waht the system is booting from, but that it won't load Windows 7 unless the second drive is also there.Is there any way to move the system reserved partition to the 120 GB drive? Or the operating system files to the 320 GB drive? It scares me that if either drive dies, the system won't boot.
View 12 Replies View RelatedAlmost every Windows application that tries to deal with my new Blu-Ray drive via a Windows dialogue insists on trying to format the BD-R disk first.
You can't format a BD-R disk, it's write-once and formatting would effectively destroy the disk, at $4 a pop.
BD-R disks don't need formatting, those applications that can handle them properly and independently do just fine without formatting.
If I tell it "no, don't format the thing", then Windows insists there's no disk in the drive.
How can I tell Windows 7/64 SP1 to quit trying to format BD-R disks, and recognize them correctly?
Iv'e put a game in the machine to install and it comes up with the autorun option and i select to run installer.exe and then the comp just does nothing. just sits there as if i havent entered any commands whatsoever. what can i do?
View 4 Replies View RelatedI saw thread on similar problem and mentioned I need to make sure services.msc -> Virtual Disk Service (VDS) to automatic and started. I made this change and click the install again. The same message shown again.After message the VDS will stopped. I can restart and try install again. no luck.I also try sfc/scannow and no luck.My laptop is HP dv2000.
View 2 Replies View RelatedMy computer has two 1GB HDDs.Disk C: is the boot disk and is running Windows 7 64 bit upgraded from Vista 64.Can I use the same Win 7 disk (and key) to install to Drive E: as a clean install? I think the new installation would pickup a dual boot system and give me the option as to which I wanted to use.I understand that I can't use the same disk for two different machines.But can I use it for two installations on the same machine?
View 4 Replies View RelatedSo, I recently bought a used computer from CL. The machine is a Dell Laptop that originally had Windows Vista installed on it. The original owner upgraded to Windows 7 Enterprise and had a bunch of new software installed on the machine. (FL Studio, Photoshop, etc.)I was able to use the computer successfully for the first day until I installed iTunes. Something went wrong, and now when I boot up in normal mode Windows will freeze as soon as i try to open anything. I can open the Start menu, but anything past that will cause a freeze. The computer works fine in all Safe ModesSo, what I would like to do is restore Windows 7 to it's original configurations and still be able to keep all those great programs already installed. However, I do not any of the Windows 7 media that was used for the upgrade. What can I do? Will creating a system image work, or will I end up just copying the freeze problem if I do that?
View 3 Replies View RelatedCan you limit the amount of ram windows is allowed to use?
Example I want windows to use 10gb of my ram and I am planing on using the other 22GB as a ram disk
I am looking at reformatting my computer, the only thing holding me back is a matter of software. I have a windows 7 professional 64-bit disk which came under the OEM licence, and I purchased Microsoft office 2010 on-line (I have an installer and a disk I had shipped to me). Would reformatting my computer and reinstalling windows require me to use one of my uses of either of the mentioned pieces of software? And where could I find how many uses I have (if it is indeed limited).
View 9 Replies View RelatedI've installed Win7 on a 500GB Sata II disk and was running fine. Then something happened, boot manager missing, and I need to re-install Win7 on same disk. Now I get a message, when installing on the SAME DISK: "Windows cannot be installed to this disk. The selected disk has an MBR partition table. On EFI systems, Windows can only be installed to GPT disks."
This disk just had Win7 installed on it and is still there (but boot manager is still missing) so how can the disk have an MBR partition? I got this same msg. when trying to install Win7 on a clean Samsung 128GB SSD as well. I re-formatted the drive and still same msg. How can I make my disk formatted with GPT partitions instead of MBR partitions? I can find no choices in terms of which kind of formatting and partitions that can be used when formatting disks on Win7 or XP Pro.
I am going to build a gaming rig in the future when i have the money to, but windows 7 install disks are very expencive, but i already have a laptop with windows 7 AND all my programs. it constantly prompts me to make restore disks (then when i click yes without haveing a dvd in the tray it still starts the proses for some reason) so, if i got it to function properly and i made my 2 restore disks (it said it would take 2 disks for complete burn) could i use them to instal windows and my programs onto the new computer? would save me 130 or so dollars (if i could get it to work right) so it would be great if someone could confirm this.
View 13 Replies View RelatedIf a pc was upgraded to Windows 7 from Vista, and we want downgrade Win7 back to Vista, can we use the original Recovery disks (from the Vista OS) to do this? I know Windows 7 is a better OS, but this is due to software incompatibility issues.
View 2 Replies View RelatedWhen trying to backup to removable media ( CD or DVD ) Windows tries to format blank disks. I believe this will not work, look at the following link. Windows Backup does not back up to CD-R, CD-RW, or DVD-R devices It would appear this type of medium is not supported.
View 1 Replies View Related