i currentlly have a 500 gb hard drive with windows xp home on it and i have an extra hard drive sitting on my desk, a seagate barracuda 1 tb hard drive, and i will be purhasing xp por 64-bit, and i wanna know if i can just put in my 1 tb hard drive and install xp pro on that and then to choose wich os to run, i know dual botting is possible im just not sure how i am going to go about installing it onto my 1 tb hard drive
I am attempting to install Win XP Pro into a second partition to dual boot with an original install of Win XP Home. Both are installed and working with the exception of an application that I installed in Win XP Pro that apparently has some hardcoded assumptions that the product is installed on the C: drive. Since Win XP Home was the originally installed OS, it has drive letter C:, with Win XP Pro getting assigned drive letter E: when it boots.
Ideally, I would like to have each OS bootup with its boot partition appearing as drive letter C:. The other OSes boot partition doesn't necessarily have to even be seen when the other OS boots, although it would be nice. There is also a third partition on the drive which I need to be available to each OS when booted, again preferably as the same drive letter. There are also a CD-R and CD-RW drive installed, which prior to the Win XP Pro install appeared as drive letters D: and E:.At this point I am looking for the easiest/quickest way to obtain the desired results, ideally without having to uninstall/remove either or both. I am willing to look at a third party boot and/or partition manager as well as manually switching between active partitions within Win XP Home or Pro prior to reboot.
I would like to load XP Pro on an XP Home PC and have a dual boot (do not want to lose the software by a fresh install) Can I have 2 operating systems on the same partition?
With all reasons aside for now (mainly because it would be too much typing), if I were to create another small partition other than my main "C" partition on my 320 Gig drive and install XP Pro on the small partition then would that cause problems and conflicts with my main C partition? The small partition that XP pro would be going on would have the drive letter "G" since I already have "D, E and F" taken up by another physical hard drive, DVD-RAM drive and Removable Disk.
So basically my question is that if I make a small partition "G" on my 320 that has my main partition "C" on it, would I be able to boot normally with each one and not have any conflicts? Also, I assume I would have to download a boot loader. Which boot loader is the best to use? And, this is kind of an experiment process in that I don't know that I will even keep the G partition so if I were to reformat the "G" partition and add the space back to the "C" partition then how would I go about removing the no longer needed boot loader?
I recently built my new dual core PC and I have set up my bios, etc. I'm ready to install an OS. What I'm wondering is - what is better for a dual core pc? XP Pro or XP Home and why?
Is it possible that having both windows xp home and pro installed on my computer could mess things up. I have this, and have noticed programs that used to work just fine crash.
I upgraded an XP Home PC to XP Pro using an upgrade disk and some how have got a dual boot situation. On start up I get the option to boot up in XP Home or XP Pro. I just want XP pro how can I get it to cancel the dual boot and go straight to XP Pro
I was having trouble accessing my Windows XP Home edition from my dual boot Windows XP Home/Windows 2000 Professional system. I used both Win2K and WinXP CDs and their respective repair functions and no help. When I select the Windows XP Home operating system from the boot select menu I get a message that some file for Windows 2000 is corrupt and to use the Windows 2000 CD or F8 function.
I have a four year old eMachines that has expired and isn't worth repairing. I would like to use the OEM Windows XP Home restore disc from this computer to dual-boot my Vista machine (HP Pavilion a1730n). Is this:
1. possible? 2. ethical?
I want to do this because I can't use many of my programs on the Vista machine. If I can dual-boot the eMachines restore disc I can use Windows Home until vendors catch up with Vista.
All things were fine and I had XP pro and XP home installed and working on seperate drives. I have just reinstalled XP pro and now on booting, no option to choose either operating system appears. I have done some searching and have seen references to copying a boot file from the CD and placing it into the XP home operating system to fix this. The instructions were not that detailed and not directly related to having 2 XP installs. nearly all search results I have found related to Xp dual booting with Vista. I have been thinking of now copying ALL the files from the XP Home operating system into the new XP Pro and then reinstalling the XP Home system. Sigh. I cannot use the system repair/recovery option as I do not know the Admin password. where did I put that? Is there an easy fix to get the dual boot working again?
I recently purchased a notebook with XP Home SP@ proinstalled. I upgraded to XP Pro but had to do a complete intall rather than an upgrade because my xp pro update cd was older than xp home sp2. I now have a windows (xp home) and a windowsp (xp pro) folder.
I have installed XP Pro on my D drive in order to practise for the MCDST. However the WLAN drivers for XP Home don't work for XP Pro. Do XP Home and XP Pro require different drivers? Because all other hardware works fine.
I have Windows XP home edition already installed on my system and I for some reasons I want to reinstall them on a different hard drive (I have 2 IDE drives). It is very important that my initial windows setup, the one I am running on now, will be working after the new installation too. Is that possible?
I have been trying to install Windows XP as a second OS as I already have Windows 7 Ultimate installed. Unfortunately, after I select a partition, format it, and reboot the system stalls on the screen after the BIOS that has something to do with a list of devices and such. After 10 or so seconds a few characters and letters go blank randomly on the page. I rebooted and selected my cd drive as the boot device and accidentally didn't press a button in time to boot and a bunch of highlighted numbers were thrown all over the screen and a random smiley face on one of the lines.
I'm trying to dual boot 2 different installs of xp pro from 2 drives using the Windows boot loader. I've edited the boot.ini every possible way I can think of, but nothing works. I've done this plenty of times using a linux boot loader or dual booting from a single drive but I cant figure this out. I haven't been able to find any reference to this subject anywhere, but I think it would work. Anybody have a clue as to how to do this? I know I can use a different boot manager to accomplish this, I just wanted to make the Win boot.ini work. Or, does anybody know of a good boot manager if I cant make this work?
I have dual booting on my PC with Vista home premium on a 500 Gb SATA disk and XP Pro on a 250Gb SATA, both internal. Vista no longer holds terrors for me and I'd like to get rid of XP and regain better use of the 250Gb HD. Can I just remove XP from the control panel in the XP boot or is it a lot more complicated?I don't really want to re format the XP drive as I'd have to transfer a lot of data and files
I have Win XP home installed as OEM software on the C drive of my PC. I also have this OS as a Norton Ghost file supplied with the PC as a "Recovery CD". I have installed a second hard drive designated "D" This all works fine. I wish to install Win 2000 (which I have on a Microsoft cd) on the second HD. I would then hope at boot - up to be given the choice of which OS to load. Can anyone tell me what is the simplest way to do this?
I am trying to set up a home network to connect my laptop (with xp pro) to my desktop (with xp home) i am using a 3com office conect router as a hub. With the fire walls on each machine switched off I can see each of the machines from each other.I can share files on the laptop with the desktop, but when I try to access the desktop from the laptop I get the following message : xxxxxxx is not accessible. You might not have permission to use this network resource. Login Failure : the user has not been granted the requested logon type at this computer.
I'm trying to share folders between two laptops set up on a home wifi workgroup. Currently, both laptops are "seeing" each other's share folders (as mapped network drives), and both laptops have full internet access I have allowed simple file sharing on the XP Pro system. I have also set the firewalls to allow access, and I'm using AVG firewall instead of Windows firewall.However, only one of the computers is allowing access to the other. The XP Pro computer can access the share folders on the XP Home computer, but not vice versa. When using the XP Home computer, I can map the shared folders on the XP Pro computer, but when I try to access them, I get denied access.
Just got a new pc with windows xp home sp2... when I open up windows all the icons are really big! and when I go on the internet the pages are too big for the screen. this was not the case with my previous PC also with xp home sp2.
Is this possible? I recently tried to install Linux, maybe it was FreeBSD, not sure i'd have to go home to look but i'm at work.... Anyways I tried to install the second OS on my ext. HD but, you guessed it... PC wouldn't boot to the ext. HD. I want to do the so i can learn and expand my knowledge etc. but it isn't looking very do-able I don't think that there is a place in my PC tower to insert the hard drive into.. ie 2 hard drives.
i plugged in my secondary monitor and my primary quit working, now the secondary shows the screen but my primary just has a box floating around that says self test feature check... i just want more work space, can someone help me?
I'm using a Sony laptop and have an external screen attached. I've set up XP to use both the external and built in laptop screen and also checked the "Extend my Windows desktop on to this monitor". This all works ok with one exception.
As I sit in front of my laptop the external monitor is to my left. In order to get the mouse on to the external display (on my left) I have to drag my mouse pointer to the far right of the laptop display.
I've tried making the external monitor the primary display but this doesn't help me either.
Is there a way I can tell XP that I want the mouse to move to secondary display when I drag the it to the left hand side of my primary display?
i have a pc with 2 ports for monitors i am using the dvi ouput to my plasma tv (through a dvi to 15 pin converter) which works fine. however i cant seem to get my other 15 point outlet to work.
I am assuming i have to activate some sort of dual monitor software? I am using xp basically how do i use 2 monitors simultaneously
In win xp pro sp2 I get a dual log in, and man does it bug me. First I get the old nt style log on, but I get an error that says I can't log in this way(yes that is paraphrased). Then I click ok and it moves to tthe typical windows xp log in style. How do I make each of these go away?