When i put in teh Win xp disc its starts loading teh file etc.. and then when done after i press enter and "Setup is starting windows" its freezes andi get liek A black dot and a few like patterns on the screen or soemtimes teh screen just goes mad liek with different colourd patterns but ontop of the blue "Setup is starting windows" screen ive checked teh disc and made a copy both work fine checked teh CD rom works fine put a diffremnt cd rom drive in and made no difference cant check ram because my computer doesnt take DDR2. ive put diffrent IDE harddives in with and without a SATA convoertor and the same thing happens with the "Setup is starting windows" also when i start the computer up before i boot from cd or anything after all that without booting from CD i get a BSOD code 0x07B.
Im installing Win XP Pro (SP2) on a HP Pavilion zv6000 laptop. Everything runs fine until I start installing windows xp. The cd boots and the "Setup is loading files" goes through but then stalls at "Setup is starting windows". Waited for 2 hours just in case and still the same results.From what I can gather this points to a hardware problem. I have tried different ram modules and removed the battery but all to no avail.Could this be a processor or motherboard problem? I did everything the person above me did and then I took the hard drive out, reformatted it and tried installing XP SP2, Windows Home and the recovery cd supplied by HP. Every time it is gets to "Setup is Starting Windows" it freezes. I know the hard drive is working since I tested it in another computer. The reason I needed to reload XP is the notebook would load and get to the Windows XP loading screen and then freeze.It wouldn't boot in safe mode either.
I can't get XP Pro to get past "Setup is starting Windows" ,to allow me to format.Loads all drivers up to that point,then the error in above post.Pressing F6 or F10 to install 3rd party(XFX MB drivers) has no effect,and Alt-F2 ultimately gives error also.S prompt is no joy also.Tried F8 for Safe Boot and no joy.Cleared CMOS several times.All drives are there in CMOS. All RAM (4 Gigs) is detected I raised Memory voltage to 1.9 volts standard for my ram),and raised FSB to 1600 Mhz from 1333 (standard also).Put timings to standard 7-7-7-24T Tried Memory linked/unlinked/Auto/1T/2T I Tried only 1 SATA drive,and 1 Gig of RAM with 1 DVD RW /2 drives and 2 Gig of RAM,I Enabled standard RAID for each and every drive and ultimately disabled them cause I want the XFX 790i ultra motherboard RAID Drivers.
I have an old system I am installing a new hard drive in and trying to install Windows XP Pro on it. It's the only hard drive in the system, a Western Digital 500GB SATA. The MB is a Intel D102GGC2 with a Intel Pen D processor. Windows has run just find on this system. Replaced the hard drive because could not boot the installed windows. That hard drive is no longer installed in the system.
I insert the Windows CD and the install process goes fine till it tries to start windows setup. It stalls at "Setup is starting windows"
I am trying to install xp on this good friend of mine's machine that took a dive last week. We replaced the motherboard, cpu, and memory. And afterwords for about 3 days, it seemed to function ok. Then it just quit booting. I told him we would need to reinstall windows. I was kind of shocked we did not have to in the first place. Anyways, So now I am trying to reinstall windows:I can get it to boot from the windows cd, it goes through the standard list of drivers, and at the end says, "setup is starting windows"... Then it just hangs there indefinately. Typically after this, you get to the screen that asks you if you want to install windows, then you hit f8 to agree to there stuff, then you get to partition ect. I mention these things so you will know what part I am talking about.
I have an Intel 945GTP motherboard running XP Pro on a SATA HDD that, until last week, worked just fine. Then, it decided not to boot up one morning, in either regular or safe mode.It won't boot from the CDROM drive either. It does boot from floppy.I've replaced RAM, taken out all non-essential hardware, replaced HDD cables.HDD can be recognised in another system.Mouse and KB are not usb.I removed the HDD partition, intending to reload XP, but the load hangs on "setup is starting windows" and never goes anywhere - i left it overnight, just to be sure.I repartitioned and reformatted using a 98 disk, just for kicks, to see if it'd work. Yep, boots to c:> HDD manufacturer's diagnostic reports no errors.I have put in another, new SATA HDD, as well as a new ide hdd.
I have a slight problem. I just recently replaced both my power supply and my hard drive, and when I try to install Windows, a blue screen pops up which runs through everything it's doing. No problem, right? Wrong.What's happening is: it says "Setup is starting Windows", and that screen does not disappear. It stays that way and never goes away.
A new 250 gig seagate SATA 7200.8 hard drive and a win xp home upgrade edition. enabled SATA in BIOS, connected SATA cable to SATA1 on mobo, BIOS didn't recognize the drive, connected to SATA2 and BIOS did recognize drive so I tried to partition and format using Seagate's DiscWizard from floppy. Things seemed to go fine until I got a message that format wasn't completed because of some error.I went ahead and tried to install from xp cd, loaded SATA drivers from floppy, cd started loading but then hangs up at "setup is starting windows"I've never used SATA before.
I'm trying to do a clean install on a laptop and every time I try to install Windows XP Pro, it hangs at the screen that says "Setup is starting Windows" I've also tried installing Windows 2000.
I am trying to install XP Pro on a machine with an AMD K6 clocked at 266mhz and 160mb of RAM. This is a laptop currently running Windows 98 SE. 98 works fine for me but I hate installing drivers. The laptop is an Compaq Presario 1235. I just want the laptop running XP, it doesn't have to be lightning fast. In setup, it hangs at Setup is Starting Windows. It does the same when installing Win2k.
I got some time and checked the available disk space. Out of 33MB I had 10MB left. I cleaned some stuff up and compressed the disk. Things worked well all day yesterday and then today we got this again.
I haven't been able to get the computer to start up now. I turn it off, and it hangs/freezes while it's starting back up. I did get it to load in safe mode,
i am trying to install windows xp service pack 3. but the windows on that kept freezing at the same point, every time it loaded to a state where i couldnt even move the mouse, was working perfectly fine before. i inserted the windows xp sp3 disk, and formatted the hard drive to ntfs (quick) and then the files started to copy, once that was done, it restarted and the actual installation part started. it went from 39 minutes down to 35 minutes and froze on the installing devices part. i thought it was a common error so i restarted the setup. this time it went to 34 minutes and froze. most of the times it would get stuck on 34/35 minutes and either froze or restarted the laptop for no reason. Only once, it went down to 23 minutes and froze. only 2 out of 30 tries went past the install devices section.
I went to try to install windows xp onto a computer that already had windows on it. I did not boot from the cd. To do it without using the cd it has to copy the installation files to the computer and then run them. When setup does this it creates a new choice of an operating system to boot from called "Windows XP Setup." So now I have a Windows XP and a Windows XP setup. I've been in msconfig and looked at boot.ini but that didn't help
For about 2 months my computer (Sony VAIO desktop, Pentium IV 1.39 mHz, 512mb RAM, Windows XP Pro, SP2) has been acting strange. I have checked the system for viruses and spyware with AVG and Symmantec and others- with no luck. I also did a Windows repair; it only got worse. I also used reg scrub.First, when starting up it gets hung up at "Windows starting up..." taking about 3 minutes to finally get to the user selection page. Once I login, it takes another 2minutes to fully open up. At that point, my mouse has a constant flicker and takes forever to open up IE (6.0). If I leave the computer for awhile, when I come back and move my mouse to wake it up- it has some new problems: I cannot type in numbers (num lock has no effect), when I type letters, they are in all caps (caps lock off), and when I go to my desktop to select a program to start, it highlights all of the icons and says basically "do you really want to start 38 programs at once".
when opening windows xp the screen gets to the windows xp with the little green light going back and forth in the rectangle box. this green light goes back and forth 3 or 4 times then freezes and you cant go further then that.
I just recently installed windows xp home, and the computer freezes on "windows is starting up" screen for like 10 minutes. there's no malware and everything seems to be fine.
Got Vista Home premium installed on 1 HDD installed another HDD trying to install XP boots from CD goes into setup stage loads all drivers gives message at the bottom windows is starting up and then Blue Screen Of Death Gives error stop code:0x0000007B.
Im running windows XP Pro. upon starting the computer, when it gets to 'Windows is starting' screen, I'm made to wait at least some 3 minutes before I get to the Logon screen.
I have a compaq presario 2500 laptop with windows xp home edition sp1 installed. I had left my computer at the desktop screen to go do something and when I came back avast antivirus had come up with a message saying that one of my files was infected with a trojan. i believe the file was stored in the system or system32 folder. anyways, it had reccomended me to move the file to avast's "virus chest", so I did. and i went ahead and worked on my laptop as normal. then after shutting my computer down and starting it back up later in the day, i found that my laptop would not load any further than the blue "windows is starting up..." screen. i let it sit there for about 30 mins. so then i went to my desktop and started researching my problem on google. i tried going into safe mode, but it still gets stuck at the same screen.
My computer refuses to start telling me it is missing windows system32configsystem and suggests I start setup and type r to repair.I have done this and get a menu of commands which I dont have any idea how to use. I would be grateful if someone can give me step by step instruction on how to proceed.Instruction to do this followed by do next would get me through but it may help me in the future if an explanation of each step is given
When I boot my computer Windows freezes at the "Windows is starting..." screen but I can still move the mouse. This just began today. It does this same thing when I boot in the last good config and safe mode. So basically, Windows won't get past this screen no matter what mode I use.Also, I can't reinstall XP because I get a technical error blue screen that says I may not have adequate disk space, a driver may need to be disabled, or I may need to change the video adapter whenever I try to boot from the install CD. The message also says "pci.sys."
I have been noticing that whenever I reboot my computer, or even at random intervals, that the wave portion of the volume menu goes to zero and it makes the sound on my computer go very quiet. I can move the wave dial back to the max and everything works alright, but I was wondering if anyone has any ideas on why this would be happening. I am running the onboard sound which is nvidia based, but not sure if there are any more current drivers than what I am running.
Had to reformat my drive and now whenever i use my win xp sp2 install disc...i first format the drive and create the proper partition..the windows disc then starts copying files to the computer but at a point i get an error message saying that windows setup cannot copy the file...and it tells me which file. I redid this several times and each time at a some point in the copying it gives me this error...each time with a different file name What should i do at this stage?
I am trying to install windows xp sp 2 over windows xp on 2 computers and the same thing has happened with each computer.I get down to 36 minutes left - installing drivers - and the setup restarts. I tried to remove the cd and xp then asks for the cd telling me it needs the asms driver, xp then is directed to search e:I386. Xp looks for it there then spontaneously restarts again. The setup is in an endless loop going from 39 minutes remaining till 34 then restarting over and over again. How can I stop this and/or correct this? I did some research at the microsoft site but I have been unable to make anything work.
I want to install Windows XP Pro 64 Bit on my Hp dv9907ca, which came with Vista Home Premium 32 Bit. I upgraded my RAM to four gigs, and get better gaming on XP and I'd like to upgrade my 32 bit to 64, problem is, the installation hangs as soon as it gets to 'Setup is loading Windows' still int he text based installation. I believe I read somehwere it's because of some sort of hard drive connection that's in newer computers, and XP doesn't have drivers for it. So basically, I'm wondering if soeone can figure out what's wrong, and tell me exactly what I need to do in order to get XP to work, now this is a laptop so I can't change any parts in it or anything like that.
I recently purchased a Western Digital laptop hard drive for my HP Presario X1015US laptop - and got the part where it said : Setup did not find any hard disk drives installed on my computer. I have tried two new drives now and it is simply not getting past this point. I have gone in to the bios to ensure it is booting from Windows Operating System CD and it is still not finding. HP told me I have to check motherboard? Is there anything else I can do or am I going to need to buy a new laptop (the old hard drive is no longer working...started making weird noise).
