I can't find any disc title printer manufacturers that have a 64 bit driver for download for their little title printers. I have a casio CW-E60 and want to use it with my windows 7 64bit operating system.
View 2 RepliesI'm running Win7 64bit and can't seem to find 64bit drivers for the above mentioned printer. Is there a work-around for this?
View 5 Replies View Relatedmy hp printer will not load on to my pc
View 1 Replies View RelatedI got a pretty bad virus on my Asus G72GX-A1, from which I could not get rid off.After backing up decided to run the Windows 7 Recovery Media Disc included with the computer.I booted up the computer from the recovery disc, selected the language and selected recover windows 7 at HD with 2 partitions. The program starts a counter, which goes to 100%, afterwards it prompts me to insert the support disc. After inserting the disc, a cmd windows opens up and apparently it runs a program calles AsCopy.exe.After some time, the computer restarts and, at the Setup is starting services screen, an error message pops up with the following message: "Windows could not complete the installation.To install Windows on this computer, restart the installation."I did the same process over 10 times, tried the options of recovering just the windows partition and the entire HD, but I get the same problem over and over again.
View 3 Replies View RelatedI am trying to print a disc label on a dvd ,my printer is a Epson stylus photo Px650 .I have the software for the job but when I drag the into the software it says "this is not a epson cd print file.but I have printed dvd labels before with no problems but I can't remember if it was with XP but I am using windows 7 now .The I want to print is a jpeg is there a way to change it to an epson print file? and if so ,how do I do it?
View 4 Replies View RelatedI use Windows 7 Professional 64 bit. My problem is: Whenever I try to print something (word, pdf, or any other file); printer spooler stops working and when I check the Devices and Printers all the printer drivers seem to be disappeared. I checked the Print Spooler" in the Services tool; and set the "Recovery after subsequent failures" option to Restart the Service. Therefore all the printer drives coma back after 1 minute. However the spooler stops immediately again when the uncompleted printing job starts; hence I can not print anything more than a page. Earlier in this forum, someone posted that Microsoft issued a hotfix for this problem ( hotfix 2388142) which can be downloaded from article: [URL]. I downloaded this hotfix and tried to install, however it gives an error message of: The update is not applicable to your computer and quits installation. I did uninstall and reinstall all the printer drives, but this did not help either.
View 1 Replies View Relatedhow do i prevent this?
View 2 Replies View RelatedI'm just posting here because there are these video files which the title of the file is different to the 'name' of the file which appears below the icon. Although not the end of the world, it is annoying since when I put the files on my external HDD to play through my PS3 and that shows the title and as they all have the same title I can't tell what I am watching.
View 2 Replies View RelatedI have two applications. One is a game, another is a helper (sadly, not updated any longer). The helper program modifies the title bar of the game with some stats.
It displays correctly in XP, when I have Aero turned off and when I have clicked "Disable Desktop Composition" in compatibility, but not when Aero is running.
I'd like to disable aero (or just the titlebar transparency) for only this program but keep Aero running for everything else, is that possible?
I wanna hide this: How can i do it?
View 6 Replies View RelatedI have an application where the subwindows are placed too high so that the title bar of the subwindow is underneath the menus of the application window.
View 9 Replies View RelatedJust reinstalled Windows 7 x64 (no SP1) and I noticed a weird problem. It happens everywhere, but I can best explain it with Task Manager. If you have Task Manager open and you try to resize the window with your mouse, the top tabs (Applications, Processes, Services etc.) flicker.
I have "show windows contents while dragging" enabled. I have Windows classic theme, but I asked a friend with the default Windows 7 theme and he has the same problem.
I don't remember having this problem before re-installing Windows 7 and I have the same chipset/video drivers.
I have numbers in front of some my music files. Not tracknumbers. The numbers are included in the file name. (03 Sunflower or 01 - Beyond The Sea) etc. My question is, is there anyway to remove the numbers. I can do by renaming each file. Is there any to do this other than renaming one file at a time.
View 5 Replies View RelatedI have about 150 MP3's I want to play in order but my phone doesn't organise them by "name" like windows can, it organises them by the "title" they're assigned. Is there a fast way to change the # on these MP3's? I don't really want to go through them 1 by 1.
View 8 Replies View RelatedI can't find the "Advanced" choice under Display: I want to change the
� Active Title Bar color
� Inactive Title Bar color
� window color
� text color
� desktop background color
� Message Box color
etc Where's "Advanced"?(I'm running Windows 7 Home Premium, Service Pack 1)
My main consideration in choosing the appearance of my desktop and windows thereon is clarity, ease of reading any text, and distinguishing between windows at a glance, and also keeping performance to a maximum. To this end, having tried various Aero themes, although I did like the rounded corners of windows, for the sake of clarity I abandoned Aero for my own customized Windows Classic appearance. Not flashy but at least clearer for me than any of the other themes.When I installed Windows 7 I quickly reverted to Windows Classic, and chose for the active window title bar colours dark green as Color 1 and a lightish blue for Color 2 (with yellow text), so there was a gradient from green to blue along the title bar. I'm not bothered about whether anyone else likes that - it's served me well for the best combination of clarity and agreeableness through various Windows versions.
Yesterday I followed a tip from a magazine and ran the Windows 7 screen colour calibration facility. After I'd run that I noticed that all my active windows had just the dark green and no gradient. When I went into the Personalize facility to change that back, I found that Color 2 was greyed out, so that I could not set it again.I know this is a silly little point, but actually the gradient did make the active windows look less severe and 'blocky', and I'd like to restore my ability to set the second colour.Reverting to Aero is no option as far as I'm concerned, for to me multiple windows look to me extremely confusing in Aero, and some taskbar text is difficult to read, no matter what colour / lightness settings one uses.Somehow I doubt whether my calibrating the screen colours had anything to do with the little problem I've run into; I assume it must be just coincidence. I did, however, recently switch to manual a few supposedly non-essential services, and just possibly the change occurred then but I didn't notice it till after I'd done that screen colours calibration.
When I turn on Aero settings my desktop wallpaper is scrambled along with title bars of applications. Everything else will work fine for a bit, but after a while it 'crashes' and Aero is automatically turned off.
The card I'm using is the ASUS SILENT Radeon HD 3650.
I've searched the threads and solutions to no avail. One member has a similar issue and solved it by switching motherboards (started with a SIS 648 chipset). Unfortunately I only have a SIS 648 chipset motherboard available.
Has anyone else experienced this and found a solution? I've attached screenshots of the effects described.
I discovered the following entry in my taskbar toolbars: url...As you can see the blank entry does not appear when i right click on taskbar and select toolbars (taskbar1.png). However when i right click on taskbar and then click on properties, the last tab (toolbars) displays an unknown entry (not seen before) with blank title (taskbar2blank.png).I noticed that the same happens even when the system boots in safe mode.A google search didn't help much. I am very familiar with registry editing, but am unable to find the key where these toolbars are added. I also tried running hijackthis but it is very difficult to find something with no name.
View 1 Replies View RelatedI am running Windows7 64 bit which runs excellent, solid like a rock. The problem I have is it horrible when it comes to getting a printer to work. I have a KODAK ESP5250 all in one printer. I can print test pages fine but when I try to print from IE, Google Chrome, and note pad I get no response. When I click on printer properties location is blank.
View 8 Replies View RelatedWhen I click and drag on the title-bar of a window the window border moves to the new location then when I release the mouse the window springs into the re-located border.This has only started to happen after I changed the partition size of my c: drive. Obviously, some setting has been changed and I have no idea as to how to reset it.
View 9 Replies View RelatedI wish to display Contacts I have in one of my Categories by Title, Full Name and Address.
View 6 Replies View RelatedI've converted a MP3 to a WAV using "Roxio-Copy and Convert". When I did the conversion , there was an old song title ( from a previous conversion ) in the name slot. After the conversion I simply renamed the song to the correct name.If I play that song with any other software , it will have the correct name , if I use windows media player - it defaults back to the old name in the "Now Playing" screen.If I look at the song properties , there is no trace of the old name anywhere - how is media player finding this old ( incorrect ) name , and how do I stop it ? Problem is I have converted many songs with the wrong name - so its not just happening with one song.
View 3 Replies View RelatedI want to connect a printer which is attached with another PC using Win XP32bit.Printer: HP P2015Ive downloaded Win7 64bit PCL5 /PCl6 universal driver fro
View 1 Replies View RelatedI am unable to install my HP Laserjet 1200 printer through wireless network on my Laptop, operating system is Windows 7 (64 Bit).
View 3 Replies View RelatedI not able to connect TVS MSP 455 XL Classic printer from Windows XP 32bit to Windows 7 64bit.
View 1 Replies View RelatedI just bought a 64 bit lenovo pc and I do not have the 64 bit driver for my hp Deskjet 1000. I need this driver to print?
View 3 Replies View Relatedi have a windows 7 64 bit machine sharing a printer. the xp laptop tries to connect but gets a request for id and pw to connect to the win 7 machine.
View 2 Replies View Relatedmy blue ray player blue light come on and door open and cloes but when i go to my computer at dose not show up at all the other player dose
View 1 Replies View RelatedI've installed Windows 7 instead of Vista in my Vaio vgn-fw250j. After that cd-dvd does not read nor burn dvd's.
View 1 Replies View RelatedI have windows 7 on a acer notebook and able to use my HP 5610xi w/no problem. I recently bought an acer desktop emachine el1352g and cannot use my hp or some other software. It says that product cannot be installed with operating system. The only difference i can see is that the emachine desktop is a 64bit processor. I tried to go through hp (download driver) website but got no where.
View 5 Replies View RelatedI'm running the Windows 7 64bit, the printer is connected to the XP. That printer is not a network printer (Hp 5740,and 5520) , and shared from a Desktop running WinXP 32 bit. I cannot install it via network access ?
View 6 Replies View Related