I have a Compaq Presario s5200nx, with 512kb ram, 2.7 ghz Celeron processor, and now a 120 gb Western Digital hard drive. I took the original hard drive (120gb Samsung), which had windows xp installed and running fine, out and put it into a newer computer I built. I installed the 120 gb WD drive in (which also had a running version of XP installed on it) and it wouldn't boot. I then tried putting my windows xp cd in to reformat and reinstall, but everytime, it loads up, and then just says at the bottom "Starting Windows" and freezes at this. I then tried using the recovery cds that were made from this computer and put the first one it, It just gets to a screen that says "Compaq Recovery" and freezes at this. Next I took some "Quick Restore" cds I had from an older laptop and put those in. Everything seemed to be working fine until I got to the end where an error saying "Memory Error" came up, and the PC still wouldnt boot. I have tested the hard drive on other computers, works fine, as well as ran Western Digital's Diagnostics on it, which showed no errors.
I want to perform a Windows repair on a Compaq Presario desktop computer but the person doesn't have an OS CD. I think what Compaq does is put the setup files for windows on a seperate partition so you install it using their recovery console. However, if you do this then it reformats the hard drive no matter what. This is NOT what I want to do. So my question is, if I can get my hands on a Windows XP Home full install CD (The computer came with Home) and enter in the CD key that came on the side of the Compaq, will it work correctly?
i have a compaq presario notebook.when i m going to install windows xp sp2 then after drivers loading it shows a error message that suggest me to virus check and chkdisk.but after doing that it didn't work.
I was running a Compaq desktop on Windows XP Home Edition, halfway through an excel spreadsheet when my PC shut down. I have not been able to bootup again and keep getting a message to install WindowsRoot>System32hal.dell, I don't have a system recovery disk and now that I cannot boot up, I cannot use the recovery function on my PC either.
I have a desktop that is stating that I need to update my BOIS or my F7 key will not operate. the version for BIOS that I have is from February 2004. Where can I locate the updates for my desktop so that I can get it up and running again?
I made the huge mistake of deciding to wipe ME and re-load an operating system (XP) onto a Compaq destktop PC (800mhz).To cut a long story short, with the re-formatted hard drive installed (NTFS), upon trying to get the PC to boot from the CD ROM to install XP it will not go any further than telling me that it cannot detect an operating system. It doesn't want to let the bootable CD ROM take over, although you can hear the CD ROM spinning, as if trying initiate a boot-up. I have tried everything - trying different CD ROMs, different ribbon cables, unplugging other hardware etc etc, but it always stops at the aforementioned message. When I go into the BIOS to see if I can alter the settings to force the PC to only boot up from the CD ROM (and try other things), the command (F10) to make changes, or to save the changes and exit will not work. It is as if the feature has been locked to stop anyone altering the BIOS settings. I haven't come across this before.
I have a Compaq Presario 5301 Desktop with Windows 2000 OS. When I installed the Belkin FSD6001 PCI Desktop Adapter onto the motherboard and reboot the pc, Windows prompted with a Found New Hardware Wizard window. It couldn't find the driver for the Ethernet Controller. It's an AMD K6 3D Processor. I tried going to HP/Compaq's site to find any available drivers to download, but couldn't find any
I've had this Compaq since 2004. I've added a gig of RAM, a 250gb SATA HDD, and a 6600GT card.
Anyway, I want to do a clean install of XP, which I've never done. I've cleared a bunch of space on my 250gb HD and transfered all the files im going to keep from C: to the 250gb.
So my question is what will happen to my 250gb drive? Do I have to disconnect it? Will XP recognize it after the clean install? What about the extra RAM and 6600gt?
I've been trying to install Windows XP on a HP Compaq 6710b. It's my friends laptop, it shipped with Vista and she hates it so I'm giving her one of my copies of XP to use, because I'm so nice and whatnot. It boots into Windows Setup, checks everything, and then tells me that it can't find a hard drive for it to install Windows on, and the only option is to press F3 to restart. Is there some step I'm missing to turn on the hard drive before I install? Is this a problem with HP products, or have I just forgot to press some button?
I have installed XP 2009 SP3 on my laptop compaq HP presario V3700,I downloaded all drivers and installed them,but I still cannot connect to the ineternet via the wireless as usual, also the sound touch pad does not work,
I've had this Compaq since 2004. I've added a gig of RAM, a 250gb SATA HDD, and a 6600GT card.Anyway, I want to do a clean install of XP, which I've never done. I've cleared a bunch of space on my 250gb HD and transfered all the files im going to keep from C: to the 250gb.So my question is what will happen to my 250gb drive? Do I have to disconnect it? Will XP recognize it after the clean install? What about the extra RAM and 6600gt?
I have a Compaq Proliant 8000 here that had Red Hat Linux pre-installed and in working order. My company then decided that it wanted Small Business Server 2003 installing, so after using Compaq Smartstart to format and re arrange the disk arrays, which is no problem at all system formatted then a raid 5 disk array set-up which smart start detects and reads correctly However, now that is done the system will NOT install SBS 2003 or any other operating system at all, at the point of the install where the disk reads "Windows Set-up" the system just stops and freezes, this happens with other disks and different O/S discs.
I have a compaq presario x1000 that is virus infected. it loads windows very slow and the dvd cum cd rom does not work. how can i reformat my laptop? is it possible to boot it using a usb pen drive since my dvd cum cd rom does not work?
I'm running Windows XP SP3 with everything up to date as far as I know. I have the complete set of my PC's OEM Disks that I've used once when my OS was completely messed up, had Geeks Rescue out and they couldn't figure out what was wrong, so I know what they are for.What I'm not understanding are the several tools I'm afraid to open listed in my "Start"/"All Programs" I have both "Compaq"/"Compaq Presario PC Tools" with "Compaq Application Recovery"/"Compaq Recovery CD-DVD Creator"/"Compaq Recovery Tools CD"/"Compaq Support Information"/"Compaq System Recovery"/"Remote Assistance"/"Safety and Comfort Guide"
The problem is that when i put the hard drive in my laptop, windows xp setup doesn't recognize it (I know it needs the SATA support drivers) and i don't want to slipstream the drivers and burn another disc. So I put that same hard drive (from my laptop) in my desktop and xp setup did recognize it. But I wanted to be sure before I went ahead and started the installation.So is it ok that I use my desktop to install xp on my laptop hard drive and put it back into my laptop? Keep in mind i'm trying to install windows xp tablet edition which is different from other xp installations.
I have just upgraded to XP and am already very irritated by the little balloon messages that just pop up. For instance, there's one that pops up every time I start up, that says I have updates waiting to be installed. I checked, and the updates were about French grammer or some such, but every time I start up, there's that balloon again. Then today there was a balloon asking me if I wanted it to remove some of my desktop icons. How do I turn these things off, so they quit popping up?
When you purchase Windows XP (Pro) as a consumer, is it correct that you may install that software on one desktop and one mobile computer within the household? I remember reading this somewhere. Either that or I'm smoking crack.
I hope I have the right Forum Need some expert adv pls.Found a old COMPAQ 1750/6400/T/10000/D/M/1 of my buddy which had a WIN 98 on it. A badly corrupted OS, it just would not start at all.So to get some experience I decided to install WIN XP PRO, it was done successfully. Unfort there was no way I could make a back up of the drivers, but thats OK, its fun to play around with it.Now maybe some1 can adv how should I go ahead to get the WIN XP going now ? Do not have any BIOS either on my system(as far as I can see)!!
Compaq Presario 5000. Hard Drive failed, replaced hard drive and now Win XP Quick Restore Cd's that came with this PC won't load on new Hard Drive. Instead, I just get a red screen with ERROR and says to contact Compaq for support. I'm assuming something is "missing" that allows the Quick Restore to be "ok" with loading. I've formatted the Hard Drive.
i need to buy a compaq quickrestore cd. ive been looking online and they seem pretty hard to find. i found one website that might work but im not sure(restoredisks.com). also, i found somewhere that there was some type of settlement with compaq and that i might be able to get a quick restore cd for free through https://www.orderz.com/qrcons/page1.asp i have my serial number on the side of my computer so everything would be legit. if worst comes to worst i might just call up compaq tech support and try and buy one from them but im not sure how much that would cost.
Hi, my mates pc has died and I have been trying to install XP Home onto a new hard drive for him. I have got a legit copy of XP of my own which I have installed on his H/D with all the latest updates and which is running fine on my backup PC, and will boot in my main PC. When I try to boot up on my mates PC all I get is the Safe Mode , Last Good Configuration etc. screen and no matter which option I choose it keeps coming back to this screen.
THis dang laptop is frustrating the heck out of me!!!!! I have a couple issues going. Sometimes when I boot up, it goes to the desktop then randomly either reboots on its own or freezes to the point that I have to use th power to shut down as Ctrl-Alt-Del does NOTHING!
Here lately another issue has been more frequent in that I can't boot up at all! I was able to get on the HP site today (once) and it suggested reseting the RAM so did that...no luck...the battery works when it's charged, so eliminated that. I have 2 AC adapters that are fairly new so shouldn't be that I think. What it's doing now is when I power on, the power LED doesn't come on. THe hard drive is solid green, then the battery is solid yellow, then the green goes out, then the yellow goes out and nothing. Through this whole process, the screen is black.
i have a compaq presario sr1620nx with windows xp. one day the computer worked fine and the next it does not. the problem: on start up the computer does not progress past the "Compaq" screen. there are no lights on the keyboard so pressing F8 or F10 or ESC does not do anything. Everything is hooked up properly so it is not a power problem.
a few months new Compaq Presario SR 1500NX AMD Sempron freezes after a few minutes of use. maybe like 10-15 mins max, then just freezes and nothing works.i dont think its ram cuz i tried another ram stick thats 512 mb and its the same thing! i dont get it, how do i find out what the problem is?
Compaq will not start. It gets to the welcome screen, where you press F1 for Setup F10 for System recovery, but nothing else is happening. I have tried to get into both Set up and recovery with no results. I have also tried safe mode, but nothing happens.
I have a Compaq Presario 5000 with 192M of RAM, 866MHz, and 40G HD. It had Windows Me loaded on it, and I tried installing W2K, but it didn't work. Here is the error message that I get: couldn't open drive multi(0) disk(0) rdisk(0) partition(1) NTLDR: couldn't open drive multi(0) disk(0) rdisk(0) partition(1) As some of you suggested in other potings, I made sure that the boot from CD was the first option in BIOS. I tried installing Windows 98. NT4, 2000, and XP using bootable CDs and startup disks but didn't get anywhere. I booted in DOS and formatted the HD and used different partitions sizes and formatted them in FAT and NTFS, and I still got the same result. The cable is connected properly to the HD and there are no apparent damage/problem with anything inside. Linux works like a champ on it, but windows doesn't.
I have a Compaq Presario 3045US that freezes on occasion for no apparent reason. Mouse, keyboard will not function, unable to shut down, have to pull power and reboot. Don't get any error message and no repeatable process although watching dvds does seem to cause it to happen more often.
