I recently went through a "Blond Moment". I decided I was going to update my SIS IDE Driver on my computer. I downloaded the newest drivers from my motherboard manufacturer, saved them to file in the C: drive Now, here is the blond moment:
I uninstalled the old sis IDE driver (rather than changing it to standard IDE driver) and it prompted me to reboot on completion.(Blond again) I clicked yes, I meant to install the new driver before doing this, but I didn't read it right so the computer rebooted.Now on boot up I get a BSOD. It basically asks me to check my hard drive (which I know is good, its new) or reinstall the IDE drivers (which I don't know how to do outside windows) or run a virus scan (done) to be sure that isn't causing the error.I went into recovery console with hopes to restore the SIS or standard IDE Driver, but Im lost, and don't know how to do that exactly. Is there anyone who knows how to install these drivers (remember I cant boot to windows safe or otherwise)OR Should I just do a repair install and will that even fix this dumb thing Ive done?
I purchased a SIIG PCI firmware adapter. It has no drivers and says that it will use Win XP drivers. Well I installed the board and booted the pc, Win XP recognized the hardware but could not find any drivers. I tried unplugging it manually, installing it in another card slot with no luck. I took it back to my pc dealer and he plugged it in his system and had no problems. I decide to try another brand, an IO Gear GIC1394.
HI, I just installed windows 2000 professional onto my computer. Everything works fine except that the resolution is really grainy. On some web sites I cannot even make out what the words are. I found out that when I go into my monitor settings in display properties I am unable to install the drivers for my monitor. Does anybody know a way in which I can get around this.
Alrighty everyone, I believe there have been a few posts about this in other forums ect.. But I would like to here this from the experts here, and personal experiences. I have a Giga-byte K8NXP-SLI motherboard (yeah I know, I realize my mistake now...), and this board has an Nforce 4 SLI chipset. I do use the SATA-II/SATA-3G connection on the board, I run two 300GB Maxtor Diamondmax 10 SATA drives. I have installed the Nforce 4 SATA-Floppy F6 drivers on the XP install and now have not nearly as many issues as before with this chipset
I just purchased a used Dell Dimension 4700, it came without the OS installed or the resource cd with all the drivers. I installed the OS this afternoon, but in the device manager serveral yellow ? came up. The flags are listed for the ethernet controller, multimedia audio controller, PCI modem, SM Bus controller, unknown device, and the video controller (vga compatible).
I have windows xp home and sometimes windows will just randomly forget drives that I have installed and I have to install them again. This dose not happen on my other pc why and how can I stop it on this pc?
I've got an Intel DG33FB motherboard, Intel E8400 CPU and SATA hard drive and I dual-boot with gentoo linux.
So basically, the last time I installed XP, I had to slipstream the AHCI drivers as well as SP2 into an image of an XP CD, then burn it and install from that disc. When I did it last time I had a handy little utility that would automatically make the required changes to the .iso and put all the files in the right spots, etc.
I'm gonna reformat my winxp in my 160GB hard drive and it's my first time to do it. Should I install these drivers?My mobo is MSI G31M3 and i downloaded these drivers from MSI website.I know I need these drivers Realtek High Definition Audio Driver Realtek PCI-E Ethernet Drivers Not sure about these.Intel INF Drivers for 3/4/5 Chipsets Intel Matrix Storage Manager Driver Intel 945G Series VGA Drivers Intel ICH7R/ICH8R SATA RAID Driver (For floppy driver) (I dont have a floppy drive so I probably don't need this) Intel IAA RAID Edition for ICH7R
I recently was forced to reformat my boot drive (I use Windows Xp Home Edition). I have a second hard drive, which I had mirrored my OS. The drive is my new boot drive, but I have noticed I can not install drivers anymore, despite the fact my user profile shows as having admin rights.
Can not install any new hardware with the drivers that come! I have never seen this and do not know which way to go. I have updated XP Home to XP Pro. I have gone through doing and HP restore (Since it is and HP box) And when you even point the hardware install to the driver that came with the (SCSI card, Net Card) it will tell you there is nothing there for this hardware.
I'm running on Windows XP and I'm unable to install my mobo drivers. It's an Asus A8N-E. When I try to install them directly from the CD, it shows the installation completing, and then a window pops up displaying only "1155:". I tried downloading the latest drivers from both the nVidia website and the Asus website, and neither work. When they are installed, Windows will attempt to load, and then blue screen and restart.
ok i am trying to install drivers for my scanner. tech support from the scanner manufacturer said i need to delete the twain*.dll and twunk*.dll files. i try deleteing them and the return without me doing anything. is there a way to permently delete them so i can install the new ones? if need more info i will supply. if this is a security issue instead of xp i will post there but thought i would try here first.
I got a new SATA 320 GB hard drive today, since my other one died. I setup the drivers for it with help of the Windows XP disc, and start to install Windows.
I get to the part where I enter the product key, and I get a prompt that it is invalid. I have entered the key at least 40 times to make sure I haven't mistyped it. I have looked at the Windows Support page and search around
My granddads computer was infected up the kaboose with trojans, viruses and stuff from not having SP 1 or 2 on it.I've put on Avast Anti-Virus, Zone Alarm, Ad-Aware, Hijack This, SP2, ran all the updates and everything else I could think of to clean down the system and it seemed to do the trick.Then I noticed the GFX card (Nvidia 5700) and Sound card (Soundblaster Live) werent installed correctly so I downloaded the latest drivers for each.When I install the GFX drivers the card works but when I restart the machine its like the drivers were never installed. I go into computer management the device list says "This device cannot start".
i am new to this forum, but i have looked everywhere and i have a problem i can't seem to find the answear to. I reformated my harddrive, it is a seagate baracuda 160gb drive. I have it hooked up by raid i think. Anyways when i boot my computer it sees that i have a harddrive, but when i go to load windows it doesnt find it. I heard i need to install drivers for it, but i dont know which ones and where to get them from.
I want to update my video card drivers because my video card is acting up and I want to see if new drivers will fix it.I printed out the instructions from ATI's site and followed it exactly. I used Add/Remove Programs and clicked on the ATI Software Uninstall Utility. I rebooted the computer. I went into Safe Mode. I tried to install the drivers.Upon doing this, every time I run the setup to install the new drivers, I get this error message:"INF Error: Video Driver Not Found" This happens if I try to install the latest Catalyst version. This happens if I try to install an older Catalyst version.This even happens if I try to reinstall the drivers that I just had (it installed fine before so why is the 5.11s giving me that error now)!
I began to install latest drivers wireless net, AGP Card (then reboot). I installed the latest ones for my nForce2 board and restarted. Only for XP to hang during startup. Numerous cold-restarts, still hanging So I tried each Safe Mode, Last Known Good Config etc, to no avail. During safe mode it would display the driver files it was loading, the last two (from memory) were nv_agp.sys(nvidia?) then mup.sys when it hanged. So I then tried repairing/reinstalling XP numerous times, and each time it would run fine till mb drivers were installed, with and without SP2. Same problem.
A dell computer about a year and a half ago and its time for a format. I have the install disk for the XP OS, and the sound card and all that, but there is no video card installation disc, i dont believe it came with one. I am just wondering if i reformat my computer (Dell) will it automatically install the video drivers
ethernet controller i dont know how to upgrade/install the right drivers, i know thatr my motherboard is the ASUS A7V8X ... but i'm having problems finding the right drivers
My friend earlier today installed Windows XP Home full install (an OEM version we found out later), now he cannot connect to the internet. His ISP provider said he needs "network drivers"...my question...where does one get these "network drivers"?
I was trying to install the latest ATI Drivers when the Installer gave me an RPC Server Unavailable error. Both RPC Services ARE running. I dont know what else I can do.
I want to replace Vista with XP however my laptop has a SATA HD. I know that I can create a boot disk on either a floppy or a CD however I think it should be possible for me to install the drivers on an external USB HD? Before I format my drive I just wanted to confirm that this is possible?
A friend of mine has a Dim.4500.He has used it for 4 or 5 years with no problems,except he says for the past 7 or 8 months its slightly slower downloading, surfing,ect...He is going to wipe it clean and he is wondering if he has to install chipset drivers before the driver for getting on the internet?
Windows XP, that is. Well, if I am not completely mistaken, hard drives do not need any drivers to work. Right? I mean, I bought a new HDD (Samsung HD753LJ) and I can see it, use it and all... But Windows STILL asks me to install it (you know, the "new device found"-thing) every time I restart my PC. I've told it to "don't ask to install this device again"
I'm planning a reformat and clean install of XP Pro in the next few days. (Intel dual core with 4 GB RAM.)The OS has been living on C drive which is a Raid 0 setup consisting of two 250 drives operating as one 500.I also have a third drive (500GB) running as D drive (I do a lot of digital photography The Plan: To replace one of the 250's with a 500 so I'll have one 250 and two 500's.
Hey guys, I've had an empty Device Manager for a long time and I'm only now trying to find out how to fix it.I didn't really worry about it before because everything was working fine, even though it was empty. But recently when I've been trying to install drivers for my video card, and my new game controller there have been issues. For example the driver installation for my radeon 9600 card refuses to start up. And the driver installer for my gamepad fails to recognize that it's even plugged in (even though games recognize the controller just fine).I'm guessing these driver problems are related to the empty device manager? The installer won't install the drivers because it doesn't think the devices are even installed or plugged in the computer.
On my Acer TravelMate 2480, I reformatted it and reinstalled Windows XP. There is not wireless icon. I went to the Acer webpage and downloaded the drivers I guessed I might need. When I try to update drivers on the Acer, and choose my flash drive stick, the computer doesn't see any drivers on the flash drive. I will probably end up having to pay to have the whole thing redone the right way
when i first installed windows and what not i had a floppy drive installed.i need to do a windows repair and to do so i need to install these external sata drivers for my hard drives.i do not have access to a floppy drive and i would like to know if there was anyway to get around using the floppy drive to install these drivers one question i had was would i be able to change the drive letter of one of my dvd drives to A so that windows will install from there instead of an obsolete floppy drive A.
I'm not having any problems with the audio itself,but I just reinstalled XP and before when I would press the volume up/down buttons at the top of the laptop a green bar/scale thing would come up on screen to show me how high/low my volume was. After reinstalling the audio drivers from IBMs website it does not do this anymore
its a FX7026. I had to replace the motherboard and am trying to install XP on it, but after loading all the install drivers it blue screens. I have installed a trial vista on it to make sure it isn't just a problem with the computer and it installs fine, but when I try XP it keeps popping a blue screen.
