I bought a USB A4 Tech HU-200 HeadPhone Its volume is quite high even when the windows volume is at 0, When its at max 100 it works like dedicated speakers Is there any way to reduce the volume beyond the lowest volume of windows 7?
Note: My Headphone does not have any soft of driver or software
My headphone volume is too low even at max volume settings.. using windows 7 64bit ultimate. Headphone : HS 320 (Creative).. tried with other 1-2 headphones.. all of them .. volume is too low!
Realtek sound driver : 6.6.1.6662
Intel : DH55TC
No problems with speaker volumes.. its loud and clear (5.1 creative t6160)
I was just messing with my speakers and I realised, when playing a CD through them, they're louder than when I'm playing music through iTunes.So I decided to open the exact same MP3 with VLC.VLC almost doubles the volume of iTunes.Even when I tried putting the Preamp up to max (I know it's not good for quality but meh) it still couldn't match VLCs volume (Which was at 100%, same as iTunes).I checked sound check was off in the iTunes preferences, I checked the Windows Sound Mixer volume was full for all programs, I made sure Skype was closed (sometimes it turns down my iTunes volume).
View 5 Replies View RelatedWhat is the optimal set-up?
High volume on speakers and low in windows, or low on speakers and highest in windows?
so i have a blue yeti, and i'm an online animator/voice actor. whenever i record audio on my blue yeti (or any other mic) i record about 4-6 inches from the mic, and turn the gain down enough that the audio doesn't peak as i yell or whatever. this is what you're supposed to do if you don't want your audio levels peaking and making your recording sound horrible and corrupted. however, afterwards, it means i have really quite recordings. not a problem right? now that it's recorded right, i can boost the volume of the entire clip afterwards right? wrong. i'm not an audio expert so i must be missing something. but why in gods name would the audio distort and peak after it's recorded successfully? it's all there, it's all clean audio. if i turn the volume on my speakers all the way up it sounds crystal clear! all i want to do is do that inside the computer so that when i upload it to Internet people don't have to turn their speakers so far up. but if i increase the clips volume in the computer, it distorts! it sounds awful! why?! i tried in sony acid and audacity and they both do the same thing! i can take sound effects, and recordings made by other producers and crank them up nice and loud, but mine just fall apart!
View 2 Replies View RelatedI just received a new keyboard today: Thermaltake Challenger Ultimate. I went from a Logitech G15.
First thing I did was connect the keyboard and install the software that came along on the CD, it probably also installed the correct drivers. First after this did I uninstall the software and drivers from the old Logitech G15. But before that, and now after, the volume buttons on my new keyboard is still not adjusting the volume when I press them.
A speaker-icon like this shows up when I press the volume buttons, so its not that the keys are not working: (ignore the text behind it, its me writing an assignment)
I recently got this problem, that my volume hotkeys stopped working, (Acer Aspire 5560G) AMD High Definition Audio. I also tryed plug in other keyboard that have's volume hotkeys but still doesn't work.
View 2 Replies View RelatedI like to listen to music loudly sometimes. I have both the volume mixer and my application's volume set to maximum levels, but it's not loud enough for my liking. Is there any way to increase the maximum sound volume in Windows 7?
View 9 Replies View Related[email]amtemirak@hotmail.comSpoiler :[spoiler]
View 1 Replies View RelatedI just installed a new mobo with my windows 7, and the sound mic volume is so low. with everything turned up i need to scream to even kind of hear myself on playback. I read this was an issue with windows 7 so what is the fix? Mobo is ASrock 970 Extreme 3 and Windows 7 Home Premium 64bit.
View 8 Replies View Relatedmy computer recently has started to reset the volume to 100% and keep it at that level, it is unable to be reduced to a better level.a week ago, I installed X-Lite 4, on my computer so i was able to start setting up my voip phone.this problem started about 4 days ago and i was able at first been able to get around it by restarting my computer but then some time later time varies, it would just reset volume to full level.with this doing this it has displayed on my screen bottom middle screen, a picture fo a speaker and showing volume bar at full. this is always ontop of all other windows.the only way I have been able to get rid of this is by stopping the service "audiosrv" through task manager.I have since done a scan with spybot, cleaned my computer with c cleaner, ran my virus scanner etc.
I have also changed property changes in audio settings and nothing has made a difference.I have also uninstalled x-lite, done a system restore to about 2 weeks ago, nothing still made any difference. I am running Windows 7 ultimate 32bit, on a pentium dual core at the moment I am thinking that maybe my audiosrv.dll file or something assoicated with it may be currupt or been infected and not being picked up so far.I have to be able to fix this issue with doing a fix. without a reinstall of the OS / software.
I was given a laptop at work. It came with win 7 home. The workplace has access to a win 7 pro dvd for which apparently no key needs to be entered.
1. Can I upgrade using win 7 anytime upgrade using the in 7 pro dvd from work? Or does it require a reinstallation?
2. If it is a reinstall, is there some way use the drivers already on the laptop to make things easier? There is a recovery partition on the laptop ~16GB, there is also a drivers partition.
3. If I can do an upgrade, can I change the language? The current language on the laptop is european; the language on the win 7 pro dvd is english.
a friend supposedly cleaned my computer but in the cleanup removed all my microsoft office program, have none, but included went my volume, i can only hear with earphone which is very annoying.
View 1 Replies View RelatedIs there some shortkey for controlling the volume and the screen brightness (if it's not a laptop and such keys are not available on the keyboard)? Also, what would be the Windows equivalent to 'All Windows', 'Dashboard', 'Application Widows' and 'Show Desktop'? Sometimes I like to put multiple windows of a browser in different spaces so I can better navigate around them; how can you do this on Windows 7?
View 9 Replies View Relatedmy pc operating system is installed in c drive which is 25 gb in size, and d drive is 50 gb.is it possible to shrink 5 gb space of d drive and add it to c drive?
View 6 Replies View RelatedSetup mb asus p6t6 ich10r (raid controller) 2 x vertex 30GB 2 x seagate 1.5TB in ( motherboards controller fakeraid ) raid 0 array Volume1 = 1 GPT partition with 1 windows dynamic simple volume ntfs formated (just 1 big ~3TB partition for storage created on a previous install of Windows 7)
Reinstall Window 7 on a vertex
Problem: After reinstall the raid array is not recognized by Windows 7 it asks me to initialize the disk (which is a raid volume). I say yes, then asks to create MBR or GPT i say GPT. But then it says the disk is unallocated and wants me to create a new dynamic volume, i say simple volume. But now is asking to format... and here i stopped, with out formating to new ntfs.
Questions: Is there a way to recuperate / restore / reinstate / recover / rescue / rebuild .... the old dynamic ntfs simple volume ? So that i could access the data without having to use a data recuperation program for 3TB of data.
Will a quick ntfs format and a scan-disk make that possible?
i have a single hard drive with 2 partitions. 1st partition with Windows 7 OS and the second strictly for data. yesterday i decided to try software raid using windows disk management. firstly, i added another identical but empty hard drive into the computer. boot it up and went into disk management. i right-clicked on the 2nd partition (data partition) on the original hard drive, and selected add mirror. after a few seconds, the disk management tell me an error "failed redundancy" on both my old 2nd partition and the hard drive i just added. so without thinking much, i decided to delete volume on the new hard drive (bad move!), and guess what, it deleted the new hard drive volume together with the original hard drive's 2nd partition (contains data!). now it is showing as unallocated space and i have not format nor create a new volume over it.(i think the data is still intact)
is there anyway to recover the volume?
*i know there is a fix within windows using dmdiag but that is for non-mirror volume(dynamic disk) only. also tried with easeus partition master but still unable to recover the partition as it is a dynamic disk.
*minitool partition recovery doesnt work either for dynamic disk..any other recommendation?
The volume on my hp 5260f Windows 7 starting cutting in and out. Ive used it with no problem for over ayear. Tried a system restore and all the fix it tools. Today it has no sound at all and the device manager says everything ok. Is it time for a new sound card?
View 5 Replies View Relatedhow to find windows key 7 installed on computer is is Volume version or other
View 3 Replies View RelatedI would like to know how to change the volume level from 50 to 100 in Windows Media Center on Windows 7 Ultimate x64. I have tried to look for the Windows Media Center folder by showing hidden folder and also hidden windows sytem files as well, but no success. Please help me. My complaint is that I want the volume for Media Center to be at 100 because when I use it I can only get 50.
View 14 Replies View Relatedi have purchase laptop in which all ready sound blaster &creative console volume launcher are installed but volume launcher i have uninstalled by mistake can i installed again. my system detail dell studio 1558.service tag 7d776bs.
View 1 Replies View RelatedI've been searching the web for some answer to this. I have an dell optiplex usff 755 with an intel core 2 duo processor that is having an audio issue with windows 7. Anytime I am watching a movie when the audio gets to a low level in the movie it drops out completely and goes to complete silence. It's really annoying because you lose the background ambience of the movie. Occassionally soft music will be playing in the background or birds chirping and then the sound goes to complete silence until someone starts to talk or a loud noise is made. This is not an issue with a certain movie file, it will happen with any movie. Even stuff I have recorded from TV using windows media center. I also don't think it is the player (I use media center a lot) because I have played the files in other players such as windows media player and KM player and the same thing happens.
View 5 Replies View RelatedHow can I reinstall volume control on windows7 after the volume icon has been deleted?
View 3 Replies View RelatedI just installed a fresh new copy of Windows 7 Professional 64 bit to my newly bought free dos computer yesterday. Later I installed my motherboard drivers, monitor drivers and optical disk drivers. I also installed CC cleaner.
Now I am trying to partition my 500GB Hardisk. The C: drive is around 465GB so I want to reduce C: to 150GB (OS+Programs/Software) and make another D: drive which will have the rest 315GB (Personal files + games).
The problem now is there is a limit in the shrink volume amount. And this limit i quite big. It only lets me reduce the C: drive to 243GB. Here is the Screenshot:
I tried disabling Shadows Copy, Paging File, Hibernation and System Restore but its still the same. I also tried defragging using the default windows defragger but nothing worked.
When I go to the normal shrink partition in my Windows 7, it won't allow me to do it. What do I need to do to get my pc to allow me to shrink the C; in order to allow large Drive partition/
View 4 Replies View RelatedMy system shows low disk space. So i want to increase my C partion without format. My system did not showing me extended volume of that c: then what can i do?
View 2 Replies View RelatedI just bought the Laptop with Windows Vista Business, but I upgraded to Windows 7 ultimate.Then I partitioned the 250G hard drive to install another OS on the new Partition. I used System Management to shrink 80G from the 222G available, but I have not installed anything on the new partition before the Windows 7 had problem, so I had to use HP system recovery to restore the PC back to factory default. After restoring, I installed windows 7 again and it worked properly. I later wanted to shrink 80G again as I did before, but I couldn't. Though the Hard Disk properties showed that the Disk is 222G, I could not shrink more than 9G, despite having more than 100G free space.It seems as if the system did cot recover the Hard drive to its original state. Please someone help me out. I need to partition/shrink up to 80G from the 115G remaining, but the system is giving me only 9G plus available to shrink/partition.
View 4 Replies View RelatedI have a PC that has windows 7 ultimate installed by a friend with a disk that legally allows multiple installations.Unfortunately my operating system isnt working well. it wont install a service pack or printers etc and I would like to do a fresh install from scratch. My friend tells me if I use his disk it will use up another of his product keys . however I am wondering is there any way I can re-install it with the existing product key so as not to use up another windows installation from his batch of licence keys
View 1 Replies View RelatedI have a new laptop I've owned since Fall. Its specs are provide below. A while ago its volume adjustment buttons (fn + volume up or down) stopped working. I've been using the desktop toolbar to adjust the sound which is of course very inconvenient. Now in the last week, the volume icon will not show up in the toolbar and I have to reboot often to get it to show, even though the icon and notification are both enabled.I have run malware bytes and super anti-spyware and the latter removed some malware. [code]
View 4 Replies View RelatedThe other day I bought a new HDD, and decided to do a clean install of Windows 7 for it. After getting it all installed and installing all the drivers and Windows updates, I decided to watch a movie. I then realized that the audio volume was (as a ballpark guess) 20-30% quieter than I was used to. I rebooted and loaded up the old Windows install, since I still have it, and started up the movie and the volume was back to the level that I was used to.Reinstalled drivers; From motherboard website, from Realtek website, and even went over and backed up the drivers on my old install to reinstall on the new drive.Checked all audio panel settings, made sure everything was turned up and set the same as my old install. Made sure it wasn't an issue with the media player program I was using; Reinstalled it and made sure the settings were the same as my old install. [code]
View 2 Replies View RelatedI have windows 7. I've read that this system does not have a loud a very loud audio system. How do I increase my volume when I download a movie?
View 1 Replies View Related