My Dell was running perfectly. I turned it off for a couple of months. When I turned it back on nothing at all happens. A friend said it could be the power supply. I looked inside and found a lot of dust. Don't know what the internal power supply looks like.
View 1 Replies
I have a Dell Dimension 2400 1.6ghz 1gb RAM with XP Pro on it for several years now. It has many programs installed on it. I purchased a faster used Dell Dimension 8400 3.6ghz hyperthreading 3gb RAM with XP Pro on it.My question is simple. My Dimension 2400 has an IDE hard drive and the 8400 has SATA. Rather than spend days re-installing and tweaking all of the programs on the 8400 I tried the following. I used Acronis Easy Migrate 7 to Image the IDE hard drive to the SATA hard drive and installed it into the 8400. It would not boot, I tried a repair install, then while booting I get a blue screen stop Error 0x0000007B. What do I have to do to fix this so it will boot?
View 11 Replies View RelatedSometimes this computer will start, sometimes it wont When it doesnt, the On button just flashes orange, when it should be solid green. Sometimes it will start up and get to the log on screen and then just shut down and flash orange. It works fine when it does turn on. Iv been through the dell help and support stuff and that doesnt help
View 3 Replies View RelatedWhen I fire up my dell the fan turns on full blast and there is a series of 6 beeps. Not sure what to do.
View 2 Replies View RelatedI get a blue screen when I boot up my Dell Dimension 8400 (XP Home Edition). The message indicates that it is a registry error. I have not added any new hardware or software or any drivers recently. I can not start in safe mode. I have run windows XP home edition setup from the Dell XP installation disc. when I select either enter to setup windows XP or R to repair using the Recovery Console, I do not ger very far before I again get the blue screen message.
View 7 Replies View RelatedStarting a few days ago my Desktop would freeze at the Dell boot up screen.. Id have to turn it off then back on to get anywhere.. The 1st time this happen I turned it off an back on twice an got through.. I didnt think much of it.. Today I was working on the computer and everything just froze At that very moment the last thing i did was change the screen saver to none.. then it all froze.. This time when booting up it jus kept freezing i didnt think i was going to be able to get through but on pwoer up i heard a beep an got an error saying it was having trouble booting up at checkpoint[Ithr]
View 1 Replies View RelatedWhen i start up my dell 8400 it goes straight to the black screen stating windows did not shut down properly and asks to start in normal safe mode so on... no matter which option i choose it goes straight to the blue screen stating the physical dump of memory how can i fix this problem
View 1 Replies View RelatedI have a Dell Dimension 8400 running windows xp home. 2.99GHZ processor and 58 GB free space left. My problem: My computer automatically goes into hibernation mode and will not start up again for at least 5-10 minutes after. It gives no warning whatsoever when this happens. I'm risking it happening right now. I have the computer set to stay on at all times. All power options are set to "never" turn off.
View 1 Replies View RelatedI have a Dell dimension 8400 running XP. Error on startup reads:checking file system on C:The type of the file system is NTFS The volume is dirt CHKDSK goes through all 3 stages and completes them. The last thing it says is 'Usn Journal verification completed'.But nothing else will respond. I have pulled the plug and started in safe mode, same thing happens or it will run a bunch of dos commands and stop with no result.I have read lots of other threads but I can't find the same exact problem. I can't get to a dos prompt (i think) to type in some of the commands I read about.
View 14 Replies View RelatedHad a major crash and now can not install windows on the Dell pc as it can not see the hard drives anymore.
Installed a brand new hard drive and still no luck just says can not locate a hard drive to install windows on, done a check in the bios on the hard drive and it says it's fine but can not see it on the fresh install.
I would like to upgrade my Dell 8400's graphic card.I am not a gamer.I just purchased a 21" HP widescreen monitor that is capable of 1920x1080 to replace the original (4:3 aspect ratio)Dell monitor that came with the computer.I just want a good quality,name-brand card that will provide the 1920x1080 resolution for the new monitor. The card that came with the computer is not capable of that resolution. My operating system is Windows XP.
View 10 Replies View RelatedMy hard drive's windows files have become corrupt and I need the files on it, so I purchased a new hard drive. I can't seem to install Windows XP Home onto the new hard drive. Everything goes fine, but then I get an error message saying it can't install the product catalogs. Is this because I'm using a reinstall CD that was provided by Dell.
View 14 Replies View RelatedI got a used Dell Demension 8400, XP Home installed (OEM). I own a copy of XP Home which is not installed on any other machine, I tried updating drilling down through using regedit...it does take the product key. What might I be doing wrong? Thanks.
View 4 Replies View RelatedHAVE DELL 8400 COMES UP FILES UNREADABLE -COULD IT BE SATA HARD DRIVE
View 1 Replies View RelatedDell 8400 desktop..On bootup, the Dell logo screen appears and goes to a 'dos-like' screen advising: Floppy diskette seek failure, strike F1 key to continue or F2 to run Setup Utility'.I get no response from F1 other than a beep. F2 brings me to the setup menu, but can I get to safe mode just in case my 5.5 yr old computer is about dead? Dell just replaced the motherboard & power supply in Oct after that quit working after a surge protected power outage. I don't have many personal files on the C drive other than my iTunes & my email
View 4 Replies View RelatedMy dad's Dell 8400 is having a series of issues. He posted a similar thread in the Hardware forum, but it's possible it might be more than hardware, so checking here to see if ya'll might have some suggestions (as I know this forum gets more visibility and he's getting anxious).He turned on the computer last night to have it not booting up at all. It gave a series of 4 beeps followed by 2 beeps, and then wouldn't do anything after that. He tried multiple times, with one or two of them bring him to the BSD asking to boot in safe mode or system restore.
View 3 Replies View RelatedTransferred all information from Dimension (Dell) to Dell XPS 410. Both computers using XP program. When I start to use my Picasa program I have a continual pop up that says " The DLL "cpuinf32.dll" can not be loaded. OS reports: The specifdied module could not be fouind. Am no computeer whiz--so this is all "Greek" to me. What should I do to correct this?
View 2 Replies View RelatedI recently returned to Kliptsch a pair of speakers which were not functioning well. While waiting for the replacements, I am unable to get any sound out of the computer. This includes streaming radio broadcasts as well as TV clips.
View 15 Replies View RelatedI first had this problem when I tried to do the first installation. When it would get to the part of the setup in windows mode, it would just keep rebooting. I was able to finally get it to finish installing, and it seemed to be working fine, untill I tried to make sure all my drivers, applications, and my cable internet conection were installed.
View 37 Replies View RelatedI often but not always get an error message when working online. I am not sure whether it is a dell problem or my internet service provider. I have dial up. A small box pops up in my face and it says . . . windows must now shut down because the RPC service terminated. System shutdown initiated by NT/AUTHORITY then it counts down 60 sec and shuts off my computer. I have no control when it does this, i cannot X it out or make it stop. Very annoying. Sometimes it goes for hours and does not do anything, sometimes it will do it 3 times in 30 min. I have scanned for virus' and it comes up clear.
View 2 Replies View Relatedi'm working on a dell dimension 2400.windows crashed and there are no restore cds.i formated the hardrive and installed win xp professional.in device manager i don't have drivers for the ethernet controller and the usb controller.does anyone know where i can find these?
View 2 Replies View RelatedI've got an old Dell Dimension XPS T450 Pent-450 which had Windows Me but I put 2000 in it. Ran fine untill I tried to add memory. I put the memory back the way it was but now I get a window saying "THE LOGON
USER INTERFACE DLL MSGINA DLL FAILED TO LOAD" What do I do to fix this problem?
This has probably been asked before so feel free to respond with a link.I have a dell Dimension 4600 which i have reinstalled windows xp HE on countless times. It has never mentioned its license or asked for the code on the side.My friend has dell Inspiron 2500 laptop. She has had it for 6-7 years now and has never done a reinstall or reformat, so naturally its on its last legs.
View 6 Replies View RelatedI have really screwed up my computer --dell dimension 2400 ? talk about a mess. I wanted to clean off the hard drive, so I tried to reinstall xp using a friend?s cd because the only xp cd I could find was an upgrade (from win98).I don?t know what I did wrong (or if the problem was with the cd), but setup got into a loop we could not get out of.Since I had my xp cd to upgrade from 98, we tried to install win98. It did clean off the hard drive, but it failed to install completely and now the cd drive will not work. And when I click on IE, an error message ?Msoobe? comes up and says it has perfomed an illegal operation and shuts down.My brother also has a dell dimension 2400, and he thought there was a way to reset the computer to its original configuation. I tried the Control+F11 that he suggested, but the screen says it needs a device file to run that it cannot find. There is a line that reads
Vnetbios.
I am looking to upgrade the memory on my Dell Dimension 2400 to at least 512 mb. I have heard that you have to purchase a specific kind of ram (dell certified?) and that it won't just use any kind of brand. Is this true? If so, can someone point me in the right direction.I know that it must be DDR PC2700/333 but I'm unclear as to which brand to buy.I spoke with Dell and hung up unclear (she spoke very poor english) so really got nowhere.
View 5 Replies View Relatedi did a clean install for a dell desktop 2400 and i'm having trouble finding the drivers i need. I went to dell.com and the ones i have dl havent fixed the problem.
Is there a site that can diagnose and install drivers that are missing for free?
I have a Dell Dimension 8200 desktop running WinXP Home however It won't boot to the hard drive. I replaced the drive with a known working one and it still doesn't boot, says Diskette Drive 0 Not Found, however I figured that was referring to the floppy drive. Tried switching the ide cables around and that didn't work either. The power supply is working, as well as all of the fans. Its running a 1700mh processor. Cd-Rom works fine, and I can boot to a CD, I can browse the files if I boot to Knoppix, however it simply won't boot to the Hard Drive. I ran FixMbR and FixBoot in the recovery console, to no avail. Bios is configured properly, and I haven't touched the jumpers. Just to be sure I tried the hard drive in another system, and it wouldn't boot in that one either. Might be the mother board?
View 14 Replies View RelatedA DELL DIMENSIONS 9150 PC. There are 2 drives on it but the DVD is not working I have tried uninstalling it and rebooting so that it is automatically installed. I have also done the built in selt test by pressing F12 when the dell logo appears.
View 9 Replies View Relatedmy computer Dell Dimension 2350 has been running at 100% cpu usage for a while now and it started occuring after the guy who came and installed the internet left. I ran tons of spyware, adware, and virus programs and came up with nothing, i wiped the computer clean and ran a fresh install but the trouble presisted. when i'm in safe mode none of this happens, the speed is fine In process explorer it says that the DPCs and Interrupts are pretty much hogging all of the system's resources. I did plenty of reading on the internet to find out it was probably a hardware or most likely in my case a driver problem. I got Driver Genius to update all of my drivers and now i see the only one that doesnt even have a driver and is saying there is an error for is my ethernet controller. It tells me that there is no driver installed for it yet it's still working. I'm not sure how i find what brand of controller i need the drivers too
View 1 Replies View RelatedI am trying to access my system setup , So i can boot from my xp cd .I tried to hit F2 but it just keeps taking me to a black screen wanting my pw . I forgot my Pw and after trying to guess my pw to many times it now just shows a black screen wanting a pw ? How can i get pass this ? I have never seen this before .Need a Pw to get to bios setup?I cant boot from my cd unless i get into the bios setup .
View 3 Replies View Relateddimension 8100 primary drive not found. no beep when powered up from mains
View 1 Replies View Related
