I have two hard drives each divided into two partitions.I performed a clean install and repartitioned the C drive into C: and D:"My Computer" shows the C & D partitions correctly but does not show the second drive with it's partitions D: and E:In "Disk Management" of "Computer Management", my secondary drive is shown as Disk 0 and not being partitioned with all the GB combined.
View 14 Replies
I have recently been working on a VB6 Program which was meant to change the registry.After i had tested it, my laptop rebooted suddenly and i got an error saying: The following file is missing or corrupt: WINDOWSSYSTEM32CONFIGSYSTEM This is a real pain because i got my laptop off eBay and after a small child hammered the keyboard, the CD Drive Became Bust. I only have a 3.5Inch floppy drive and 10 floppy disks. It is quite old and it doesn't support USB booting When i try using a MS-DOS startup disk, it doesn't show my C: Drive
View 9 Replies View Relatedmy dvd/cdrw drive just recently disapeared from the "my computer" window, and it does not work any more. It has power going to it. I checked all cables plenty of times. The only time it works is when i put XP cd and restart computer, it reads it. But otherwise it wont read anything when i am on Xp. i dont watn to reformatt agian lol
View 6 Replies View RelatedI am having an issue with my DVD Burner. It used to work fine, I was able to burn DVDs (Using Roxio). I fixed an issue related to AVI files by installing a program called K-Lite Codec Pack. During the installation, I was asked to approve some erroneous registry entries that existed. Since then, I have had issues with the DVD Burner (HL-DT-ST DVDRAM GSA-4081B). The drive doesn't show up in as a valid letter on my list of drives. When I go to the device manager, it has a yellow ! next to it (Code 37)....
What I have tried so far:Un-uinstalled and re-installed the device driver Followed instructions on Microsoft.com to Manual steps to delete the UpperFilters and LowerFilters registry values that can cause CD access problems (http://support.microsoft.com/default...en-us%3B314060) At that point, I could see the drive and the exclamation mark in the device manager was gone, however, I could not burn any DVDs... it didn't recognize it as a burner....
My problem is that in my computer with windows xp I used to always use the thumbnail view in the windows explorer to know which videos where which and also for images. But then my computer got all screwed up and I had to reformat it and install the windows xp again and downloaded all the new service packs and stuff.But now, I go to either the windows explorer or my computer and for images I can see the thumbnails but for videos it only shows either the windows media or realplayer logo but no thumbnail image of the video. It is driving me crazy because I really need to be able to see the thumbnails in order to identity them fast instead of having to open all of them!
View 1 Replies View RelatedFirst I am new to XP but not new to computers.I got a new-ish thinkpad with two partitions on it's drive. The c: primary one was NTFS, there was another for SERVICE which was FAT32. I promptly proceeded to using PartitionMagic to break up my huge c: partition into 3 partitions (all primary - now I have 4 primary partitions, 4th being the SERVICE fat32 one), the first 3 being NTFS.
View 8 Replies View RelatedI had a problem with my windows. When ever I plug in my Flash drive (i got a few: kingston data traveller 1gig, pendrive 128mb,etc) onto my usb port. Window will be able to detect the drive had been plug in. I can see the "Safely Remove Hardware" icon on the right side of my task bar. But i cannot see the drive appearing in "My Computer". If I double click on the "Safely Remove Hardware" icon and try to view the external drive information, I can see that its already detected and being assign with drive E: . Even if I open a windows explorer and type in E: , it will throw me an error "Cannot find 'file:///E:/'. Make sure the path or Internet address is correct". But if I were to restart my computer, then i can see it for the first time. If I disconnect it (thru the "Safely Remove Hardware") and plug it back in (or plug another flash drive), I cant see the external drive. Causing I had to restart my computer multiple time a day.
View 3 Replies View RelatedMy brother went to My Computer one day and saw that there was no disc drive there, it was working in the past, but now it doesn't show up, I don't think he did anything unusual. But it shows up under Safely Remove Hardware Wizard with "Samsung CD Drive" or something like that.
View 14 Replies View RelatedXP SP2. I have a card reader on my printer that I never use. how can I make that drive not show up in my computer?
View 2 Replies View RelatedI am running XP Pro on my computer. On another drive I have windows 7. My computer stopped booting to my XP drive all of a sudden, but it would let me boot to my Windows 7 drive. That lasted for about 3 days. Now I can't boot to either drive. When I start the computer it says there is no HDD. I tried to use the XP disk to repair, that didn't work., so I thought I'd do an XP install. But my hard drive doesn't show up all the time. Or it will show the HDD but upon trying to pick a partition to set up XP in, it then tell me there is no HDD. I get the blue screen of death, and have to manually force a shut down. Other times it tell me that the HDD is RAW, and it needs to be formatted. How can I get the HDD to format? Is there a way to do it through DOS. Sometimes I can't even get to the DOS prompt. The bootup section is corrupt. I need to repair it, but can't if the system doesn't see my HDD.
View 8 Replies View Relatedthe hard disk partitions shown in the my computer folder usually have a name as well as drive letter associated with them.today as i opened my folder the name of the drives along with the folders cd rom n floppy disk were missing.when i select a drive the information shows up in the left hand pane
View 4 Replies View RelatedMy hard disk and cd-rom drive doesn't show up when I go to My Computer.Doesn't work in Explorer or in Vapor.It's all there and working fine when I go to Device Management.I've got Windows XP Home Edition; service pack 2
View 2 Replies View RelatedMy win XP pro doesn't recognize my USB 400GB WD external HD.The PC detected it the first time however on subsequent connection, it only detect it as mass storage device. Window explorer doesn't show it as external device.I uninstall the USB mass storage driver from device manager several times but window doesn't display the HD in window explorer.
View 3 Replies View RelatedNormally when I turn on my computer, it loads and logs in automatically and doesn't need to show the login screen. But today when I turn it on, it goes to the login screen. So I click my name which is Compaq_Owner, and it logs me in. I see a quick flash of my background of my desktop with no icons, and then it goes back to the login screen and logs me out. It says "Saving Personal Settings" and "Logging Out" . Then I am back at the log in screen. I do not get any errors, just this. I have tried Safe Mode and making a different account I can log into, but it doesn't work. I did a system restore to Monday, 2 days before it started this. I then log in and it does the same thing all over again. I have also restarted and tried to log in, but that doesn't work either.
View 10 Replies View RelatedI am attempting to delete some software off of my computer. None of the 3 that have been downloaded for a long time and show up on the bottom of the screen (Net Defensewall, System Suite 8, and Windows Defender) but yet they don't exist when I try to delete them? What am I missing? I have never seen this happen before.
The computer is not in safe mode, as I checked that already. As a matter of fact, my software box only shows like 5 different softwares when it should show about 12
i'm trying to delete a file in dos that shows up when i do dir but when i try to delete it, it says it can't be found. it is a virus that i'm trying to get rid off. it's in the windows logon shell in winntsystem32 folder.
View 2 Replies View RelatedI am having trouble setting up XP on my Windows 2000 SP4 Computer.I know I installed the components into the computer, but it does'nt show up.I have no experience In boot disks or anything else, so please speak slowly.
View 6 Replies View RelatedI know this is probably a very simple fix but I can't seem to remember it. When I open windows explorer (xp home) to view files and folders it is not showing me all of them. For example, under c:documents and settings it does not show "local settings..." and all the subfolders. And, when I installed Office it created an install cache folder but it doesn't show that either. How do I turn it on to show all? There is no prompt to "show hidden files". its probably something real simple that I am overlooking.
View 2 Replies View RelatedI've noticed that the dot-url part of the file name does not show in Windows Explorer for web link files/shortcuts even though I have Explorer set to show the entire name, including extensions.Why is this exception made in Windows Explorer to only this one extension?
View 5 Replies View RelatedI just tried to do a system restore using the built in windows tool. However, everytime I go to the screen, the area where the little calender that has all your restore points, is gone and blank. I have tried restarting; nothing. I have tried making a new restore point and it doesn't show up. Refer to the screen shot I took to describe what I mean.
View 11 Replies View RelatedOkay, so there are many topics out there from people asking for help because they deleted their show desktop icon.I however never deleted it, it just stop working. After some investigating it was revealed that my C:WINDOWSsystemshow desktop file is gone. The icon is there but the file is gone.
View 14 Replies View Relatedi have a laptop from acer that does not show the desktop items i wanted to no how can i get them back on there without deleting everything.
View 1 Replies View Relatedi installed Windows Vista Ultimate on my C Drive. and then installed Xp SP2 on my D Drive, in that sequence. now when the window boots it doesn't show the booting options and directly boots into XP SP2. i can not boot into Vista now. is there anyway i can make OS choice menu available / boot into Vista.
View 4 Replies View RelatedI have Winodws XP on a Compaq nc6120. I opened my laptop today to get it working and clicked on Google Chrome's shortcut, and nothing happened. The hourglass cursor came up and it stayed that way for about a half hour, then I tried to turn it off and back on the same thing keeps happening. I have also tried other programs. The task manager doesn't show up and the start bar does not even respond. I ran an HDD self-test and it said that all tests were successful. I use Avast Anti-Virus Free, and tried to download Comodo, but something went wrong, this was the day before theses issues started happening. I'm not very intelligent when it comes to 'under-the-hood' problems with computers, so I have no idea what could be happening.
View 2 Replies View RelatedI have the following problem: Explorer doesn`t show any details for any media file type like artist or album, when choosing Details view. Additionally, clicking on file properties doesn`t show any info either, nor simple, nor in advanced view.The files are fine, and other software reads the media file info correctly, including WMP 11 and Winamp.
View 10 Replies View RelatedI obviously have a network connection, because I'm sending and receiving Usenet messages and can browse the Web. The problem is that Network Connections in Control Panel is blank, empty, it doesn't show anything
at all. The other problem is that the Network Setup Wizard won't run.Any ideas on what the problem is (aside from user incompetence).
I cannot find out why the partition drive letters are not showing up in disk management but are showing in "My Computer". I can view directories and file in explorer but links and commands do not work because they can't find the paths.
View 1 Replies View RelatedI recently purchased a USB external hard drive by Western Digital. The drive shows up in the device manager. but no drive letters show up in My Computer or Windows Explorer. I can click on Start,Run,F:, enter, and a window opens up with the drive letter as the header. Any ideas how I can get the drive letter to appear in My Computer of Windows Explorer?
View 2 Replies View RelatedI discovered that my main computer had acquired the 'Pure Networks Platform' mess, possibly from when I installed a Linksys WRT 160n wireless router. The actual software doesn't seem to be on the setup cd, but I haven't downloaded it either. Have figured out that its give me slowdowns and wierdnesses and generally making me mad. Especially when I find that it does not show in Add Remove! Tried searching for Pure Networks remover, and other variations in wording. Find that lots of people have similar difficulties. What is the trick? Safe mode and delete the folders? Search the registry manually?
View 3 Replies View RelatedI'm trying to copy some files from my PC, but it doesn't recognize that I've got a dvd burner, it sees it only as a cd burner, it will play dvds, but wont let me erase or burn.My pc has started getting some bugs recently, and I need to hurry to backup my files, before it takes the big crash.
View 6 Replies View RelatedAt work we have so many network drives and in a recent upgrade to xp, the drive letters are showing up at the very end of the drive description. In certain applications, you only get to see a short portion of the beginning of the drive info and with the complex naming schemes we have, it is difficult to remember what's what and hard to tell the difference with just the beginning showing. It's very easy to remember what we've designated as K or N or P for example. Any way to switch these letters back to the beginning?
View 5 Replies View Related
