My motherboard failed. I can't boot into my existing win7 OS anymore. I will have to install a new board, which usually means, complete new installation and loss of all settings and updates (2 years) Is there any way or tool to transfer my existing OS, with all settings and programs intact into the new hardware environment?
View 6 Replies
I have just replaced my motherboard after the original was fried by a lightning strike. I'm thrilled that the computer now is working (I'm not a computer geek so replacing the motherboard successfully was a major triumph for me). However, now I am getting messages that I cannot use Windows update since my Windows 7 does not pass the validation test. I went to the Microsoft site and downloaded software to test the validity of my operating system and (hopefully) reregister it, but was unable to. I have the product key for the software but the Microsoft program doesn't even ask for me to reenter it. How do I re-validate my operating system without having to purchase or reinstall the software?
View 2 Replies View RelatedI will be replacing my PC's MoBo soon. My PC came with Windows 7 Home Premium 64-BitI want to upgrade the motherboard, but I heard that I will lose my OS. Is that true?If so, can I reinstall my OS (I have the product key, but no installation disk)? Will I lose my data as well?
View 4 Replies View RelatedI've had my notebook for about two and a half years now and its starting to run slow and lag often. I noticed that the cpu usage when just browsing the internet is around 50%, when watching a movie around 70%, and when playing a video game or using a big program around 90%. The notebook has a relatively slow cpu speed (1.2GHz). Is it possible to put a new cpu in my notebook without replacing the motherboard as well? It also has 4gb of RAM which I am going to upgrade to 8gb soon. I was just looking for ways to upgrade my current pc.
View 2 Replies View RelatedI have a burnt up motherboard in my laptop. My question is do I have to match the exact model to the one that is in there already inside? Or can I get one alittle cheaper? The one that is inside is around $200, and I was hoping to spend a bit less.Me and hubby can replace and change out anything on a desktop, and even build one from scratch.But laptops aren't our thing.This one is an ASUS K52F REV 2.0. Any suggestions, or do I have to match it up with what is factory?
View 2 Replies View RelatedHow to transfer win 7 to new motherboard, drive, ddr3
View 7 Replies View RelatedI'm stuck in the installation of a new motherboard - Gigabyte GA-Z68X-UD3H-B3 - and the transfer of a Windows 7/64 Home Premium system SSD to it. The basic story is that a Sysprep'd SSD wasn't recognized as having an OS when I booted with the new motherboard and now it's not being recognized with the old motherboard either.
Update: trying again. Was able to restore Win 7 SSD from EaseUs backup and then make a System Repair CD and a Windows image. those will provide security if the changeover doesn't work again.
915 motherboard intel support chipset motherboard sound, vga, usb drivers download
View 1 Replies View RelatedHow to Transfer Files from One Computer to Another Computer with Windows Easy Transfer ?
View 0 Replies View RelatedI thought my problem was a bad SSD, and so did Crucial, but after having it replaced under warranty, I am still having the same BSOD's.
I tried to follow instructions and have attached a zip file with the minidump files analyzed. I have a Sony VAIO VGN-Z570N laptop with a clean install of Win 7 Home Premium 64 bit.
yesterday i was just replacing a new RAM into my pc, bcoz there was something wrong w/ it. (BSOD happen lots of time). Im using a 2x2Gb of DDR3 RAM.
But recently, BSOD keep happening again, so i switch the slot of the DDR ( from slot 1 to slot 2, and slot 2 to slot 1), and everything seems fine until now. I had run the furmark, and the test completed without any interruption.
The question is why is this BSOD still occured while i'd replaced the RAM?
I have an HP g42-415dx laptop with Windows 7 64 bit and AMD Dual-Core Athlon II P340 which I would like to replace for a faster AMD Quad-Core Phenom II P960 from e-Bay.
View 4 Replies View RelatedI have an overclocked Athlon II X4 and I wondered if I needed to do anything before I replace the CPU? Should I remove the overclock?
View 4 Replies View RelatedI am replacing my motherboard with a Asus P8Z68 Pro and adding a Patriot Wildfire 120GB SSD. I will install Windows 7 Pro 64bit SP1 on the SSD. Windows 7 Home Premium 64 bit is currently installed on my WD 300GB drive and configured as my C: drive. Can I leave the WD HDD unconnected, connect my SSD and install the new Windows 7 Pro then connect the WD HDD and maintain a dual boot system for a while while making sure everything is working properly?Will the SSD automatically configure as C:After things are working can I just wipe the boot sector on the old HDD and leave the data intact?
View 1 Replies View RelatedI've bought a second-handed NP-RC530-S06 with a dual boot (win7 and Hackintosh). As I wanted to restore the notebook to factory status, I inserted the DVD (attached to the package) and installed win7. In fact the recovery solution was not accessible by pushing F4; probably the previous owner deleted the OEM partition... By the way, after the OS installation, the PC was (obviously) missing the drivers and the samsung software. I know I could download the samsung stuff from the support page but my idea was to get back the OEM partition.Thus, using testdisk, I re-spawned the OEM partition getting the following:
- name: SAMSUNG_REC
- hard disk letter: D.
- partition type: Primary
is it possible to restore the link between the F4 and the OEM partition? What would be the procedure?
Newegg.ca - XFX HD-577A-ZNFC Radeon HD 5770 (Juniper XT) 1GB 128-bit GDDR5 PCI Express 2.1 x16 HDCP Ready CrossFireX Support Video Cardis my current and old card, I'm trying to find something under the $200 price range again with better performance... also, the card should preferably be the same size lengthwise...8.5") I can probably jam in a 9.2" card..
View 9 Replies View RelatedI have a three yr old hp Pavillion desktop. HD has totally conked out. Was going to just get a new one, but was wondering about the feasibility, and ease, of just replacing the HD. What am I letting myself In for ?
It looks like it will cost me around $ 100 to buy a new drive, so it will be a pricey experiment if it does not work out. Lost a lot of the paperwork, so am not fully sure as to what,is in it now. I looked inside, and apparently it is a Seagate 1 TB drive. 7200 rpm. SATA, 3 GB/sec
Has the dimensions of approx. width of 4 inches and depth of 6 inches. Is this what is called a 3-1/2 inch drive ? So, what do you think ? Worth a try ?
Will the electronics in this 3 yr old pc support a new hd with its built in new electronics O.K. ?
If I decide to try just replacing the drive, what should I buy ? What should I be aware of In regards to buying a hd for my old pc ? And, do they come pre-formatted ? If not how is this handled ?
Are there still master-slave jumpers that need to be set on the new hd ? After installation, do,I just run the "Restore" disk set of 3 disks to get Windows 7 on it again ? Do these restore disks that I created when I first got the pc have Windows 7 already on it ?
Not all that sharp with this stuff, but am a retired Engr., so reasonably comfortable with this kind of thing. Still, I would not really want to dump $100 if there are lots of potential pitfalls and caveats I am not considering.
I've found this guide Windows 7 Installation - Transfer to a New Computer for changing all my components except HDD.My question is, I currently use my install as an HTPC. If I use the sysprep method, will the codecs (ffdshow etc) work correctly afterwards, or will I have to go through installing them all again?I understand graphics drivers will need re-installing.
View 3 Replies View RelatedI have a sony vaio netbook with W7 starter but it is in Spanish! I have W7 ultimate on my external HD and want to replace the W7 starter on the sony with the full ultimate version.
View 4 Replies View RelatedMy hard drive died a couple of days ago and I was wondering if the only way to get the operating system back onto a new one is to purchase a new copy? Kinda new to this so am unsure what to do since it didn't come with any sort of OS recovery cd when I bought it.
View 5 Replies View RelatedHOW TO FORMAT PC FROM PENDRIVE
View 2 Replies View RelatedWhat critical issues should I be aware of in the event I would like to REPLACE W7 os with XP3 os on a new laptop with 64-bit / 2GB ram
View 1 Replies View Relatedim just wondering if there's something wrong with mylaptop's battery as its showing this"consider replacing your battery" message on the lower right hand corner.
View 1 Replies View RelatedI upgraded my dell studio 1535 from Vista 64 bit to 7 professional 64-bit and now have problems with the keyboard (It's usually recognized, but keystrokes are often not recorded. Sometimes it doesn't work at all). USB devices work fine. I have my Vista OS under c:Windows.old so I would like to replace the 7 keyboard drivers (i8042prt.sys and kbdclass.sys) with the Vista drivers of the same names that are in c:window.oldwindowssystem32drivers Will this cause any problems? If not, how would I go about doing this?
View 1 Replies View RelatedSo yesterday, i opened my laptop to change the keyboard. But when i turned the laptop again, everything worked except that at the batttery icon there is an X. And if you click it it sais ''consider replacing your battery''What to do ?
View 4 Replies View Relatedi was on [URL] and found win8 login for 7 i replace authui.dll in system32 and sysWOW64 also replased basebrd.dll
then tried it out by switching user i got black screen then rebooted and i still got a black screen
then i booted into startup repair and then it gave me an error now i have startup repair infinite loop
I keep getting a message saying 'Consider Replacing Battery'. I'm running Windows 7 on a Toshiba A300. I've read that this is a problem with Windows 7. I'm wondering if Toshiba has a fix for this such as a fix for the BIOS.etc or maybe a driver? It looks like I should downgrade to XP..
View 9 Replies View RelatedI'm replacing my mobo/cpu with Sandy Bridge parts when they become available tomorrow, and I'm hoping to be able to move my data partition over without wiping it. I've currently got my drive partitioned up such that C is Windows 7 and basic programs, and the D drive includes my Steam games and other data. I know that a new mobo means reinstalling Windows, so will I be able to just wipe the C partition, keep the D partition intact, and then reinstall Windows 7 over the C partition on the new computer without issue, or will all the programs on D fail to recognize and function with the new Windows 7 install?
View 8 Replies View RelatedMy hard drive crashed and I am replacing it with a new one. Can I just install a fresh copy of windows 7 on acer aspire 4810t without having to do any upgrades? I cannot upgrade until windows 7 is installed first. Is that possible?
View 2 Replies View RelatedI used XP Transfer Wizard to store my files (over 200GB) on external hard drive. Now I have Windows 7 machine and can't use them directly.I tried to use Virtual PC XP mode to import files but Virtual PC can only handle something around 136 GB virtual hard disk, so after 6 hours of transfer it stopped... I don't have the XP machine anymore - I'm stuck with Windows 7 and can't figure out how to move these files over..Is there a way to actually open all these Wizard IMGXXXXX.dat files and read them?
View 7 Replies View RelatedIs there a preferred sequence that one should use (and one should avoid) in replacing a video card... to avoid being left in the dark?On my Dell Dimension 9200 (now on Win 7 Home Edition, 64 bit), I will be replacing its x16 256mb OEM NVidia GeForce 8600GT with a freed up card from another machine (x16 OEM 1GB ATI RADEON HD 5670).Will this sequence work?:remove all Nvidia software via control panel power down and remove the card insert the replacment ATI card and power up pray it will work with native windows drivers install ATI The AMD Catalyst� Control center run "auto-detect" the card follow prompts to install the proper drivers. or is there a safer sequence of steps?
View 3 Replies View Related
