Recently, after varying times of general computer usage (internet, e-mail) ranging from 5 minutes to an hour, I'll get a BSOD, with the above title. I'll attach the dump files, and include the code from it below. I've tried some troubleshooting of my own. I've run memtest86+ on each of my 4 1-gig RAM modules, all clean. I've run Prime95, clean. I've installed new video drivers. I've run a diskcheck, and used Western Digital's diagnostic utility, clean. The culprit always is ntfs.sys. Should I try to repair my windows, or replace the ntfs.sys with a new one?. Also, I don't have any readboost of USB storage devices plugged in.
Code: PAGE_FAULT_IN_NONPAGED_AREA (50) Invalid system memory was referenced. This cannot be protected by try-except, it must be protected by a Probe. Typically the address is just plain bad or it is pointing at freed memory. Arguments:
Arg1: fffffa610b3a9ff8, memory referenced.
Arg2: 0000000000000000, value 0 = read operation, 1 = write operation.
Arg3: fffffa6001219130, If non-zero, the instruction address which referenced the bad memory address.
Arg4: 0000000000000005, (reserved) ............
If you are like me and have a NAS device on your network that is not compatible with Windows Vista, now you can tweak Windows Vista to make it work again. You do not even have to wait for your device manufacturer to release a new firmware any more! Just follow these steps below:
Click on the Start Button and key in secpol.msc in the search box and hit Enter.
When the Local Security Policy editor has loaded, expand Local Policies and select Security Options.
Scroll through the list and locate "Network Security: LAN Manager authentication level." Right click on this setting and select Properties....
I installed an update today (USB composite device dc3d) and it changed my DVD RW drive from "hard disk drive" to "devices with removable storage" I think DVD RW drives are supposed to be classified as "devices with removable storage" I was wondering if this #1 Matters #2 is correct #3 will cause any problems. Any thoughts? What does your "my computer" view show your DVD RW drive type as.
2) I have a 2 gig usb drive that im using with ready boost but I havent noticed a memor difference in my graphics applications.
3) Can I add more usb drives and use more ready boost to up my ram?
Im a noivce to Vista.. I am runing 2 gigs of ram on my laptop a dell (hell) and I have running - 3d max 7, photoshop cs3 extended and usually either IE or flock running to upload my images to the web. I have a 2 gig usb drive hooked up using ready boost - it is allways flashing.. any way to add another usb drive to use as ram? or overclock the 2gig usb stick?
I get the option to "Speed up my system using Readyboost" when i put a (4g) SD card into my computer, but then when i click it, there is no readyboost tab. It is my understanding that I have to enable this in the systems.sfc,buuuut.... I have tried cmd prompting sfc/scannow, and it tells me "You must be an administrator running a console session in order to use the sfc utility." Note: I am not trying to remote connect. I am trying to enable this locally on this laptop on this administrator account. Operating system: Windows Vista Home Premium 32bit
I have a laptop with 2Gb, Vista Ultimate, and an SD slot I use for ReadyBoost. I currently have a fast 4Gb SD card, but noticed the price on 16Gb SD cards has gone way down. Would there be any benefit to replacing my 4Gb with a 16Gb, given that I only have 2Gb of RAM? Could ReadyBoost make use of it all? Would I notice any difference?
On my vista basic index score,there is one part letting my system down. Is there any software downloads to get it performing higher or it a case of new hardware.the part in question is 3D Business and gaming graphics performance 3:1.
How do I know if windows readyboost is working. i have 4gig flash drive and it even says enhanced for readyboost on package, but when I get to windows task manager it still only shows I have 2 gigs of ram. and I have all 4 gigs of flash drive used for ready boost.
my computer, running windows vista 32 bit, will not use ready boost properly, as i have a 1 gigabyte jumpdrive plugged into your standard USB 2.0 slot. Every time, however, i go to use ready boost on the formatted lank drive, it pops up this device will not work as a ready boost device, or something along those lines.
I have a flash drive that is enhanced for readyboost. When I plug it in to the USB port on my PCI card Vista says it does not meet the requirements. Is the drive the problem or does Vista require that the USB port be off the motherboard?
I have recently inherited two very old computers. I there anything useful I could use them for? For Example, it was suggested to me that I boost the HDD capacity,connect it to the tv and turn one into some kind of media server for my home where i could store videos,music, etc... What can old,slow computers be used for in general ?
ReadyBoost helps your computer by giving it more high-speed memory. If your computer is running low on RAM then it has to kick a lot of applications out of high-speed physical memory to the paging file on your hard drive. This usually results in a big hit in performance and increased activity on your hard drive. ReadyBoost helps this situation by giving Windows an alternative to having to stick data into the slow paging file on your hard drive. Instead, ReadyBoost uses a USB storage device that is faster than a hard disk. This results in a performance boost because Windows will have a high speed alternative than using the slow paging file on your hard drive....
I installed Vista after my XP became corrupt (long story...). Have noticed that it's using 510-560 MB RAM at idle! I have a total of 1024 RAM. If I get a 4GB ready boost compatible USB/flash card will it make a difference or is it a waste of money and only to be used if Vista is chewing up more than 1024 MB?
i have windows xp on my laptop Acer (Aspire 1690) ..and i want to change it to vista ...can i do that and how? what's the best edtion of vista for my laptop?
i'm going to format an external HDD: in the mask that appears in Vista i need to choose the amount i want for the size of the allocation file. what does this mean? How this will influence later my HDD storage capability?
I am sure this is not new questions but I didn't find a clear question and clear answer. I have Hp laptop with vista I need to remove vista completely and install xp on that laptop. Laptop didn't came with vista cd and I don't have vista cd. I am not worried about losing data or my driver will not match or backup. Just want to replace vista with xp. When I put xp cd install option is disabled and if I put cd and restart boot from cd installation starts but stop half way. Just want to know simple steps if I can install xp.
I just purchased a new PC. Operating system is Vista Home Premium 64 bit. The problem is I have Quicken 2007 for my business and through your forum have found that the two do not mix! So I plan to remove Vista and replace it with XP so I can continue to run my business. My question being my Vista is 64 bit and my XP disk is just home basic, so I assume it is 32 bit. Can I replace vista 64 bit with XP 32 bit?
My Vista Premium will not run autochk.exe. I ran sfc/ scannow and the cbs log file found autochk.exe corrupt. I tried to copy autochk.exe from another Vista PC to the c:windowssystem 32 folder and it will not let me. I'm running as administrator and click continue when user account control pops up, but it won't copy.
I have an internal IDE HDD that I have put in an USB external enclosure and connected to my Dell Vista laptop. When I attempt to format the drive in Computer Management, I assign it a letter and format with NTFS. However, the result is a Healthy Partition in RAW format. When I try to attempt to reformat using quick format, sometimes it will format it again as RAW, or it will give me an error message stating that Windows cannot format the drive. Again, the HDD shows up as a Simple, Basic, Healthy(Primary Partition) with a RAW File System. I cannot access the drive and put files on it.
I am changing my motherboard from ASUS P5Q deluxe to the ASUS Maximus II board. Will i have to re-activate my Vista even though the two boards are both based on the P45 chipset and similar design. Could I get pull it off or will Vista still read it as a new motherboard and have to go through all the re-activation grief with Microsoft?
I want to buy Windows Vista NTFS and I cant find it. I have a small business and I need this program for my Apple Computer. But I cant find on any website what versions of Windows vista has NTFS.
when I powered up my Vista I noticed that it was unusually slow and all of a sudden, it froze for no apparent reason. I rebooted [by pressing reset on case as keyboard wouldn't respond] and booted into XP and ran chkdsk on the Vista partition. Sure enough, it found two errors but in the index area. Here's the output of DOS window:
Code: C:>chkdsk /r d: The type of the file system is NTFS. Volume label is NEW_C. CHKDSK is verifying files (stage 1 of 5)... File verification completed. CHKDSK is verifying indexes (stage 2 of 5)... Deleting index entry SBEServer.exe in index $I30 of file 1153. Deleting index entry SonicMCEBurnEngineIcon.png in index $I30 of file 1153. Index verification completed..................
