i am unable to connect 10 systems using windows xp, i am using dlink 16 port switch, each systems detects network at a speed of 100 Mbps, the network is not connected to internet, so i used manual configuration of ip. all other settings i know of is ok, the fire walls are off, it uses norton antivirus. what do i do to get the systems connected. pls help it is hanging on my neck.
View 3 RepliesI have a home network with six computers, connected to a DHCP Router and ADSL Modem. I also have a IOmega Network drive connected to the router.Well, I had to reinstall Windows XP on one of the computers, taking the chance to install SP3 directly after installation.So far so good. But when I was going to connect to the Network drive, I could not find ANY! computers when checking for them. I can connect to the router on its setup IP adress, and also the drive setup. But I did not see the volume. I also have Internet connection.
I tried to ping the drive, and it worked. I tried to ping the other computers, but it did not work.
Then I tried to search for the volume, and it worked. I was able to map the volume as a drive, but I still cant see it on the net. Searching for the other computers was negative.
I have 3 computers on wired network and have to move one computer to another room. It would much more convenient to use the existing cable which would have to be coupled in two places, however I have been told that although this can be done it is not recommended, and have also been informed that it would be ok to use couplings.I would like to know if they are ok to use and what type to use.
I have had numerous problems with my PC - including disappearing icons, connectivity problems (I have cable internet and all seems to be in order but I can't connect a lot). I also have settings on my PC that somehow change themselves. So, I've read through the forums and decided to try the Hijack this solution and was hoping someone could help. I also cannot use Internet Explorer - I get a window that mentions internet settings. Before that window came up I saw something to the effect of c:windowssystem 32 error.
View 11 Replies View RelatedWhen i connect to the internet, The Icon of the two small computers does not go to my Task bar ( near the tasks eg: msn messenger ), until i go to My Network Connections, Right click and press Refresh... i mean it does'nt go automaticaly, same as my network connection when its aquiring the ip, it stays there in my tray until i refresh my Network connections, Anybody knows a workaround ? I don't have any idea why that happened, i don't remember missing with anything
View 3 Replies View RelatedMy dad's Dell 8400 is having a series of issues. He posted a similar thread in the Hardware forum, but it's possible it might be more than hardware, so checking here to see if ya'll might have some suggestions (as I know this forum gets more visibility and he's getting anxious).He turned on the computer last night to have it not booting up at all. It gave a series of 4 beeps followed by 2 beeps, and then wouldn't do anything after that. He tried multiple times, with one or two of them bring him to the BSD asking to boot in safe mode or system restore.
View 3 Replies View RelatedMy desktop computer has been running windows xp for a long time. It also has a linksys wireless card that connects to a router in my home. Yesterday, I tried to run an ethernet cable from my router to my computer. The computer crashed/froze almost instantly. I decided to re-start the computer and again it crashed/froze. The reason I wanted to do this is because I want to connect my linksys wireless card to a gaming console so I can play games with people all over the world. This required me to change some of the settings on my network card. This time I changed the settings before connecting the ethernet cable to my computer. When I connected the cable, my computer showed the wired cable icon "searching for ip address" then I got the "blue screen of death" saying that windows crashed due to some form of network/hardware problem. I restarted the computer and in a few minutes I got the blue screen again...
View 8 Replies View RelatedI was unable to connect to the net regardless of through direct cable or wireless pot. its only essential process' are running.
View 1 Replies View RelatedI took my daughters Gateway M320 laptop and did a restore from the CDs that came with the laptop. After doing all the Microsoft Updates, ALL the wireless driver installs from Gateway there is no 'Wireless Network Connection' icon. I have also checked Device Manager and there is no wireless adapter. Before this exercise she was running wireless fine. It does work 'hard wired' but no wireless icon.
View 16 Replies View RelatedI am trying to set up a home network to connect my laptop (with xp pro) to my desktop (with xp home) i am using a 3com office conect router as a hub. With the fire walls on each machine switched off I can see each of the machines from each other.I can share files on the laptop with the desktop, but when I try to access the desktop from the laptop I get the following message : xxxxxxx is not accessible. You might not have permission to use this network resource.
Login Failure : the user has not been granted the requested logon type at this computer.
I have Windows XP Sp2 whe i try to chanhe ip in "Local Area Connection" i got following message:" Network Connetion Folder was unable to retrive the list of network Adapters":i checked "Services" .Ok working fine then what 's the problem??
View 1 Replies View RelatedI've installed an Access database on our network. Can I connect to my db while it's on the network using IIS? I've tried in the past and have always gotten the message telling me that the db has to be local.
View 1 Replies View RelatedI have three computers that i need to connect to each other and to my network. What I want to do is put 2 NICs in each of the three computers and connect Computer A to Computer C and Computer B to Computer C via crossover cable. The second NIC in each of the three computers will be used to connect each of the computers to my network
View 5 Replies View RelatedMy wireless connection says that it is connected to the network, but can't connect to the internet. Tried to repair through MSN and said that my default gateway is down or something of that nature.
View 1 Replies View Relatedi reformated compaq laptop presario 700 have WAN network driver and bunch of aol stuff
Aol uninstall not in Add/Remove list shouldn't i be able to connect the cable modem here at work to this laptop i've been working on?i plug cable in and no connection to interenet.am i forgetting a basic thing to do?
This is my boss's daughter laptop that was Kazaa infected so i reformated.
I had a problem trying to connect my Canon Pixma 4000 so that I could access it wireless via our home LAN. I have one laptop(the wife's) attached directly to the router (cable service from Optimum). My laptop is used wirelessly from another part of the home. All was working well, except I could never get the printer to work so that I could use it wirelessly, so I had it plugged in directly to my laptop. Up to this point, it was all ok. I have AVG and ZoneAlarm running on both computers. A friend, (really) was at my home and volunteered to connect the printer so that it would work wirelessly. He is a UNIX administrator, manages a number of pc's too. I thought, "this is great, my own administrator".
To shorten the story, he removed ZA, the computer will not work wirelessly, only works when connected directly to the modem and the printer doesn't work wireless. I called ZA, and they guided me through removing all the "orphans" that were left behind, so that cleared up a problem whereas I could connect to the net, but couldn't get to another url. I did not re-install ZA yet, because I don't want to add anything else into the mix. I will post a HJT log if that is what is needed. I DO NOT care if the printer works wirelessly. I will live with it connected to the back of my computer, BUT, I do want my laptop to work wirelessly so that both me and my Frau can be on-line at the same time. I have been through the IP address checking, all is ok there. If I try to connect via the SYSLINK wireless, I get nothing, even PING ing different sites gets no valid response. Regrettably, I have some tech knowledge, but not enough to figure out this one.
I have just installed Windows XP and am trying to connect to a network via Ethernet on a Compaq Presario SR5130NX.I have green lights on the network cable and when I boot into Ubuntu (Linux), the network works fine. In Windows XP, when I go to Control Panel > Network Connections > Set up a home or small office network, I get a message: "The wizard cannot find your network hardware." Under Device Manager, there is nothing to do with network components, so I'm pretty sure that I need drivers.
View 3 Replies View RelatedI have read that you can get network connections such as Dial-up, and VPN to connect at boot of windows using windows services. - But it did'nt say how. I have found out how to add a new service, But I don't know where the root for the network connection I want to connect to is. Can anyone give me any advice or tell me where the network connections root is?
View 7 Replies View Relatedi have a problem with my network folder.It seems that I can't see my existing network connections in the folder! I first noticed this when i click on my dial-up connection the connection window won't come up.When i open the network connections folder in the control panel, an error message comes up with this message:The Network Connections Folder was unable to retrieve the lsit of Network adapters on your machine. Please make sure that the Network Connections service is enabled and running.
View 6 Replies View RelatedI can't get it connect to the internet. I know the connection is good, because I can see other computers on my home network, and those computers can get to the internet (like this one). The Bad computer has IE 7, which loads ok but then I can't get anything on the web. Also have Mozilla Firefox loaded which I was using for a while, but now it won't even open up.
View 10 Replies View RelatedI just installed XP pro Sp2 over Vista Home Premium on my laptop. Please note that I originally had XP and upgraded to VISTA (big mistake) a year ago. The installation process went well, however I can't connect to Internet. My network connection shows that I have a connection. I tried to do ipconfig from command menu and did nor get any IP address.
View 14 Replies View RelatedMy home wireless network is connected at excellent signal strength, and the other computer on the network can access the internet, but once or twice a day, none of the browsers on my operating system can load anything until I restart. Also, TrendMicro can't update until restart. Possibly related: The last time this happened, I checked task manager and found two copies of rundll32.exe, but only one copy once I restarted. The computer was nuked about a month ago, I've kept my user privileges to the minimum and I perform frequent updates and scans, so a trojan seems unlikely, but maybe it's a driver problem? Also, on one occasion the wireless showed limited/no connectivity, but this is not usually the case.
View 3 Replies View RelatedI tried to install ZoneAlarm last week which crashed during the installation. This has caused multiple issues:1 - Can't shut computer down - I can get to the "log off", "shut down" and "restart" option of which none do anything so I'm forced to unplug as the power on/off doesn't work either. I've checked the power management options and these are normal.2 - Can't connect to the internet via my network card. Replaced the card as the network cable works on laptop and though it was the card but no luck(Modem goes to router which splits to 2 PC's and laptop
View 3 Replies View RelatedMy toshiba laptop detected the wireless network in range, but when I try to browse nothing comes out!!!will reinstalling the windows solve the problem, to ensure that all drivers are defined??
View 1 Replies View RelatedI am at a friends house and one of their computers are not connecting to the internet, they have a network set up and all tha good stuff and its working fine on allt he other computers BUT hers. She recently moved her desktop from the floor to her desk to get it away from the pet hair, and i made sure the wires are all in good condition and plugged in correctly. The computer will not repair the connection nor will the internet work.
View 2 Replies View RelatedI have been having alot of trouble lately. Every time I try to click on a site I get an unable to connect message, if I go back and try again it usually goes through the third or fourth time clicking the link. This is happening with every site. I am running windows ME. I have tried disabling Norton, running ccleaner, all spyware utilities and nothing helps. It has taken me about 45 minutes just to be able to post this message.
View 1 Replies View RelatedI'm trying to connect my PC with Windows XP Pro. via RDC on the internet, the screen pops up with blue screen but it never refreshes for login screen to come. It's stays there while and then it will disconnect. But am able to login on my own network either LAN or WAN. Outside my network it never works, what should I do pls!
View 6 Replies View RelatedI have a Dell latitude D505 and reinstalled the OS on it, i loaded win2000 on it first and updated the heck out of it. every service pack ect. internet worked great. Now i upgraded it to winXPPRO and can not get the Ethernet controller or Network controller to work. cannot get on to the net wired or wireless. I did try installing the drivers before the chipset's but i think even after installing that it would work. nothing. tryed like 5 different drivers for this and nothing. i do not have any dell cds so im doing good so far the only thing in the device manager that is showing up in other devices with points over them is the Ethernet and Network controller.
View 14 Replies View Relatedfor a little while now i've been unable to connect to any servers, or at least thats what i think. I play lots of games online and so on. things were fine and then one day i recieved this error while trying to play 'halo' online. 'An error has occurred while trying to contact the gamespy master server'. after messing around with halo for a while i tried other games; doom3, quake3, counter strike and so on, but all with the same effect, i couldnt connect to a server. This was also the case when i tried to update Ad-aware, it freezes when i try to update. I've checked my firewall and individual programs but have come to no conclusion. have also tried 'system restores' but each time they fail?
View 2 Replies View RelatedI have been having alot of trouble lately. Every time I try to click on a site I get an unable to connect message, if I go back and try again it usually goes through the third or fourth time clicking the link. This is happening with every site. I am running windows ME. I have tried disabling Norton, running ccleaner, all spyware utilities and nothing helps.
View 3 Replies View RelatedFirefox made an automatic update to my system. consequently am unable to connect to firefox because mcafee wont let the update be activated.
View 1 Replies View Related