after plugging in the external hard drive after a while I get you need to format the disk in F:\ do you want to format?After a while throws another warning saying F: is not accessible, Data error (cyclic redundancy check)It was working well until last week but then suddenly started giving this error message.
View 1 RepliesI have recently had to ditch my old computer windows xp, and bought a new Dell running windows Hoem repmium 7 (64 bit). I had a 32 bit ide external hard drive and had backed up my files there. Having got the enw copmpouetr set up I am trying to access my archived files on the 32 bit to transfer to new hard disk, but am unable to do so. Windows explorer locks up.
View 3 Replies View RelatedI have a Maxtor External Hard drive and Windows 7 Premium 64 bit. I have a user setup for each member of my family on the computer. The maxtor drive was working fine uptil I decided that I wanted only myself to be able to access it only. The drive appeared as my K drive. I went to sharing and added myself as read/write access and removed the everyone share thinking that only I would be able to use the drive. I restarted my PC and now nobody can access it. When I plug the drive into the usb slot the drive whirs up as normal but there is no drive letter for it and it does not appear in device manager etc. I plugged it into my old XP machine and that cannot read it either..
View 2 Replies View RelatedThis morning while i was watching a movie from my Toshiba 500GB external hard drive, there was a windows update going. Because of the lagging due to the update and all, I restarted it after the update is done while my ext. HD is still connected to the computer.
After restarting, somehow I can't seem to access my ext. HD even though the HD is detected. The HD somehow became a "Local Disk K:" and everytime i try clicking it a pop-up telling me that "K is not accessible. The parameter is incorrect".
I googled the problem and found one solution that told me to run a CHKDSK on the command prompt. I ran a "chkdsk /r K:" but then got stuck on the "stage 3 of 5" where the chkdsk is verifying Usn journal. This has been going on for 5 hours and the cursors still blinking.
I can access my HD again? Does the verifying Usn journal really do take this long?
I am using Windows Seven ultimate x64 and I started having a problem when trying to access user's folder under documents and settings or users on any attached external hard drive on my computer. i didn't have this problem before, it started on the same installation of windows and without any changes to my system settings or user settings.
I am a computer tech and I use my computer to backup data before repairing computers so I attach the hard drive to my computer using a USB enclosure. This is limiting my work since I didn't find any solution yet. It's giving me the error below: "you don't currently have permission to access this folder" This is happening on any external hard drive I want to access the user's data.
i took out the hard drive from my laptop that had a BSOD and can't boot. I boutght an enclosure n plugged it using usb to another laptop so i can get my files, but when i click on the disk a window pops up saying disk is not formatted..i dont want to lose my files si i downloaded tesdisk. When i choose "Analyse" it seems that it finds four partitions, but above each one there's a warning "Incorrect number of heads/cylinders 255 (NFTS) ! =240 (HD) or Bad sector head and Bad Ending Head and Bad Starting head..I dont know what to do next.
View 1 Replies View Relatedcan see my external hard drive in device manager, but not able to access it
View 4 Replies View RelatedI have a Titan 500 GB portable hard drive, the computer will after a longer than normal time recognize the PHD, the list of files will open up. But when I try to open the file, I get a non responsive message, then it just freezes.
View 2 Replies View Related.I didn't wait for the computer to tell me it was ok to remove the drive in the usb port. Now my computer no longer recognizes the external drive After removing my external hard drive (without the ok) my computer no longer recognizes the external hard drive. What do I do.
View 1 Replies View RelatedI have an internal hard disk not in use ,and I would like to make it as external disk !I looked on the net and I found I should have the " encelsure " butt I think I wont find it here in my city .So is there another way ? like usb -esata cable
View 3 Replies View RelatedMe and my brother built me a new computer from scratch (he did the building - i did the watching). I purchased an internal hard drive from Overclockers UK. It's a Samsung 1TB drive. I also have a 64 Solid-state drive in there as my primary hard drive that Windows was installed on and a couple of programs are installed on. My storage disk (the 1TB disk) is for all my music/films etc. Whenever I drag and drop a file into the Samsung hard-drive - it copies it rather than moves it instantly.When I had a laptop, I had 3 external hard drives and this is the way it copied files onto them.how I can get the internal drive to stop acting like an external drive?
View 6 Replies View Relatedunable to access external hard disk?
View 2 Replies View RelatedI have a USB external hard drive that I keep all my documents etc on (had it for years)I upgraded from Vista Home to & Home Premium then had to upgrade recently to Professional to run my Sage. Through all these upgrades my ext. drive ran fine. Occasionally the drvie letter would change if I had something else plugged into the USB, this was always easily corected in disk management by changing the drive path.The connection on the case packed up so I had to get the drive put into a new case, now when I plug it in the drive is assigned G instead of F, I tried to change the drive letter allocation in Disk Management but it won't let me as the program still thinks I have a second ext. hard drive which is labelled F. I suspect this has happened because when the usb connection broke the drive was disconnected suddenly instead of a proper eject.How do I get Disk Management to remove the inactive drive - i can't find any obvious way - eject, delete etc are all missing when I click on tools or tasks.
View 2 Replies View RelatedLow disk space, Can transfer data on D drive to an external hard drive
View 5 Replies View RelatedI can see my external hard drive in device manager, but not in my comp
View 3 Replies View RelatedMy external dvd/cd drive (Sony DRX S7OU W) previously worked from this computer running on Windows 7 but I now receive the message "Windows cannot access the specified device, path, or file. You may not have appropriate permissions to access them." The same dvd/cd drive continues to work on other computers. All other devices that I link to this port (camera, ipod) continue to function. I tried new firmware downloaded from Sony but this did not help.
View 2 Replies View Relatedmy SSD drive was suddenly inaccessible after a reboot, so I put my backup spindle drive into my laptop to get it started. Because I have important files I need to access from my ssd I put that into a case and plugged it into the USB port. Now windows explorer just hangs forever trying to detect/access it! in Computer management I cannot see the disk partition but I can see the harddisk device in device manager.
In windows explorer I can see one drive letter assigned (there should be two drives on the ssd) but when I tried to access the drive it just hangs forever. It also hangs with any other methods I try to access it (chkdsk, data recovery programs, Testdisk by CGSecurity)!!I think the main issue is that the external ssd is locking up everytime some program tries to access it... perhaps if I can somehow remove this lock I might be able to attempt a data recovery.
External hard drive salvaged from computer running Windows XPEncased, plugged into USB on new computer running (not by choice) Windows 7(Know where this is going?) Given every permission and ownership to new computer to have its way with docs on external drive. Can't copy docs from external drive to new computer even in (basicithout networking) safe mode. (And haven't tried a mac.)Can I somehow change permissions or ownership on the EXTERNAL drive to access my own documents? Anything else?If I throw it against the wall, will that work? Who is this other administrator to give access, when I'm the only administrator?
View 1 Replies View RelatedI just got an external hard drive yesterday, and have been asking a few questions on this forum. So far, people have managed to be very helpful with the previous questions, hopefully someone can do so here too.Reinstalling all my games to external hard drive, need to know if they will / how to make them appear / function properly in my GEF, whether added automatically or manually.I am basically going to have EVERYTHING put onto my 1TB external, and by everything I mean "Music, Pictures, Videos, Documents, Games, and maybe Programs". So, I made a folder for each of those things on it,and only now that I am reinstalling my games into the Programs one have I realized something.I am a bit obsessive about having a fully functioning Game Explorer Folder (GEF) with all my games visible in it. It's my assumption that when I install into an external hard drive, none of those games will be automatically added into the GEF. However, if I add them in manually (using the regedit method in the tutorial), should everything function properly, so long as I have my external hard drive on whenever I use the computer?I just need this to be confirmed before I start reinstalling more. Also, if not, please let me know if there IS a way to get them to show up in my GEF properly, or possibly move the GEF to the external hard drive or get it to recognize things from a different directory.
View 6 Replies View RelatedIn order to make upgrading via a clean install easier -- and because I've been considering one for awhile anyway -- I'm looking at picking up a decent external hard drives right now... and can't seem to find a clear answer to something:
Will I see any drop off in quality of playback or computer performance if I use a drive like this (external, USB) to store all of my recorded videos. The tuner and Media center would save everything directly to this drive and play everything directly from it. Would that cause any problems at all? I notice that it requires no power adapter since it's USB powered, and it has a Interface Transfer Rate of 480 Mbps -- not sure how either of these apply to my potential use of it.
if I could use my external hard drive to install windows 7 on a new build with a new hard drive?
View 2 Replies View RelatedAttached an external sata hd with an esata connection. After power boot, external drive not recognized and also secondary internal sata hd not recognized.
Do I need to do something to the BIOS?Sinch stonooka has chosen the best answer to his/her question.Click here to view the answer that was selected.
My windows vista computer died. I have backed it up on and Iomega external hard drive but can't figure out how to restore the information to the new computer which is a windows 7.
View 12 Replies View RelatedWhenever I power up my computer, my external hard drive does not always come on line. I have to unplug and replug it for it to come on line.
View 1 Replies View RelatedI just got a new Packard bell go external hard drive which I used for a couple of days with no problem. btw it has never fell or had any physical damage. I plugged it one day into the PC and it couldn 't be detected in my computer. it shows up in devices and printers and also in disk management. I read on some forums to try and initialize it but it gives me an error saying cyclic redundancy check. I 've tried everything but still not working. this is a new hard drive which has never fell and no physical damage. and please don' t tell me to return it cos it was bought in another country. the only option right now is to fix it?
View 14 Replies View RelatedRunning Win 7 home, acer 1800.About a week ago I installed a Buffalo 1.5 TB external drive and automatic back up package, it was working very well, however it now shows as " Not Connected".I have replaced the usb lead but no change in status.It is also no showing up with other drives?Any one had this problem and found a fix?I did a search but found nothing quite like this.
View 2 Replies View RelatedI have a 2TB Seagate hard drive that keeps dropping out in Windows 7. I use it as my main backup drive and when writing to it using either of the two backup apps I use the drive usually "disconnects" and I have to switch it off and on again to use it.I've tried using a different USB port and a different USB cable - same thing. I have run Windows 7 error-checking checking which reports no errors.When it disconnects, device manager shows that it is still connected and working but it definitely doesn't work. For instance, I can double click and open it but it shows no folders. Switching it off and then on fixes this but only temporarily.
View 2 Replies View RelatedWhenever I try to eject a certain external hard drive using the little icon in the task window, I get a message that it is in use. I am very careful to be sure it is not in use but still get the message. This is a data storage disc. I am not aware of any programs on it that may be running in the background. Is there a way to examine a disc to see just what is being used on it at any given time?
View 9 Replies View RelatedI've recently spent 2 days indexing an external hard drive and now the index has appeared to have gone, for most of that drive.
1) if I index an external drive and remove, re boot, and re attach the drive, will the index still work for the external hard drive?
2) if the answer to question 1) is yes, why can I not search all but the most recent files on this re attached drive?
I'm trying to backup my data on my laptop to an external hard drive. Windows isn't recognizing it for some reason.
The laptop is an HP running windows 7 and the hard drive is an Eagle Cansus. Using the windows commands in the control panel don't seem to help.
I have been using a commercial company to back up my computer for the last 2 years. Now I have decided to do my own backups. I already did the first back up to the external drive. Now its time to back up again, when I back up again, will everything be backed up again? Or just the files that have changed?
View 1 Replies View Related