Windows 7 - 0x8004240F Error When Trying To Make New Partition
Dec 2, 2012
0x8004240F. I encounter this error for the very first time and it happens when I try to make a new partition to install Windows 7 on it using Windows 7 installer (not disk management!) The hard disk has a legitimate Recovery partition of HP (which was active and primary) and another data partition. It has 40 gb of free space. Even if I select like 1 or 10 or 20 gb it still gives 0x8004240F error. I made several commands (after installing Windows 7) like bootrec /fixmbr /fixboot /rebuildbcd and they didn't detected the Win 7 I managed to install BUT I made it's partition in Acronis Disk Director suite. After each restart Windows 7 wanted to start chkdsk on drive C (the Win 7 drive) automatically.
Also the system thinks there is an older version of Windows but there isn't. The partition I created with Acronis was reported Primary in acronis, but in Win 7 installer it was reported as logical... Currently it is reported as Extended. Paragon partition manager reported that some partition overlaps another and this must be the key to solving the problem. But why fixboot and fixmbr didn't worked? I even tried them on the other data partition. I haven't modified the Recovery partition only made it hidden and not active. How to check the partition table for errors and fix them so Windows 7 won't get this error?
0x8004240F I encounter this error for the very first time and it happens when I try to make a new partition to install Windows 7 on it using Windows 7 installer (not disk management!) The harddisk has a legitimate Recovery partition of HP (which was active and primary) and another data partition. It has 40 gb of free space. Even if I select like 1 or 10 or 20 gb it still gives 0x8004240F error. I made several commands (after installing Windows 7) like bootrec /fixmbr /fixboot /rebuildbcd and they didn't detected the Win 7 I managed to install BUT I made it's partition in Acronis Disk Director suite.
I was trying to install win7 ultimate on my laptop which had winXP. It has two partitions C: (220GB) and D: (280GB), while i was doing the installation, i deleted D: and installed on C.After the installation, i went to computer mgt to format the D as it was not listed in my computer. I noticed it had Extended partition and written on it is FREE SPACE. Well i went on with the format process but it prompted an error saying "not enough space" i don't know what this is.I tried installing win7 again so i can format drive D but it gives me error 0x8004240f. thus i cannot go on.
I have two hdds (500gb 7200rpm) in my laptop and have 260gb of data on the second one. I wanted to create a partition for games at the beggining of the 2nd drive (the left side) as i heard it increased performance to put games in anoher drive and at the beggining of the drive.Will it make difference to make a partition at the beginning or at the end of this drive when it comes to gaming performance?My cousin showed me one game in the same drive installed in the 1st of four partitions of a 500gb 7200rpm (the same i have) performing with 3-5 fps more than that game installed in the 4th partition of that same drive....
I install Windows 7 64 bit in a 60 gb partition of my HDD (C drive). I have about 200 GB free space in D drive. Now I want to make a 60 GB partition from the free space of D drive.
I recently acquired a 60GB SSD and want to migrate my current system hard drive to the new drive. However, when I go to the Windows Backup manager to create a system image, it wants me to copy ALL of C partition and ALL of D, when it should only be C.D drive is full of a bunch of crap that I do not want included in the system image.If there even are system files on D, by no means is copying the entire partition necessary!Therefore, is there any way to make partition D NOT a system partition?
I have a system with two harddrives, one with Vista and one with Win 7. Vista drive was used to boot the system. Recently Vista drive dies, so I tried to boot from Win 7 drive. Since bootsector isn't there I can't. How do I make the remaining Win 7 drive bootable?
I already know how to make a data partition but I wanna know how to make a data partition with windows 7 on it so in the case of an emergency i can use the data partition with windows 7 on it to reinstall the os so I wont have to use a disk im asking because my pc did not come with a partition that has a copy of the preinstalled os on it so you can reinstall the os if needed like with most pcs thats you buy from the store. Im currently useing a preinstalled version of windows 7 but I also have a retail disk with windows 7 on it
I would like to make my PC dual-boot with Windows 7 Home Premium 64bit version & Linux Ubuntu. I know about Wubi to install Ubuntu within Windows, But would like more space than the 30gb limit that Wubi uses. How do I create an partition with Windows that can be used for a dual-boot. doctorwhovian11-24144041650249291689021989539000 has chosen the best answer to his/her question. Click here to view the answer that was selected.
I'm helping my brother to set up a dual-boot of Windows 7 & Windows 7. The reason for this strange setup is because my brother wants to have his own Windows 7 system, separately from his son who keeps causing trouble with trojans/viruses & online games. I have several questions before I do this. What is the fastest way of installing the OS twice with some basic applications on it? Is it possible to just re-image the first installation to the 2nd partition & make some changes on it to avoid reinstalling everything twice? It would save time a lot. But then, what changes should I make to the system to make it dual-boot? Will that be complicated or even possible?
Though there is 200 GB space available in my C drive I cannot create a disk partition using disk management , i am getting the available shrink space to be zero when I click the shrink volume.. but I do have free space..My system is Dell Vostro 1440.. How should I make the partition now?
I am on my grandparents desktop, and they recently had me dual boot Windows 7 onto their Windows XP machine, and they now no longer need XP anymore. The XP partition is listed as a System, Healthy, Active, Primary partition. The 7 partition is listed as a Boot, Active, Healthy, Logical partition. How can I delete/format the XP partition and make the Windows 7 a primary partition? I have tried by using Disk Manager, and Eauseus Partition Manager, but it won't let me convert it to primary, or format the XP partition.
No install disks, no manual just letter telling me to protect customer data entire drive was wiped clean including Recovery partition. Checked disk management it shows all 4 primary partitions used: 200mb (boot), 169gb (C drive), 281gb (D drive), 16.5gb Recovery partition. I tried F9 when booting (nothing) just boots into OS. This setup is completely useless to me. Called Asus ($50.) for install disk they said call Microsoft, call Microsoft ($99. new disk) they said call Asus, I've already paid for Win 7 once and i'll be damned if I pay for it again. Typical corporation bullshit.What I want to do is install Win 7 on 1st part, 2nd (shared NTFS part), Ubuntu on logical partitions.
I am thinking about dual-booting my system with Windows 7 as the main OS, and linux ubuntu as a secondary. I have a few questions:
1. How much space should I leave for ubuntu's partition? 2. How do I make a swap partition (or whatever it is called, for swapping files between OS's)? 3. Can I set it up to automatically boot into windows unless I am holding down a specific key, or something similar?
BTW, my HDD is ~500gb, but my current (factory) windows partition is 450gb.
I currently have a disc copy of windows 7 and I am currently running it as my main OS as well. I was wondering just in case my computer decides to have a few issues is there anyway I can make a data partition to store windows 7 or put it on a flash drive so that in the incident of a hardware failure I would be able to go into my bios and boot the recovery partition or boot it from a flash drive allowing me to reinstall the OS.
i resized my my C: partiton and it is my main partiton usin Partiton manger and since then it is not bootable and windows is not loading although i didnt format
I was wondering if it's possible to make a restore partition in my HDD? Just like the laptops now that come with the restore already built into the drive, any way of doing this?
At the end of each semester, I typically restore my primary laptop (Asus G1S) to the factory default settings. I realize that this isn't technically necessary, but there's something psychologically pleasing about a freshly installed operating system. It's somewhat like returning to a hotel room in the afternoon after the maid has tidied up. The bed is made, the bathroom is stocked with clean towels, and the free water bottles have been replenished.
I'm currently downloading the Windows Seven installation files, and have been reading through various guides. Many writers recommend partitioning one's hard drive to permit a dual boot. However, since I've just restored my system completely, I would rather just turn the entire thing over to Windows 7 without any Vista remnants clogging up the machine. If things go south, I can always unpack the restore disks and revert to the factory default state.
Is this advisable and possible? Can I completely wipe out Windows Vista and turn my machine entirely over to Windows 7?
I have an HP pavilion dv6 that came with windows 7 64 bit. But I'd like to install Windows 8 on a separate partition. I tested this out on another computer and was able to successfully make a bootable partition and run both windows 7 and windows 8. But when it comes to my dv6 I'm having issues. At first I found online that a dynamic partitions can't install windows and that only 4 partitions max per drive. Did some more searching and found out that I could just delete my hp_tools and recovery partitions after I make a backup. And even though I did that, I still get dynamic partitions. Keeping me from installing any other os.
I'm trying to dual boot to get vista and Windows 7, but my vista won't give me more than 300mb space on my second partition. I saw an old guid to get past it, but it told me to delete all my hibernation files and recovery files and for about 50% of the comments that didnt work. My question is: Is it safe to delete those files or is there a newer and more effective guide or should i just install Windows 7 on the same partition as vista`?
I am going to install Windows 7 on a Dell computer, that came with Vista preinstalled. The computer has Vista on C: drive, Dell restore to factory specs on D, including Vista System Restore. There is, also, a small drive that contains Dell Diagnosis. I plan to keep all of these drives, when I install Windows 7 on C drive. I plan to make another partition for Windows 7's System Image. Any suggestions how large I should make that partition. Space is not a problem?
So I copied / duplicated a copy of my C: into another partition, H: using Partition Master.This has worked successfully, however I would like my laptop to prompt me during boot so that I can choose either of those partitions. How can this be done?(Using Disk Management, I can see that C: is the primary, and H: is a logical partition).
Does anybody know the command to make a partition bootable in Win 7? Fdisk does not work and I want to partition and make it bootable for an older program that runs in DOS
I just did a clean install and created 2 partitions.... C and D. I meant D to be the Windows partition and C be my main. Well I messed up I guess lol. I made 2 partitions C being 30gb(supposed to be 450gb) and D being the 450gb(supposed to be 30gb). How do I switch partitions? Make C become D and vice versa?
Also, how do I make everything I download and install in the future use
Am I only allowed to make one copy of my Recovery partition?I have a Dell desktop, with a built in Dell recovery partition. I have read that. "You are only allowed to make ONE copy of your Recovery partition and it must be on to ROM CDs or DVDs."I didn't know that when I made a copy of C and recovery partition to my external drive, I am a bit concered that I can only do this once. Is that strictly true?
I have my HP Laptop which came with Windows Vista as the OS. I want to upgrade to Windows 7 so I bought Windows 7 from my local store.I entered the disc and did boot from CD. It reached to the page where it shows the disk partition. I deleted the partitions and created new one. However, whenever I create the partition, it creates a primary one and gives me error saying Setup was unable to create a new system partition or locate an existing system partition.
I had to install windows 7 in my pc.....bt while installing a message always shows up saying "windows could not format a partition on disk 0.an error occured while preparing the partition for installation.error code 0x80070057"my hard drive is samsung HD502H(500GB) and have a partition of 93.1GB.
So I have a machine on my hands that is suffering registry damage due to viruses that I managed to remove but I still can't get the registry repaired since the computer has no recovery partition and the original cd is gone. System restore did nothing so I'm wondering if there is a way to fix the registry with what those things missing.
