PC-Doctor Diagnostic Tools Preinstall
Jul 29, 2008Can anyone here tell if it's possible to reinstall pc-doctor diagnostic tools that came preinstall on hp computers?
View 4 RepliesCan anyone here tell if it's possible to reinstall pc-doctor diagnostic tools that came preinstall on hp computers?
View 4 RepliesRunning Vista and am logged on as a member of the Administrators group and "owner" of C: drive, but cannot start the Diagnostic Policy Service. Error 5: Access is denied.
View 9 Replies View RelatedI can't afford to lose any of my data (who can?), I'd like to have something on my laptop that monitors the hard drive - and any external USB drives. Free is good but I also want quality. Perhaps some readers have suggestions for software for me? Don't worry, I keep an external hard drive for backup and use it often. But, it wouldn't
hurt if I had something to monitor my drives. The external hard drives crap out to often and leave me without a backup until I replace it.
After running the System Health Report from here;
System Health Report
at the System Diagnostic Report, I get a warning advising that the scan failed to detect running anti-virus, anti-spyware etc. protection, here and yet at Start>Control Panel>Security Centre, all protection requirements are shown as up and running, here
is there any way that I can get the scan to recognise the Security protection setup, and so include it in the System Diagnostic Report? I've had no problems with viruses, malware or spyware. This is purely an administrative issue to try and get the System Diagnostic Report to give a true account of the system.
I have the Diagnostic Policy Service (DPS) set to automatically start, but it never shows that it's running. When I try to start it manually, it starts and then stops with a message that says that some services just stop when they are not in use by other programs. There are no error messages on the Event Viewer that are related to this. (Just informational messages showing that it started and another showing that it stopped). This service used to work, but for some unknown reason just decided to quit functioning. Does anyone have a clue as to what's happening? I've Goggled it and have found others that have the same problem, but no solutions were located.
View 4 Replies View RelatedOkay, so I've had this HP Pavilion with Vista 64 bit less than a week (see specs below) and it's much much faster than my old Dell model [with XP] BUT today I was running a scheduled Hardware Diagnostic and it took like 30-40 min. and towards the end of it I tried to change the Power management so it would not go to Screen Saver mode (as it already had) and when I tried to do so, it took like 3 min. for it to open the Control Panel, 3 more minutes to open the Power Options dialogue, 2-3 more minutes to open the sub-menu there, and so forth - altogether about 8-9 minutes to do this simple task of changing Power Options while running hardware diagnostics.
I can understand that Hardware Diagnostics might take a lot of the computer's resources, but THIS is ridiculous! It was like going back to Windows 98 with 256MB RAM. Problem is, I have this*, so it shouldn't be this slow! Should it??? :
*Pavilion a6750y Desktop
AMD Phenom X4 9650 quad core processor
8gigs PC2 6400 DDR2 SDRAM
750 gig SATA Hard Drive (7200 rpm) (with about 650 gigs of space left!)
ATI Radeon HD 3200 graphics with 256mb memory
2MB L2 _ 2MB shared L3 Cache memory
Windows Vista Home Premium 64bit
Is there a way I can tweak my memory or ? to make this not happen? Or does my computer have a serious problem?
how/where to uninstall Microsoft Diagnostic TOOL (MSDT). Got on their site last night as they offer free help on SP1 and inadvertently clicked yes when I meant to click no when asked if I wanted to download the tool; comes with ActiveX too. Now, I can't find any uninstaller for it, anywhere.
View 6 Replies View RelatedI ran Autoruns for Windows and under Task Scheduler it has Windows Disk Diagnostic User Resolver with a Red Circle with a White X inside of it. Image Path C:WindowsSystem32dfdwiz.exe
What concerns me most is that it is "Unticked" to autorun.
a. Should I have this item ticked to run?
b. If so what has caused it to become unticked and now apparently is not running?
c. What are the consequences of placing a tick back beside it to enable it to run?
In the past few days I had some erratic computer problems, but has now seemed to have settled down.
I ran the Memory Diagnostics tool and after it completed and rebooted back into Windows, I didnt see any results. Where do you see the results of the test? I'm trying to diagnose this problem where my PC is rebooting at random, but I can't determine if it's a memory problem or not. So where can I find the results of this test?
View 7 Replies View RelatedLately I bought a new nice laptop with a strong cpu and lots of ram. The reason was, that a wanted to use it for both gaming, programming, designing and recording music.
This other day, I finaly had enough saved up for buying the M-Box 2 with Pro Tools software. At this point, I realised, for my big dissapointment and confusement, that it wasn't supported for my Vista system?
I learned, that Digidesign doesn't support Vista Home Basic, and overall doens't support 64 bit systems!? Ok, maybe this is Digidesign's problem, but then again - if I had known this before I bought my laptop, I would surely have bought a mac instead, so at that time it gets your problem.
My question is therefore: Why is M-Box 2 and Pro Tools not supported for x64 Vista systems, and why only a couple of x32 systems? This is simply not good enough, and I really must underline my dissapointment in this case.
I was looking for the snipping tool but it was gone, so I went to turn windows features on/off and the box was checked for tablet features. So I unchecked it and rebooted, went back to turn on features and rechecked it and rebooted again. Still the folder for tablet tools including the snipping tool is empty.
View 8 Replies View RelatedI've tried some methods already and still unable to use "Computer Management". I've tried having my computer in safe mode. I've tried going to cmd and net user administrator /active:yes and tried to access "Computer Management" I've switch on and off UAC. Note* I am logged on as the administrator. I am using Windows Vista Home Premium 64bit What can I do to access the Administrative Tools?
View 6 Replies View RelatedIt reads in part "Ironically, the new operating system has been hailed by
Microsoft as the most secure version of Windows to date. However, recent
research conducted with statistics from over 1.4 million computers within
the ThreatFire community has shown that Windows Vista is more susceptible to
malware than the eight year old Windows 2000 operating system, and only 37%
more secure than Windows XP," Clausen said. "
I installed the 64 bit version of DAEMON Tools (the 32 bit version won't even install), and it gives me this error when I try to run it that says:
Initialization error 7.
This program requires at least Windows 2000 with SPTD 1.37 or higher.
Kernel debugger must be deactivated.
What are they talking about? I'm using Vista x64, and this is the Vista x64 version. What is the kernel debugger, and how do I deactivate it (and do I even want to)?
Today I found that the Administrative Tools folder items are missing. This has happened before but can't remember how to fix it. Also when I attempt to merge a .reg file back into the registry the file simply opens with notepad for editing?
View 6 Replies View RelatedI was poking around and noticed the following: Administrative Tools > Services (%SystemRoot%system32services.msc). However the following exists as well: (%SystemRoot%SysWOW64services.msc). So, is Vista 64 by default using the 32bit versions, or are the 64bit version in system32 as well? Note: When I run both neither have the "*32" which I'm assuming is a flag for 32bit support.
I have been trying to delete/uninstall Spyware and it just wont.
View 4 Replies View RelatedI'm looking for a native x64 command line tool that can display the amount of free RAM. It has to be a true x64 tool. Does anyone know one? My google searches brought up nothing.
Edit: I finally found what I was looking for. RamStatus is the tool that helped me out.
I need to go into the internet options from the drop down tools. When I click on internet options nothing happens. No little window opens with all the tabs in it.
View 9 Replies View RelatedAside from Vista's standard cleanup, disk tools. Does anyone have any recommendations of any good programs for Vista?
View 9 Replies View RelatedI have a sound trigger for the 'Open program' event in Vista Basic sp2 x32 When my computer is idle and I "here" a program open the only thing I have to go by is the time it occurred. If I want to go to Event Viewer in Administrative Tools and see what this event was that triggered the event sound I'm overwhelmed with a bunch of categories and sub-categories. In order to find what opened at the specific time I need to check each category and sub-category. That is a real pain in the ass. I find no search capabilities in Event Viewer unless I've missed it. Is there some way of making a hunt for a specific time easier in Event Viewer? Or, is there some 3rd party software with the capability to sort all events by data and time??
View 9 Replies View RelatedI have disc defragmenter to run at a certain time, say I am away from my pc and my screen saver comes on does it still work? as in run disc defrag still?
View 4 Replies View RelatedThese two Admin. Tools are not running;
Administrative Events -
and,
Network Diagnostic Events
I would like to know how I go about enabling both.
For all the iPod/iPhone users, today I?d like to share two software which will make your digital life much cooler and easier! '*Tipard iPod Transfer Pro*'them are all the professional software designed for the iPod/iPhone users. The following guides will respectively introduce their functions in details!....
View 9 Replies View RelatedFull Antivirus Programs. Avira Antivir (downloadable free software) Avira is one of the best Antivirus vendors on the market. ((AV-comparative 2008) Avast! (Alwil) (downloadable free software) Free Home Edition antimalware progam. AVG Antivirus (downloadable free software) Free home Edition single computer use-non commercial use Not free, but highly recommended ( free 30 day trials)
Eset NOD32 4.0
Avira Premium/Pro
Kaspersky
Norton 2009................
I have just built 2 new ISO's (one for 64-bit and one for 32-bit). It contains a crap loada stuff. It has about 10 programs (installation files) of all the best removal products available these days. The links are:
32-bit: MEGAUPLOAD - The leading online storage and file delivery service
64-bit: MEGAUPLOAD - The leading online storage and file delivery service
I will be making video tutorials soon, and post them online or wrap them up in the ISO (not sure yet, dont want size to become a factor). Anyways, use them out, and let me know if there are any programs I should add. Remember, this iso is for programs needed for removal of infections, not other computer needs.
Programs included:.............
Well im trying to mount a ISO file with daemon tools version 4.12.3. It's in Finnish and says that : "Autorun stopped working, windows is checking to solve this problem". Well i tried to enable daemon tools in this autorun crap in : control panel -> system -> systems preferences -> executive function -> the on in up. And i added daemon tools there, clicked use and ok then i rebooted and still that annoying thing is there when im trying to mount.
View 9 Replies View RelatedI am having trouble signing into msnews.microsoft.com from the toolbar button and the menu selection under tools. If I try to send a message (including this one) I get "Not Responding" . I have to then close Windows Mail from the Task Manager, reopen Windows Mail and try to send again. Is there some reason the Windows Mail does this even though I have given it my Windows Live ID and password?
View 4 Replies View RelatedI do have Window Vista premium and it says on window mail not available. I followed a suggestion toclick on tools and then option, but I do not have an option to click on in tools.
View 4 Replies View RelatedIm currently rebuidling a friends computer. I am installing vista and adding software for him. Is there any software I can add that will let me take control of the computer when he is back at home and I am at my house? I dont want him to be able to see the program starting up all the time because I may never need to use it and he doesnt want me to install it. However I know in a few weeks time he will be on the phone asking me to deploy Logmein IT Reach to him and I really cant be bothered. I want to set it up now so I can control it whenever I need to. I have also installed a hidden admin account to use.
View 4 Replies View RelatedCan someone point me toward anything that defines the individual settings under; InternetExplorer/Tools/Advanced/Settings?
View 7 Replies View Related