I am on the road and trying to do a system restore. I use an external hard drive in my office but I do not have the external hard drive with me now. I can not get the restore to complete and I can not get the undo to fully complete. Is this not working fully because I am not hooked up to my external hard drive? When I initiated the restore it asked something about the external hard drive.
View 3 RepliesWhen I start SR I can only see one restore point, the one I made the day after I replaced my hard drive.But now when I try to create a new restore point it allows me to enter the name, then after I click OK I get the message ''System Restore is not able to create a restore point. Please restart the computer , and then run System restore again.''After I restart I run System Restore again and get the same message.
Also, the restore points I made before I replaced my hard drive no longer show up.When I replaced the drive (with a Maxtore 80 gb), I used their MaxBurn program to duplicate everything form the old one to the new one. It boots from the new C drive and runs OK and all my programs are there, but some act strangely. I'm wondering if these programs are looking for some kind of system volume information tho make sure they are still on the original system.
I have an external hard drive that I have assigned it a permanent hard drive letter reference through Disk Management. I have set the System Restore tab in My Computer Properties tab to not moniter this external hard drive K. Problem is that every now and then when I plug in every now and then for backing up my files via Briefcase - this will activate the System Restore function on that hard drive. This usually happens when I have the hard drive plugged in when I either turn off or turn on my computer. I stopped having the hard drive plugged in to hopefully stop the stop the System Restore on that hard drive (and then re-checked the System Restore tab)
View 12 Replies View RelatedI turned the PC off to reboot when I though I was going into safe mode and went into regular mode instead. Now, it thinks one of my external drives is the C drive. On boot, I am getting a message that it cannot recognize find the system 32 windows config file (I'm paraphrasing).
I used the repair utility to get to the C prompt (which is pointed at the external drive) and checked the drive letters. I don't think the PC bios knows the hard drive is there.
I tried going into setup and reverting to factory installed configuration and that didn't change anything. I could not get it to recognize the hard drive.
I'm connecting a 30GB Travelstar Hard Drive via an external USB 2.0 case to my Thinkpad T40 with Windows XP (pro). Windows immediately recognized it. However, the hard drive does not show up under Windows Explorer. I can go into Device Manager, click on Disk Drives, and it does show the new drive there (along with my main hard drive, which is a 80 GB hard drive).
I cannot figure out how to make it show up in Windows Explorer with an Drive Letter assigned to it and thus, how to actually use it.
My USB External Hard Drive suddenly decided to stop working monday before last, it is weird, like it will turn on and all, but it doesnt get recognized and while its on none of my programs will load like Ventrilo and games(ventrillo will half load but not all the way) and the computer wont shutdown while its on. but the moment i turn it off they all start running smoothly agian and the computer will shutdown immediatly (if i am at the shutdown screen). Any idea why/how this happened and how to fix it?
View 1 Replies View RelatedI want to back up my entire system to an external harddrive and then reinstall windows on the internal one.My question is can I use a program to put programs back on to the internal drive from the external harddrive. I heard ghost copies everything even registry is this true?
View 10 Replies View RelatedRunning Windows XP home, well-protected from viruses and spyware with all the usual recommended programs. I have a 160G external firewire hard drive, NTFS system. Cannot access data all of a sudden, I am getting an error message, "file system corrupt and unreadable." In disk management, the drive is listed as healthy, 160G, but no NTFS listed. What could have caused this, and is there a way to retrieve the data? Are there any low-cost or freeware programs to do this, or is it inevitable to spend a "fortune?"
View 32 Replies View RelatedAn external hard drive. When it is on & I try to boot,I get the following error : Invalid system disk Replace the disk, and then press any key I then have to turn off the external & press any key to get it to boot. Is there a way that I can boot with that external turned on. Some setting I need to change perhaps? I have an E-Machines computer about 2 years old.
View 6 Replies View Relatedquality of AcomData External HD? Also, is this a well established company? Any info as to how this brand compares to a Seagate External HD?
View 5 Replies View RelatedI have a Dell computer where one of the loading .dll files came up 'missing' one day, so it won't boot. I want to get all the photos and other docs off the hard drive. I had downloaded one version of linux and was able to see the files on the internal hard drive, but was unable to copy them to a memory stick or external hard drive. Now I've downloaded ubuntu and booted off a memory stick... this time, it's telling me that the internal hard drive has all kinds of bad sectors and won't let me access any of the files on there.
View 1 Replies View RelatedI have an HP pavillion xf328 laptop and of late it refuses to boot.I could not sart it in safe mode or any of the other choices offered at stert-up. I finally got tire of it just repeatedly cycling through the first part of the boot cycle so I got out my power max floppy and reformatted the HD. Then I reinstalled XP pro. It worked fine for several start-ups and now just goes to a blue screen. Is hp somehow proprietary on how I have to 'restore' the system?
View 2 Replies View Relatedi need to knwo what it is wrong , my operating system will NOT work with my new 80 gb hard drive and i dotn know why , when it reboots from the system install then says"error loading operating system" ive tried a few things but im looking for more ideas, if you have any clue what it could be please reply, it cant be my memory cuz i have 384 mb ram
View 14 Replies View RelatedI have an 8 month old Dell xp system and have just caught something nasty. I cant do a sytem restore, dl/run any software tools, and its so slow that the system is pretty much useless. Dell says that they think it is spyware and they can fix me right up for just $49.95. I think I have everything I need backed up, so I was thinking about wiping my hard drive and starting over for free. Could someone walk me through it? Then, could someone point me in the right direction to keep this from happening again.
View 14 Replies View RelatedI understand the need for system restore to be enabled on the C: drive. But should it be enabled on the d: drive/recovery partition?
View 1 Replies View RelatedI am cloning my existing hard drive in my laptop (sata) to an external hard drive (pata) in preparation for installing a new larger hard drive (sata)in the laptop. Can I, or how do I transfer the cloned data from the external (pata) to the new internal hard drive (sata)? Thanks in advance and I apoligize if this is a rudimentary question as this is my first time attempting something like this.
View 6 Replies View RelatedI just installed windows service pack 3 and now I'm having trouble with my external hard drive. when I go to My Computer, and click on it, it says it can't be accessed because of an I/O error. It's a Western Digital MyBook.
View 10 Replies View RelatedWe have Windows XP Home Edition 80 GBCan we copy entire hard drive to an external hard drive?
View 36 Replies View RelatedI've connected an external USB drive, but when I go to My Computer it shows it as a network drive. In addition, it gives it the same name as the mapped network drive that already exists there. When I change the name of the external drive there, it then changes the name of the mapped network drive, so again they both have the same name, although the drive letters are different. Any ideas how to make the external drive appear where it belongs in My Computer, under Hard Disk drives?
View 8 Replies View RelatedI have a usb external hard drive. Can I install windows os on this drive and use it.I am told that windows must be installed only on main hard drive 9i.e. drive 0).
View 10 Replies View RelatedRecently, my motherboard fired, but the Hard drive was uneffected. Since i had a lot of info on the hard drive i tryed to find people who could take the info off the hard drive for me. I then had this great idea of just putting my hard drive into a "Hard Drive Enclosure Kit". Well, i did that and it worked great. But theres one problem, I can't seem to get into the Owner folder of the hard drive, for evey time i do, it brings up.
View 8 Replies View RelatedI just recently purchased a 100 Gb laptop hard drive together with an outer case and a USB cable. I just wanted to upgrade my laptop's hard disk, by first making an image of my current drive into my new one through the outer casing. The thing is when I connect it to my laptop, windows cannot detect it. Whats wrong with it? Is there anything I have to do?
View 9 Replies View RelatedI recently downloaded some drivers as I was trying to install a new printer who's software would'nt load. This did'nt solve the problem. I decided to get a printer that I had had before, Brother DCP-110C as I knew this had worked well. I tried to install yesterday (28th July) but could'nt and my PC keeps switching itself off near the end of the installation. I then thought I would use System restore to go back to a happier time when I had the first Brother printer. previous saved point wont let me to restore
View 4 Replies View RelatedI have followed the wizard for system restore but having set the date and pressed next nothing appears to happen. How long should it take? I have tried this in safe mode as well
View 1 Replies View RelatedI am unable to acess any of my or XP's restore points. When I went to restore to an earlier date. All appeared to be going as it should. However, when I got to my profile a message window came up that said unable to restore to (chosen date/time) etc. I chose 3 other restore points over the last month, thinking it might be some recent problem, still a no go. Any help would be greatly appreciated? Is there a utility to use to check and see if there is something corrupted?
View 7 Replies View RelatedI'm trying to do a system restore without success. It goes through the motions but after it restarts always say "cannot use restore point, no changes have been made to your system". I'm trying to correct a font setting change that happened without my knowledge.
View 13 Replies View RelatedMy problem is that I am trying to use a 60 GB ATA / 133 Maxtor DiamondMax Plus 9 Internal Hard Drive as an External Drive as a Slave and I am having trouble getting my bios to recognize it.The Hard Drive is hooked up in the same way as an Internal SATA DVD burner setup as an External DVD Burner that is running on Windows Office XP 2003 and it works fine. So what suggestion would you give me so that I maybe able to get the bios to recognize this drive?
View 2 Replies View RelatedFound some very useful info on here so decided to sign up and post a recent problem i encountered with an external hard drive. the hard drive has a capacity of 80GB and came from another pc. there was a 25/55 partition already on it from the old pc. i tried to delete the partition that was 25gb. now i can't find that 25gb at all. when i plug it in to the usb slot i can only see the 55gb partition it used to appear as 2 hard drives in my computer and nothing else. when i use disc management to format it i only see 55gb.
View 2 Replies View RelatedTo anyone that might be able to help... I've had this external hard drive for a long time and I haven't been able to access it to store lots of music and videos on. My computer sees that it is there, but like I had said earlier, I can't use it. It won't let me see it unless I go to Device Manager. My computer is getting old on me and it's been places most labtops shouldn't have gone... Once in Purgatory, and now, it's on Hell's surface. I get the safely remove hardware icon down by my clock, but I don't want to remove it, I want to use it. I want it to show up in my drives so I can instantly see how much space I have left and what not... I went through the Troubleshooter, tried every possible way that I can think of, the ways the troubleshooter.
View 2 Replies View RelatedI have a Sony VAIO desktop running Windows XP. I purchased a Comstar 160MB External USB2 Hard-Drive and installed it. Since Windows XP is supposed to have the drivers that are necessary, no driver disk was included, and none was needed.The problem developed when my Windows XP began to give me problems later. I had to re-install Windows XP. I did that, and I downloaded all Windows XP up dates (including Service Pack 2). Now, this Windows installation does not install the external hard-drive. Windows recognizes that there is "a USB2 device," but Windows states that there are no drivers and asks me to furnish them.
View 2 Replies View RelatedI'm partitioning an external hard drive that's connected to my Win XP machine. I set an 80GB partition for XP (NTFS). When I tried to allocate the rest of the drive as a FAT32 partition (for my Win98 machines), FAT32 was not an option, until I reduced the partition size to 20 GB. I'm using XP's Disk Management. Is there a maximum limitation of FAT32 partition size?
View 8 Replies View Related