I have got a problem with formatting my PC. Everytime I try to fromat it, it gives me a message (Setup was unable to fromat the partition. this disk may be damaged. If the disk is SCSI disk, make sure your SCSI devices are properly terminated).
But i have tried about 6 different hard disks but still giving me the same message.
Somtimes I am able to fromat it but when the system does the first reboot after deleting the files, it starts the whole process all over again
I've been looking all around the internet for 2 months for my answer, yet I haven't been able to do this. It seems simple to me. Why can't I find an answer for this question...How do you re-format the C drive?It seems at least simple to me. That's all I want to so. I have two paritions, C and D. C is my system partition, and install Windows XP Pro on it. That's all. In XP setup, it will not let me format it, so to me in theory, I'm at a dead end. So I've installed XP on the C drive three times, all in the same folder, and now it has taken up 10 GB (why?) of space when it only should take no more than 4.
Over a year ago when I setup my new system and before installing most of my APPS, I backed it up to a small HD. My Win Xp Pro MCE 2004 has become a little buggy (MY FAULT).How would I copy or clone the smaller HD over to my 80GB drive AND maintain the larger partitions? I have Ghost 2003 but I'm not sure if it permits me to set the partition size when copying HD's.
I have a system which was initially set up a while ago as a dual boot, Win98SE/Win2K. I had a need for the Win98SE side of things then, but now that has gone but the Win98SE partition is the boot of course.I want to be able to do away with the Win98SE partition completely and ideally add the space to the Win2K one, maybe leave it as a clean NTFS partition if that makes things easier. This would mean that I would end up with a drive with a single boot partition holding Win2K. This of course is not a trivial process as the drive letter of the boot partition will need to change. (I do want that drive letter change incidentally).
I have loaded the CD and have gone through the instructions just like others have suggested, however, the process will not allow me to delete the partition because it says it, "contains temp files that are required to complete installation". This is not allowing me to remove the partition, so I can reload XP and start from scratch. The partition obligates my whole hard drive, so I am unable to add a new partition. Additionally, I tried to format C: using the repair menu and DOS prompt without success
I turned on my laptop and got the following message: "Windows could not start because the following file is missing or corrupt: WINDOWSSYSTEM32CONFIGSYSTEM You can attempt to repair this file by starting Windows Setup using the original Setup CD-ROM. Select 'r' at the first screen to start repair." My problem is that I'm unable to location the original Setup CD-ROM. Can this CD be ordered from the manufacturer? Also, whenever this Setup CD is required to repair, will My Documents be effected?
I am running: Windows XP Home Edition SP3 Pentium 4 2.0 ghz 512 ram ATI 8500 32.7 Gig HD Spac I keep getting error message "set up is unable to find a HD location to store temp files. Make at least 898KB available. What setting should I use and where is this setting?
I have been using this PC without any problem for 6 months. I wanted to reinstall my Windows XP on my PC and tried to booting up with a bootable Windows XP_SP2 Prof CD(first boot is CD ROM). But to my surprise, the setup process in not taking place. I am getting a grey blank screen(instead of windows setup screen) after this message "Setup is inspecting your Computer's Hardware configuration".This is the case only with the Windows XP bootable CD. I have tried to boot with different WinXP CDs, but of no use. However, I am able to boot with Win 98, Win 2000 and even with Win 2003 via boot CDs.I am suspecting whether there is any problem with the motherboard, as I was able to install Windows XP Pro before on the same PC.
When booting from an old Windows 98 bootdisk to install Windows XP (with slipstreamed SP1) I allways got this message: "Setup was unable to copy cdrom.sys".The problem was known at Microsoft (knowledge base) and they even got a solution for it (dude!).In the config.sys on your disk there will be a line somewhat like this: "device= /d:cdrom" simply change the cdrom to something else like : "device=..... /d:DVDRAM" and it will work.
1. When I try to run the Network Setup Wizard, I get an error at the very end that Windows was unable to complete the setup 2. When I select Windows Firewall from the Control Panel, I says that it cannot start the service 3. When I select Network Connections>Local Area Connection>Properties>Advanced (tab) it says that it cannot display some of the properties of the connection because WMI information may be corrupted 4. When I try to configure my Intel network adapter, it says that it "failed to load a network component" 5. Also, this is not related to networking but the Windows Updater has failed to install every update for quite a while now.
On my laptop I have Windows xp Media center edition and I want to reformat the hard drive and reinstall Windows xp Media center edition. The problem I have is I don't have a disk for it. The Windows xp Media center edition is on the D drive (HP recovery) Normally I seen it on the bootup menu ( hit a key to recover) but it is no longer there. Also if I go to my computer and hit the d drive it tells me I can't get on it because its the recovery partition. What can i do to get to that partition?
My friend and I took both of our old computer and combine them so we could have a small end gaming computer. Previously on the Hardrive was installed Windows 98 but we reformatted the Harddrive and are trying to put Windows Xp on it. We went through the setup with a series of from my HP System Recovery CD's (7 Disc's). Which installs Window's Xp, we went through all 7 CD's and at the very last CD when the installation was about complete it says "Unable to locate/create user partition." I have no idea what this means...and everytime we boot up the computer it just trys to do the Hp System Restore again but only goes as far as the unable to locate/create user partition.I'm not real sure what I should do...or how I can get out of it.but if theres anyway possible just to reformat again since I can't really get out of it can you please tell me how!
I am trying to do a repair on IE 6.0 but I cannot get into windows add remove programs. I keep getting the error posted in the subject line. It tell me to contact the system admin. I am the Admin. I am running XP home with sp2 installed. The trouble seemed to start when I unistalled Mozilla Firefox!
i tried to reinstall windows Xp and a error came up saying unable to start the partition . then when i press ok on the error it reboots my computer. i cant reinstall my computer
When I go to disk management and right click on the c drive,I do not get the option to add a partition.I disconnected from the wireless network same negative result. Started in safe mode and signed on as administrator and still could not create another partition.
I installed PM 8.05 and used it to resize C drive (WinXP OS is there).I used the auto function to take a 1Gig amount each from drives D, E and F (about 25+ plus Gig free on each of these on a Seagate 120Gig HDD) to add to the 1Gig of free space on the C drive. The PM process seemed to go OK (went into DOS(?) and went through 7 steps to resize, etc) as there were no error messages. It said at the start it was going to do FAT 32 which is what I had the drives set up as. At the end PM said it was going to reboot and then the fan was hit. The boot up stopped at the "DMI Verifying Pool Data" message and the little line cursor just sat there blinking.
I have a HP laptop that once ran on Vista. This summer before I left for college,I decided that it was finally time to downgrade to XP,seeing as I had backed up everything, and classes would be starting in a week.So I did the usual thing. Insert CD, restart computer,"A problem has been detected, and Windows has shut down...."Blue Screen of Death. The Stop Message: 0x0000007B (0xF78D254, 0x00000034,0x00000000,0x00000000)
When I try to install Java, I get the following error message:Error 1304.Error writing to file C:Program FilesCommon FilesJavaUpdateBase Imagesjre1.6.0.b105 patch-jre1.6.0_05.b13launcher.exe. Verify that you have access to that directory Well I go to that directory and double-click it, and I get the following messsage:Windows cannot access the specified device, path or file. You may not have the appropriate permissions to acces the item.
i have a acer t135 sempy 3300 w/ xp home,Ive tried to convert partition to ntfs its set as this 72.6 fat 32 on (c: ---and 73.4 ntfs on (d: i had a copy of partition magic from a guy at work but when i tried it i wiped hd and had to use acer restore discs
I have a P4 550 running XP Pro.I'm trying to reconfigue my drive to use all it's disc space, I have a'Type 77' partition that is 7.6GB that I can't seem to do anything with.Partition Magic 8.0 can't seem to format it, convert it to NTFS, delete it ,or any other operation I try to apply to it.I've reformatted this drive 4 times now and the 'type 77' partition always remains.It does not have a drive letter, PM 8.0 lists it as Local Disc [*:]
Hi,when I go to Control panel>add or remove programs>add/remove window components,I get an error message saying"setup was unable to open information file sidebar.inf"
I've setup Windows 2003 fax services on a W2K3 server and shared the device. I've tested faxing from Word on my PC and it works fine.However, when other users try to install the fax client, the setup hangs asking for the fx* setup files. I've tried different XPSP2 CDs, copying the files to a local directory, making sure that the users have local admin rights (and even domain admin rights) but to no avail. The files are already in the system32 directory so in theory the setup doesn't even need to copy them. Even if I delete them, it doesn't work.Our corporate SMS team reckons that there isn't any policy which could cause the problem.
I started an upgrade for xp pro part way through the install I got a message "WatchDriverSigningPolicy.exe" no found I pressed enter then got another message "fake setup call himself instead original "setup.exe" ; setup abort!" now each time I reboot it starts to load xp then gives me the same message then press enter it then reboots.
I mistakenly launched XP Setup and want to know how to stop it from progressing further. I have another XP installed on another virtual disk. Rebooting from there allowed me delete the Setup files. Or so I thought ! The main XP installation however continues to try to launch Setup. Just about whatever I do, it ends in tears. My question is how do I stop XP on this disk from thinking it has to launch Setup? I dont want to reinstall XP, as that will involve a huge amount of work to recreate my environment.
How do I make the second partition, which includes all files from another hard drive, pretend that it is the main partition? I want to simulate the second partition being my main one for a while.
I have my Windows format disc and I want to create another partition with it. I tried to create one, but it said something like "You have no more space to create another partition because you used up all your space on your Windows primary partition". See, when I reformatted my computer a while back I just created 1 partition for Windows and applied all the space onto that partition.
If there is a way I could remove some space off of my Windows primary partition and create another partition with the space I removed. I want to do this so I can put general things in my other partition such as documents, music, etc. and just leave the other partition for Windows and programs.
What are the steps needed to access one of my partitions, delete it, then use 1/2 the space and apply to system drive and the other 1/2 to another partition?
I bought a new computer.It appears to have been partitioned into a NTFS format and FAT32 format.The default drive for my documents & my pictures etc is the NTFS which I have been using happily. It is Media Centre Edition so I also have a few large files (>4GB) - though I dont keep them long term.NTFS partition has fulled up - but I cant move my large files to other partition to free up space
I've done a little bit of reading but my question is "Should I reformat the FAT32 to make it more of use to me?".I cant really see the need arising to access older OS files, except .JPG's (photo's I had on my old Windows ME Comp) or "Should I move all my smaller files (documents and photo's) to the FAT32 partition and use the NTFS drive for the bigger files?"
I was told to reinstall windows 2000 aon a C800 I was given. I stopped with an erroro reading line 3221166496 hivedef.inf corrupted. Setup cannot continue.
My hard disk arrangement is C(primary partition FAT32)for Windows XP D(extended logical FAT32) for non-os data (movies, pictures etc..) F(primary NTFS) for Vista.. I am formatting F: and then C: through XP installation CD (and C->NTFS from FAT32) is this ok??? will D: be accessible after installing XP on C???
I would like to know if it´s possible to take free space from an extended partition and redistribute it to a primary partition using partition magic 8.0..both partitions are NTFS
