My fully updated Windows 8.1 notebook suddenly will not show any wifi connections when I click on the icon in the system tray (it shows "No Connections are Available", although it is connected, and I can surf and browse normally).
To connect to a new network, I have to manually enter the details of the network, and then it connects. This is something new, since previously it would show all the available networks, and allow me to make a selection (which is normal). What setting could have flipped do enable the above situation?
I just bought a dell xt2 on ebay it came with windows 8 pro. My problem is that it goes into limited connection every ten minutes, even when i am next to the router. The error I get when i trouble shoot is the Default gateway is not available.
Is there a way to setup network profiles or something so that when I bring my Surface Pro to work and connect to the wireless network there it will use the static ip address I have but when I disconnect and then connect to my home wifi it will go back to DHCP? On my MacBook Pro I can go into the network settings and change the location profile I have setup for networks but I don't see anything like this for Windows 8.
I just bought a Lenovo Y500 a couple of days ago and it came with a pre-installed Windows 8 everything seems working fine but when it comes to Wifi it randomly disconnects a lot , sometimes shows limited access and most of the time the signal strength bars keep going up and down.
I purchased a new Windows 8, Inspiron 15 7000 series - 7537 last December. I had been using a router at a hotel for the time, and it worked correctly. When I arrived home, I had a Belkin router, and i experienced network issues in that i could not connect to the wifi. I could connect with Ethernet cable. The problem was fixed through customer support eventually, but I now have a new Comcast router, and i'm experiencing what appears to be the same or a similar issue. I can access the internet fine by wire. With wifi, it says i have access to the internet over the internet icon in the bottom right, but i cannot access webpages. I can use skype, and communicate through it.
Here is the result from the ipconfig /all :
Microsoft Windows [Version 6.2.9200] (c) 2012 Microsoft Corporation. All rights reserved.
C:Windowssystem32>ipconfig /all Windows IP Configuration
I really need the wifi on this router working for this laptop. Let me note that it works on other laptops, so it should be an issue with hardware or settings on this laptop.
I have two wifi APs in the home and only one has an Internet connection. the other is to access the wired LAN.
Last week I updated from Windows 8 to Windows 8.1 and thought everything was going well until I started getting wired LAN dropouts.
I have traced it back to 8.1 handling connection to wifi APs. In Windows 8, I was able to have "Connect automatically" for BOTH wifi adapters on this laptop. Now when I try to connect to the non-Internet AP, Windows 8.1 announces (correctly) "Limited access" and that's what Windows 8 did too. BUT, Windows 8.1 waits a few seconds then drops the connection with a useless message, "how me solve connection problems," where there is NO problem. A limited connection for the AP to the wired LAN is OK as it was in 8.
So now I am stuck with no home LAN access unless I drop the Internet AP and connect to the LAN AP.
Also, in the great wisdom of 8.1, because it is only a "limited" connection, it does not remember the Passphrase so I have to type it in every time. So much for progress.
What to do to get past this behavior and have a "limited" connection as OK as it is with Windows 8?
Since past few days WiFi is not working on my Inspiron N4010 laptop. I am able to connect to internet through LAN cable but with wifi it keeps showing the yellow symbol in the network icon in system tray.
And For Bluetooth , the icon is not getting displayed in the system tray. Even If I am trying to start it with BTTray.exe it still doesnt work. And Bluetooth adapter is off, how to make the adapter on.
I tried installing the latest drivers of network .....
I have a fresh install of Windows 8 on my desktop computer. However I've run into some major issues with accessing my NAS (Media Server/Hard Drive)
#1 - I cannot for the life of me map my NAS as a network drive anymore.
#2 - This the important one, I can't see over 80% of the files stored on my NAS, only the most recently updated ones. I can see them just fine from my brothers laptop that came preinstalled with Windows 8, and no issues whatsoever with other computers on the networks on Win 7. Is this an issue with fresh installs? If so how can I remedy this?
I prefer to keep my home WiFi network from public view by disabling the SSID broadcast, i.e "hiding" the network.
With two modem/routers (a Belkin Play Max F7D4401 ADSL modem/router and now a Cisco EPC2325 DOCSIS modem/router) on two computers (home-built desktop and Acer TM8172T notebook), after the initial connection Windows 8 Pro would not reconnect without tediously re-entering the SSID name and password. Once it does connect, it displays the original SSID name with a new one with an incrementally increasing appended number like:
I was manually deleting them all (except the original) using netsh, until I realized you can <right-click> on an entry in the screen above and choose "Forget this network."
This is the process I go through each time to re-connect. Is there something I'm missing?
I read that if Windows 8 saves too many WiFi connections, it cannot "remember" them to automatically reconnect to them, so on the notebook, I deleted all but wpcTrue (the original), and it now automatically reconnects, although occasionally it will add a new connection with an incrementally increased number -- currently the notebook shows both wpcTrue and wpcTrue 2. I had used the notebook on the road, so had about five WiFi connections saved. On the Desktop my home network is the only WiFi connection I've ever made. However, no matter what I do on the desktop, it NEVER remembers to automatically log on when the SSID is not broadcast.
I even tried manually setting up a connection via Network and Sharing Center > Set up a new connection or network, to no avail -- the desktop computer will not automatically reconnect.
I doubt that this is relevant, but the Belkin modem/router, the Belkin USB adapter I use on my desktop computer, and the notebook's Broadcom internal modem are all b/g/n. The Cisco modem/router is b/g.
If I "unhide" the SSID, i.e. broadcast the SSID, all is well in the world. Both computers automatically reconnect to the modem/router. If I hide the SSID, and then disconnect or reboot, the desktop computer will not automatically reconnect.
I just noticed that the pop up WiFi connection column shows "WiFi-2 Off" -- what does the "Off" mean?
And, why is it "-2" ? My notebook just shows "WiFi', period. (The first image with "WiFi (Off)" was from a previous Windows 8 installation on the desktop computer. I decided to change from EFI-boot to non-EFI so reinstalled Windows 8. I simply used the old image as a quick way to show how the connection name assignment runs away.)
How can i create local WIFI network without having internet access on my pc. This seems to work if I have access to internet but when i disconnect internet connection my PC ( virtual router ) cannot see anymore other devices..
All other devices that are connecting to my virtual hostednetwork are working without any problems expect my pc. What have i missed that my PC where virtual hostednetwork is running cannot see devices in "virtual" network without internet access?
My laptop is few months old HP Pavilion g6 OS: Windows 8 uses a ralink rt5390r 802.11bgn wifi adapter.
The wifi was working just fine suddenly it stopped. It detects my home network but every time it tries to connect ends up "unable to connect to this network". It connects to my friends wifi but not mine. And it connects with cable.
There is a red cross on the wifi network but it's green not GREY. It is not a modem problem because the other PC connects just fine. When I'm on wifi, cmd ipconfig gives me disconnected media for all the network cards on the laptop. Command netsh shows failure and access denied.
What I have tried to do for the past week :
I upgraded the adapter/ driver. My windows is fully updated. I re-installed the network card. I tried a USB wifi. I uninstalled the private server. I uninstalled my Norton because I thought it was blocking the connection I also deactivated the windows fire wall. I changed the SSID and PSW ... nothing worked. and of course I tried restarting, resetting, rebooting, deactivating and activating, disabling and enabling every single thing but nothing works.
I just bought a msi s30 laptop yesterday. So everything went fine when I test the wifi connection before I go to sleep. When I say fine, I mean I could connect to the internet. Then when I woke up this morning, I turn on the wifi but it says "no network found". I check the router and it is working perfectly fine. I also checked the device driver and its also working properly.
Windows used to show all nearby WiFi hotspots in the same way that my phone does. You could also "rescan" to do a better job of seeing weak ones.
I don't know how to do this on my Win 8.1 Update1 desktop PC.
It just seems to show my own 2 connections and not all the 10 or so I see on my phone. I left click on the bar graph in the N.A. - a blue bar pops out from the right but it does not show all the nearby connections.
What algorithm is it using to make this selection? How can I control that? Do I have to buy an "app" or a program?
just got a alienware 17 laptop and i installed windows 8 on it.
now when i go to connect to the internet through wifi like i normally do it cant find any wifi signals and says i have no network adapter driver? i tried using a Ethernet cable at work with different internet and when i plug the Ethernet cord in it doesnt do anything and still says no connections at all
btw ive tried updating it through the files on my computer and it says its up to date, used troubleshooter everything. nothing worked sadly
My girlfriend recently updated her computer from Windows 8 to 8.1 Since then, she's been unable to connect to her home wi-fi. She can only connect via cable. Unfortunately, neither of us have disks to roll her back to Windows 8.Yesterday she brought her computer to my house and it connected to my wi-fi with no problem.
I updated her adapter drivers to Windows 8.1 but that had no effect on her ability to connect to her home wi-fi network.Last night she ran "troubleshoot problems" and it says that her adapter is damaged. I highly doubt that since the computer is only a couple of months old and she could connect to my wi-fi network.
Recently upgraded my laptop to Windows 8.1 and I cannot see any 5Ghz wireless networks, even though they are present (I am able to successfully see and connect using other devices including a Windows 7 laptop). I can see 2.4 Ghz networks and connect no problem. I have upgraded the wifi driver to the latest Windows 8.1 version for the Intel Wireless-N 7260 card, v220.127.116.11 but no luck.
For some reason my windows 8 Hp will not connect to my home wifi network. Has had no problem connecting in the past but yesterday I unplugged my router to move it to another part of my house and ever since then it can't connect. My cell phone and other laptop connect to the internet no problem.
On my Hp it will show a list of wifi networks and my home network is on the list, however, when I try to connect to it and then troubleshoot the problem it says I can't connect to the network because it is hidden. I don't see how thats possible since the network name shows up on the list of nearby wifi networks.
What I've done but hasn't worked: Reset my router and laptop multiple times. Tried to manually connect to network. Forgot the network on my laptop and tried to reconnect.
I don't understand how one day it can connect to the wifi fine and then I unplug it and all of a sudden it can't connect but my other devices can.
Windows 8.1, Broadcom 802.11n network card&driver,
My computer stopped recognizing the wireless networks at my university - oddly enough, some other networks elsewhere can be found (although I cannot test if I can actually connect to them, since they are passworded/not mine).
I followed the 3 steps of Network Posting Tips
Xirrus Wi-Fi Inspector showed nothing: Connection - Broadcom 802.11n network card - NA, everything under Wireless and Addresses also NA. No networks.
I am running Windows 8 Home Edition. On a HP DV6-7250CA.I have a Intel Centrino Wireless-N 2230 Card.I also have several other laptops and desktop all connected to the same router. For some reason, randomly my Windows 8 HP laptop turns of my wifi internet access just on this laptop, then when i try to reconnect, it says unable to connect. The only way I can get back on line, is if I go to device manager, and disable and then reenable my wireless card.I have tried reinstalling the driver, and it still happens. None of my other machines are effected and run great on wifi. Why just this windows 8 laptop is randomly doing this?
I have the same problem, I used to connect to my collage wifi, which is powered by sonicwall for the past 1 year, but I can't able to connect it anymore from my room.... I use TP link wifi routerTL-WN7200ND...my signals are good in my room buy it not connecting, saying unidentified network... I tried formatting c dive and re installed OS and all, I tried even windows 7, but my problem is not solved, I tried ipconfig cmd command and many, but none of them worked for me.... I forgot tell something, I can connect to the proxy from a 10 rooms after my room,with the same signal strength... but not from my room....
I'm in Window 8 on a Toshiba L855-S5112 Satellite laptop. It's an inexpensive laptop, which was most likely my first mistake.
But... My wireless sees nothing, and when I check the device manager for the network adapter info, it's enabled and it reports that it's working fine. the wifi switch is definitely set to on. With "show hidden devices" turned on, this is what I see for network adaptors:
Recently I have upgraded my Lenovo G580 laptop from windows 8 to windows 8.1. After up-gradation Wifi is stop working. I have checked the WIFI device driver(Broadcom 802.11n) in device manger and it is showing working fine but in the Networks section the Wifi is showing disabled.
I am attaching the screen shot of the device driver property and the my network panel.
Im looking for a way to have wifi access per user for example one user can have access to wifi while another user cant have access. (Currently Using Windows 8)
In Windows 7 I used this method (Profile types) to allow wifi per user and it works great. How to Enable User-Specific Wireless Networks in Windows 7 But in Windows 8 I cant seem to set wifi access per user.