I just reformatted my hard drive using Windows XP re-installation CD. After successfully formatting and installing xp, it goes to restart to continue with the setup. Once it starts to boot it says that press any key to boot from cd but I don't do anything cause it's not supposed to so it try's to boot from hard drive but says: Disk read error Press ctrl + alt + del to restart. I don't understand whats up. I had Windows 7 installed before but do to unfortunate circumstances I have to install XP for now, but I can't complete the installation.Priority Boot Sequence:1.CD 2. Hard Drive.
window loads, sits, finally other half will load, mouse just doesn't seem to do anything so you click again and 3 minutes later 2 of whatever will finally open... just annoying crap really A few days ago comcast went off and I had to unplug modem, wait, then plug back up and restart system. I got a "Disk read error press control, alt, delete, to restart" error, tried that same thing so I shut down and when I turned back on it booted fine. I have since moved... just set up the system and am getting the same error except this time shutdown/restart isn't working ( The OTHER problem I realize is this... this is a tempory move! Most everything I own is in a storage unit, boxes to the back, furniture to the front and guess where my disks are? Right! I put printer, shredder, disks, everything I didn't just HAVE to have in the storage unit.
I've started getting "a disk read error occurred press ctrl + alt + del to restart" on my nearly new alienware bot. i have to use power button to turn off systm, then turn it back on to get it to work.
Upon starting up a Gateway LX laptop, I receive a "A disk read error has occured, press CTRL + ALT + DELETE to restart." Instantly, I know this is bad. So I load in the Windows XP Home disk and boot from the CD. I go to repair and recovery and the console opens up. I run chkdsk and it stop at 13%. Any suggestions. Is the hard drive done? I have backups, I'm just wondering if it's time for a new hard drive.
I've been trying to rebuild my friend's PC for ages now and every time I get past the initial part of setup (boot from CD, create partition, copy files, reboot) I get this error message.I've done everything I can think off:I still get the same error message when I replace the hard drive with a new one.And I've read about a billion articles about this but none of them have the same solution.
Custom built system, Primary IDE connects to HDD Hitachi, Seconday IDE connects to Master DVD Burner 1.I opened my case, put in a 2nd DVD Burner in on Secondary IDE Slave. Fired the machine up, and the entire Secondary IDE fails to pick up both DVD's.I put it back the way it was, I swapped cables, ran the HDD from secondary IDE, tested the DVD's on the Primary IDE, and my conclusion is that I've somehow damaged the Secondary IDE from picking up any device.Now I am running the new DVD burner as Primary Slave and the HDD as Primary Master, I boot up and get
When i boot windows XP i very often get a A disk read error occured. Press Ctrl+Alt+Del to restart. Does anyone know what is the reason for this? It boots successfully around 30% of the times i try.
I trying to help a friend with their computer; Dell Dimension 4700, XP Pro, and getting the error message: A DISK READ ERROR OCCURRED. PRESS CTRL & ALT & DEL Does this mean the hard drive is bad?
I've spent about half the day building my new PC - a Windows XP Pro 64-bit box. I've installed the hardware and it is recognized by the BIOS on my Gigabyte PE45 UD3L motherboard.. The next step was to install the OS, a 64-bit version of Windows XP Pro. All went well until the installation program prompted me to reboot. I received the message: "A disk read error occurred. Press Ctrl+Alt+Del to restart." I've done this four or five times now, with and without the installation CD loaded. If the CD is loaded, the installation program tries to copy the files to the hard drive all over again. I went along with this once, thinking maybe the first time some driver had been corrupted. I have also changed the boot order in the BIOS, with first boot to the HD. I have reset the Fail-Safe Defaults in the BIOS. There are two hard drives in the PC, 320GB SATA Western Digitals. One of them has not been partitioned; the other was partitioned by the Win XP installation program.
my Toshiba Satellite M110 recently froze, crashed, displayed the blue screen (beginning dump of physical memory). i restarted the computer, but it suddenly displayed: Read Disk error. Press Ctrl + Alt + Del to restart.I talked to Toshiba Corp. Australia, but they said i had to bring it in to be repaired, or backed up, then a system restore. my dad has a technician friend, who will be able to back it up... but is there any other ideas? i mean, this might sound rather random and deranged, but does anyone here know how to open up and remove a HDD (hard Disk Drive) from a Toshiba Satellite without blowing anything up? my dad's tech friend has a laptop USB HDD Caddy, but i just need to well yea. i have the recovery disk and know how to recover, so i got that bit covered, just the removal of the HDD before 2nite and safely too. other wise i can just get my dad's tech friend to do it.
In a little bit of a situation. My laptop is not loading up, after about 20secs it states "Disk read error occurred- CLT+ALT+DEL to restart.But it just happend again and again. I've been reading around and everyone is saying just use the xp install disk to repair the master boot, problem is I have moved that many time is the past 2years I have no idea where that CD is.I've downloaded DiskInternals Boot CD and it will start on this. But it wont actaully repair the disk, just scan it I've used diskcheck via cmd on the boot cd but it states there is a master boot registry failure.
My computer has recently started giving me an error message that says "A disk read error occurred. Press CTRL-ALT-DEL to restart." during startup. The first time this came up I took it into the repair shop the morning after. They turned the computer on, it started normally, and after keeping it overnight they returned it to me saying that they could find nothing wrong with it.It worked normally for about 2 days after that and then when I was using it the system suddenly became unresponsive. I was forced to turn it off via the button on the front of my tower, and when I turned it back on the disk read error message came back up. The next morning when I turned it on it was fine.
I am encountering this error when copying a large number of files from one external hard drive to another. I have Windows XP. A number of files will copy prior to the error occurring. The error occurs when the copying process reaches a file that my Trend Micro security software had identified as a virus and had quarantined. Instead of simply skipping the file that cannot be copied and moving to the next, Windows Explorer displays the error "Error copying file: cannot read from source or disk" and aborts the copying process, leaving the copying process only partially complete. Copying each folder or file individually to avoid encountering the error would be very time consuming.
on winxp pro machine. PC will not start in safe mode and i will get "disk read error" push control alt delete.does this mean hard drive is dying or dead..
I am having an issue with a Maxtor Model Number 92739U6 hard drive. I have just finished formatting and installing windows xp home edition. Everything was going ok until I restarted the computer. First right after I restarted the computer I got an error message A Disk Read Error Occurred. Press CTRL+ALT+Del. I was unsure what caused this error message so I started to research this issue on Maxtor?s website and they advised me to use fdisk /mbr to repair the error. I did that and restarted the computer. Same Error?. The thing I can?t figure out is why I am able to boot right to windows using a boot disk.
Everything has been fine with my 3 and a half year old ADVENT PC, and I've been successful in upgrading parts such as DVD Drives, adding extra RAM and installing my new graphics card.However, in the past few days, when I boot up my PC, it stops at what I believe the DOS screen (part with BOOT FROM CD etc.) and will say A Disk Read Error Occurred. Press Ctrl+Alt+Delete to restart. This happens 2/3 of the times I turn on the PC.Also, if I do press Ctrl+Alt+Delete and the PC restart, it is normally successful, and will boot up Windows perfectly. Just this morning, it gave me the error, and with 2 Ctrl+Alt+Delete restarts, it's working perfectly, hence I can type this.
A Disk Read Error Has Occurred Press ctrl alt del to restart I keep getting that message when i turn on my computer its been like that for the past few days. Im Using windows XP Bell system optiplex 170L series Bios version A07 I can access the setup menu and the boot menu but idk what to do. im a computer noob.
A Disk Read Error Occurred. Press CTRL+ALT+DEL to restartThis is what my compaq lap top is saying upon restart. Using XP, I do not have any recovery or diagnostic disks.I have a new laptop and was using the compaq as a back- up. I hadn't used it much in the last month or so and when I turned it on, it was unusually slow.I attempted to defrag the hard drive, and it initialized(after it analyzed). During this time windows shut it down for an update to take effect. Upon restart, this is the message I got: A Disk Read Error Occurred. Press CTRL+ALT+DEL to restart.
I'm running Windows XP on a EMachines PC. The PC is only a little over a year old. Suddenly tonight I have what appears to be a DOS screen that says "A Disk Read Error Occurred. Press CTRL+ALT+DEL to restart". After doing a ctrl alt delete, I keep getting the same screen again. Can anyone shed some light on how to restart my PC? Is the hard drive shot?
The pc normally runs when i open for the first time and when i restart it shows "a disk read error press ctrl + alt +del to restart " at booting and when i do the same it shows me the same error again... i have to power off whole my system and then have to on it again... cannot restart.. please help ... and also i am not getting the dvd drive option shown at the selection of boot, means at 'to boot from where' ... instead it shows the cd drive which is not connected.
When I start up, I get a black screen with this: Disk read error occurred Press Ctrl+Alt+Delete to restart So I do. Same thing happens. I don't have any CDs or anything in the drive. The computer had also been shutting down randomly on me prior to this.
I am trying to update my EVGA 7800GT's BIOS as well as my motherboard's. I have done this a few months ago, same disks and everything.When I create a floppy with the required files and restart, I get the following message:"Non-system disk or disk error. Replace and strike any key when ready."
i recently attempted to format my computer as it was going very slowly, i did the usual process of inserting the recovery cd's which came with the computer however this time the process did not complete, i left it for over an hour and the screen still remained the same. I decided to restart the computer and a message keeps coming up, disk read error press ctrl alt delete. I tried formatting again but all i get is a blank screen even before its begun, i tried using windows xp cd's
I have a P4 HT (old one) I formatted its hard disk using another comp to install a fresh copy of WinXP but the bootable XP is unable to start as there is a "GRUB" message that is last shown and then nothing happens.I have only 1 drive attached to this comp which is this one.it is running in a slave mode(doesn't matter as its the only default drive for the motherboard to read, and i have lost my jumper pin so thats y it is running in a slave mode.)What shd i do abt this "GRUB" message and how shd i go about installing WinXP ?
I usually backup my weeks work on Friday afternoons. What I do is run a "search" for all files created or modified within the last 7 days and then "copy" all relevant files to a folder on an external hard drive, and then burn a CD.
Everynow and then, I get the following message. "Cannot Copy File: Cannot Read From the Source File or Disk"
Computers a few years old its a Dell gx110 and it wont start , it will get past the initial loading screen but instead of going to my accounts page a message says that "a disk reading error has occurred" or "cannot find disk drive one" ive tried a few things but nothings worked
Just turned on my comp and when it got to the part where it says 'Verifying DMI pool data'It says 'A disk read error occurred' then asks me to ctrl-alt-del I did that and I keep getting the same message. I have win XP pro. I tryed to start it with the XP pro disk in.
I am running XP Pro and trying to install a games disk for my granddaughter, the disk works on another computer running XP Pro but not on mine it won't even show up in my computer in the D drive just tells me to insert a disk I have tried going through run to no avail, all other disks work
XP home-- CDROM will only play Shadowbane game disk--any other disk pop up window --install CD--comes up. Also had window I/O device not acessible pop up. used windows troubleshooter had RED Triangle pop up.Malevalent program installed
