I am using a Peak dual DVB-T tuner card with Windows Media Center 64bit. I receive my digital TV signal from an attic aerial. My problem is that I get corruption on video and audio while recording with WMC. The video corruption is hard to describe but looks like vertical streaks down the TV screen making programs impossible to watch. The corruption does not happen all the time, but usually starts after 30-40 minutes into a show. I have checked aerial connections etc and have recently reloaded windows 7, but with no improvement. I have no problems whatsoever while veiwing normal TV or internet TV etc on just the TV itself. I haven't filled in system specs in my profile as I have 3 different PC setups and wanted to try get some help asap, (this is my first post). The problem occurs on a HTPC with an Asus HD55M-pro motherboard, an Intel I3-530 processor, 4Gb ram and a Samsung F3 1TB with a partition for system and the rest of drive for storage. This is using Intel intregrated HD graphics on the CPU cabled to a Sony LCD TV via HDMI lead.
I recently purchased a Media Centre PC with a Compro E750 Dual Digital PCIe HD TV Tuner. When I record a TV program I get large blocking in the picture and it is difficult to watch. I have a clear picture when normally viewing TV and when viewing TV programs from web sites.
I have added the library for recorded tv and verified that the scheduler service is running. When I select a show for recording, it seems to accept it and shows the red dot in the guide, but when the show time begins - it doesn't record. Record worked before the recording drive failed and had to be replaced.
I'm in grave problem here. I just installed windows 7 x64 a few days back. And initially I installed the 32bit version of k-lite codec pack for my windows media player. The media center worked fine then. It was loading my ffdshow and ac3filter along as I checked it.But then yesterday I noticed that the same pop-up od recommended/express install of WMP came again. Initially I thought that it must be some bug or something, but then when my MKV and AVI files didn't work in WMC, I realized that somehow WMP x64 got triggered, and now it is using the x64 bit of WMP in WMC. And I just wanna revert back to 32-bit WMP in WMC.
I can't get eithe WMP or MC to play a DVD. I've set the region code. WMP acts like it will play, but then just goes blank, and MC says it cannot play the DVD. These are original discs, not burned copies. I have a custom built system, with 2 graphics cards (GTX 260 and a GT 220) 6 GB of RAM, and an i7 processor. Any help would be greatly appreciated.
We just had a Dish Hopper installed and tried using their Home Media program which looks at Windows Media Player for music. I can play the music from 2 of my 3 computers but the 3rd one won't play.I checked the 2 computers and I can play the music from there.When I try the 3rd computer I get: The file you are attempting to play is missing or corrupt or not in a location that is currently not available?I removed WMP and had to "turn Windows Futures off" and WMP was available, the problem is it is still linked to the corrupt files.How do I remove the corrupt files and direct WMP to the correct location?
When I open Windows Media Center - Internet TV is listed.On the windows website it shows that I should have that option.So, I assume I don't have something set up right.I have a TV tuner and I can record and watch TV just can't get to see the Internet TV channels.
I have installed Windows 7 Professional on my laptop and it has Media Center. But I can't see any way to access Netflix. Is Netflix support available on Windows 7 Media Center?
I'm trying to make my wallpaper but when I scale or fit it with desktop personalization it cuts off an important part of it or it doesn't cover the whole screen.I want to take a full screen shot in Windows Media Center but whenever I take the screenshot I just get a black screen and not the screen shot.So it seems it may be a bug or something and I'm not the only one with the problem.I followed those steps and added what they told me to with Regedit but it still didn't work for me. The author in the article says to "restart" media center does that just mean to close the program and open it again? I tried that and it still didn't work.
I am currently using Media Center but was wondering if there are anything better out there. I have alot of MKV files so I would need something that can play those.
I want use a self build pc. The spec are Asus motherboard Intel socket 775 2.6 quad core oc'ed to 3.1 16 gig of 1333 ddr3 ram and a Asus Nivida 9800gt graphic card. Would this system be good enough to run and play tv programs?
I was wondering, if I run an HDMI cable from my computer to the TV, can I run Windows Media Center over on my TV in the background? If so, would I be able to say play a game on my computer while my parents are watching something with media center? (without audio of course) Would I be able to use a remote with the media center running in the background, and still use my mouse and keyboard at the same time(while the remote is being used)?
I am experiencing issues with WMC in combination with Windows Firewall. With the FW turned on I cannot watch live TV and get an event viewer message "WMDRM-ND" Error. Turning Windows Firewall off resolves the problem. As I do not want to turn the FW on and off all the time I would like to know where I have to apply the relevant tweaks so I can watch TV with the FW on.Ideas anyone?
I recently tried to use windows media center to connect to my xbox. I've had my hp laptop for over 2 years now and may have never even used WMC. But whenever I try to launch it, the blue wheel next to the mouse pops up for a second and then nothing. Nothing happens at all.
I've tried going to programs and features and turning off both WMC and WMP, restarting, and then re-enabling them. This has done nothing. I've even gone into Windowsehome and deleted all the files in it and did the disable/enable thing (I did, of course, make a backup of the folder). I looked through the programs and features themselves, hoping to find WMC so I could see if there was a repair option, but it doesn't show up. How can I make WMC work?
I started watching an OTA recording with WMC7 and about 2 minutes into it WMC7 stopped. A message came up saying it stopped & had options to restart WMC or go online (which appeared to send info to MS) and a 3rd option I don't recall. I just restarted & everything worked just fine.
I looked at event logs & found this. I did a search for that ntdll.dll but could not find a definitive answer to what caused the problem. The typical comments were to reboot or reinstall software. Is there anything from this listing that tells or hints at what caused WMC to stop?
I can't open any programs because of windows media center. I tried to access the "default program" which can be found on the control panel but still the WMC pops out and also the regedit in the start-up menu still WMC pops out. All my app icons are WMC. If i open it WMC will pop out. Lastly, I tried to make a system restore but it didn't work because WMC pops out again.
I need to set up windows media center on my sons computer. he has a verizon fios set top box.we do not have a windows media center remote or any IR remote. all we have is the verizon remote for the verizon box.so how can i by pass the stupid IR hardware not connected message?
When I first upgraded from Vista Premium to Windows 7 Home Premium I was able to view a TV movie using Windows Media Center but I had accessed the WMC from a web site.Now I can't find Windows Media Center, even when I press Start > and look in Programs. However, Windows Media Player is listed.When I press Start and enter Windows Media Center in the search field nothing comes up.In Programs and Features there is listed "Windows Media Center Add-in for Flash"
ive added the folders in windows media center id like to share but when i go on my ps3 it says its not registered or something?could we use the media center and ps3 for sharing?
I would like to know how to change the volume level from 50 to 100 in Windows Media Center on Windows 7 Ultimate x64. I have tried to look for the Windows Media Center folder by showing hidden folder and also hidden windows sytem files as well, but no success. Please help me. My complaint is that I want the volume for Media Center to be at 100 because when I use it I can only get 50.
All of a sudden windows media player and center won't play any videos other than mp4s. Could it be related to me installing a new amd driver? The files run good in real player but they look better in windows media player. When I try to open videos with it it will pop up then give the message this program has stopped working. I tried resetting it but it did not work.
windows media center error Description: Stopped working Problem signature: Problem Event Name:APPCRASH
I have the windows media center hooked up with my 360.. It was working fine with the movies... But now it doesnt.. On the computer when i click on movies it says its stopped working... Also it does the same thing on my 360 but says reconnect?
Windows Media Center has stopped working on my dell studio 1749 laptop. When I try to open it tells me that windows media center has stopped working and that windows is checking for a solution to the problem. Well, that's been going on for a month. I've tried a recent system restore, checked this forum and microsoft answers forum for answers but with no luck.Should I try a older system restore? Should I go ahead and use my system image I made last year which was right after I bought this dell brand new? Wanted to try and fix without re-install but if I can't find the problem that might be the only thing left to do.
Last week both my hard drives failed and after buying a new one I reinstalled Windows 7 Home Premium. When I tried to reinstall/set up Windows Media Center the set up got to the point where it was scanning my TV signals for channels and was about 1/3 to 1/2 through when the computer killed itself and rebooted. This happened 3 times at about the same place. Why is this happening and how do I get the set up to complete? I had it working just fine before on my old hard drive but I can't now.. I am now using Total Media 3.5 which works but not as well as Media Center so I would really like to get the set up to complete...
I have a USB TV Tuner which works fine to watch TV in WMC. However, when a programme is set to record, and my laptop goes into sleep mode, I believe it turns off the USB TV Tuner, and therefore the programme doesn't record. WMC support center says that the program is able to record when the computer is in sleep so I know it is not the program which is the issue.