External Hard Drive Reduced Max Capacity?
Jun 11, 2012i do have an external HDD with a 250G capacity... i bought an enclosure then...i think i have this almost 3 years now...i have noticed lately that max capacity is now 150G...
View 3 Repliesi do have an external HDD with a 250G capacity... i bought an enclosure then...i think i have this almost 3 years now...i have noticed lately that max capacity is now 150G...
View 3 RepliesI tried installing 64bit Win 7 Ultimate on mirrored 3TB Seagate HDD using a Digitus RAID card and failed. After the failed attempt, I disconnected the HDD and plugged the primary HDD to an on-board SATA connector only to find its capacity reduced to 750 GB. Windows Preinstallation Environment shows the same size and running clean produced no effect.
Something odd I noticed after running diskpart is that no matter how many drive is connected to onboard SATA, it only shows the 750 GB and the PC name is MINWINPC.
I`m completely stuck with this and cannot figure any solution. Please anyone help me restore the original 3TB size.
My hard drive fills up to within 5 GB of capacity without me taking any action. I run disk check and everything is fine until the next time I turn on the computer and the disk is full again. I ran a couple of malware tools and they found nothing. When I look through the directories I cannot find any huge files. I have the hidden and system files set as viewable. The HD is 300GB and has about 35 GB of real files.
View 4 Replies View Relatedjust replaced my 350g hd to a 750g hd in my laptop. loaded the ghost image and when i open the computer icon it show me the same amount of storage i had before?
View 2 Replies View RelatedAfter a hard drive failure on a 500 GB hard drive, I restored the image onto a new 1TB hard drive.
Windows is showing the C: drive with 224 GB and partition D: with 225 GB.
I'm guessing that Windows doesn't know that it's on a 1TB drive now, so how do I get access to the missing 500GB?
.I didn't wait for the computer to tell me it was ok to remove the drive in the usb port. Now my computer no longer recognizes the external drive After removing my external hard drive (without the ok) my computer no longer recognizes the external hard drive. What do I do.
View 1 Replies View RelatedRunning Windows 7 Home Premium 64 byte. Have a 1 tb external Seagate drive connected with USB 2. Disk capacity is showing 925GB. Have lost 75 GB. Is there a way to recover the the lost 75 GB?
View 1 Replies View RelatedI have an internal hard disk not in use ,and I would like to make it as external disk !I looked on the net and I found I should have the " encelsure " butt I think I wont find it here in my city .So is there another way ? like usb -esata cable
View 3 Replies View RelatedMe and my brother built me a new computer from scratch (he did the building - i did the watching). I purchased an internal hard drive from Overclockers UK. It's a Samsung 1TB drive. I also have a 64 Solid-state drive in there as my primary hard drive that Windows was installed on and a couple of programs are installed on. My storage disk (the 1TB disk) is for all my music/films etc. Whenever I drag and drop a file into the Samsung hard-drive - it copies it rather than moves it instantly.When I had a laptop, I had 3 external hard drives and this is the way it copied files onto them.how I can get the internal drive to stop acting like an external drive?
View 6 Replies View RelatedMaximum capacity of hard disk
View 6 Replies View RelatedI have a USB external hard drive that I keep all my documents etc on (had it for years)I upgraded from Vista Home to & Home Premium then had to upgrade recently to Professional to run my Sage. Through all these upgrades my ext. drive ran fine. Occasionally the drvie letter would change if I had something else plugged into the USB, this was always easily corected in disk management by changing the drive path.The connection on the case packed up so I had to get the drive put into a new case, now when I plug it in the drive is assigned G instead of F, I tried to change the drive letter allocation in Disk Management but it won't let me as the program still thinks I have a second ext. hard drive which is labelled F. I suspect this has happened because when the usb connection broke the drive was disconnected suddenly instead of a proper eject.How do I get Disk Management to remove the inactive drive - i can't find any obvious way - eject, delete etc are all missing when I click on tools or tasks.
View 2 Replies View RelatedLow disk space, Can transfer data on D drive to an external hard drive
View 5 Replies View Relatedtel the maximum hard disk capacity of Windows7
View 2 Replies View RelatedI can see my external hard drive in device manager, but not in my comp
View 3 Replies View RelatedI just got an external hard drive yesterday, and have been asking a few questions on this forum. So far, people have managed to be very helpful with the previous questions, hopefully someone can do so here too.Reinstalling all my games to external hard drive, need to know if they will / how to make them appear / function properly in my GEF, whether added automatically or manually.I am basically going to have EVERYTHING put onto my 1TB external, and by everything I mean "Music, Pictures, Videos, Documents, Games, and maybe Programs". So, I made a folder for each of those things on it,and only now that I am reinstalling my games into the Programs one have I realized something.I am a bit obsessive about having a fully functioning Game Explorer Folder (GEF) with all my games visible in it. It's my assumption that when I install into an external hard drive, none of those games will be automatically added into the GEF. However, if I add them in manually (using the regedit method in the tutorial), should everything function properly, so long as I have my external hard drive on whenever I use the computer?I just need this to be confirmed before I start reinstalling more. Also, if not, please let me know if there IS a way to get them to show up in my GEF properly, or possibly move the GEF to the external hard drive or get it to recognize things from a different directory.
View 6 Replies View RelatedIn order to make upgrading via a clean install easier -- and because I've been considering one for awhile anyway -- I'm looking at picking up a decent external hard drives right now... and can't seem to find a clear answer to something:
Will I see any drop off in quality of playback or computer performance if I use a drive like this (external, USB) to store all of my recorded videos. The tuner and Media center would save everything directly to this drive and play everything directly from it. Would that cause any problems at all? I notice that it requires no power adapter since it's USB powered, and it has a Interface Transfer Rate of 480 Mbps -- not sure how either of these apply to my potential use of it.
if I could use my external hard drive to install windows 7 on a new build with a new hard drive?
View 2 Replies View RelatedAttached an external sata hd with an esata connection. After power boot, external drive not recognized and also secondary internal sata hd not recognized.
Do I need to do something to the BIOS?Sinch stonooka has chosen the best answer to his/her question.Click here to view the answer that was selected.
My windows vista computer died. I have backed it up on and Iomega external hard drive but can't figure out how to restore the information to the new computer which is a windows 7.
View 12 Replies View RelatedWhenever I power up my computer, my external hard drive does not always come on line. I have to unplug and replug it for it to come on line.
View 1 Replies View RelatedI just got a new Packard bell go external hard drive which I used for a couple of days with no problem. btw it has never fell or had any physical damage. I plugged it one day into the PC and it couldn 't be detected in my computer. it shows up in devices and printers and also in disk management. I read on some forums to try and initialize it but it gives me an error saying cyclic redundancy check. I 've tried everything but still not working. this is a new hard drive which has never fell and no physical damage. and please don' t tell me to return it cos it was bought in another country. the only option right now is to fix it?
View 14 Replies View RelatedRunning Win 7 home, acer 1800.About a week ago I installed a Buffalo 1.5 TB external drive and automatic back up package, it was working very well, however it now shows as " Not Connected".I have replaced the usb lead but no change in status.It is also no showing up with other drives?Any one had this problem and found a fix?I did a search but found nothing quite like this.
View 2 Replies View RelatedI have a 2TB Seagate hard drive that keeps dropping out in Windows 7. I use it as my main backup drive and when writing to it using either of the two backup apps I use the drive usually "disconnects" and I have to switch it off and on again to use it.I've tried using a different USB port and a different USB cable - same thing. I have run Windows 7 error-checking checking which reports no errors.When it disconnects, device manager shows that it is still connected and working but it definitely doesn't work. For instance, I can double click and open it but it shows no folders. Switching it off and then on fixes this but only temporarily.
View 2 Replies View RelatedWhenever I try to eject a certain external hard drive using the little icon in the task window, I get a message that it is in use. I am very careful to be sure it is not in use but still get the message. This is a data storage disc. I am not aware of any programs on it that may be running in the background. Is there a way to examine a disc to see just what is being used on it at any given time?
View 9 Replies View Relatedafter plugging in the external hard drive after a while I get you need to format the disk in F:\ do you want to format?After a while throws another warning saying F: is not accessible, Data error (cyclic redundancy check)It was working well until last week but then suddenly started giving this error message.
View 1 Replies View RelatedI've recently spent 2 days indexing an external hard drive and now the index has appeared to have gone, for most of that drive.
1) if I index an external drive and remove, re boot, and re attach the drive, will the index still work for the external hard drive?
2) if the answer to question 1) is yes, why can I not search all but the most recent files on this re attached drive?
I'm trying to backup my data on my laptop to an external hard drive. Windows isn't recognizing it for some reason.
The laptop is an HP running windows 7 and the hard drive is an Eagle Cansus. Using the windows commands in the control panel don't seem to help.
I have been using a commercial company to back up my computer for the last 2 years. Now I have decided to do my own backups. I already did the first back up to the external drive. Now its time to back up again, when I back up again, will everything be backed up again? Or just the files that have changed?
View 1 Replies View RelatedI want to back up files ,pictures using an extrnal hard drive. After researching this matter I'm now more confused. I know what size I want but not sure if I need a Sata or usb or what. Please explain what I need and the difference.
View 9 Replies View RelatedI was using Win XP on my Toshiba Satellite A215 S5818 until yesterday, now im using windows 7, so i insert my Transcend Storejet external hard drive, it was working perfectly like it used to. So i left my lap top running through the whole night because i was downloading something. I get up this morning and my disk isnt working. I was looking for a solution but no use, i tried to initialize the disk with disk management and i get the "incorrect function" error.
I noticed that i have two drivers that are not installed, both of them are "base system device", i tried to upgrade them automaticly online but windows cant find the drivers. The thing is i have valuable stuff on the drive, so i just need the files, i can get rid of the drive right away with the guarantee and get a new one.
Got a Acer laptop with Windows 7 for Christmas and previous had a computer with Windows XP. I had a external hard drive that when ever I connect to the computer it is automatically detected and will come up in My Computer. I went to connect my external drive last night and nothing as happened apart from whenever I connected the computer made a noise that something had been connected but there is nothing in My Computer.
View 7 Replies View Related