1) Can I just add my old Windows XP Pro 32-bit SATA hard drive to my new computer (due to arrive in a few days) that has Windows 7 Home Premium 64-bit installed and set up a dual boot? It would be nice to keep all my programs and files as they are. Or do I have to do a clean install? XP Pro was pre-installed on my 2nd to last system and I have a Product Key.
2) Once a dual boot is setup would there be a way to allocate different memory to each O/S? My new computer will have 8GB RAM and I want to take full advantage of it for the 64-bit O/S, but I understand that 4GB of RAM is the maximum for 32-bit systems and that it is sometimes a problem going that high (so I was thinking like 3 GB for the 32-bit O/S).
3) If I have both 7 64-bit and XP Pro 32-bit installed, will the old hardware like my scanner or a fax/modem card work like it did on my old computer for the new XP boot because they are not listed as compatible under Windows 7?
The reason I want to have a dual boot with XP Pro is I'm worried some of my most used programs will no longer work on the 64-bit system. And I heard the virtual XP is not that great, besides the fact that I would have to upgrade for $89 to get that capability.
I have installed w7 64bit to take advantaqe of the 4GB ram. My scanner and a few progs I use do not work even with compatability mode. On another pc with w7 32bit the scanner and progs work. Would it be possible to install both W7 32bit and 64bit on the same pc either on different partitions or hard drives and use either? If this is not possible and I have to use just 32bit is there a simple way of converting from 64bit to 32bit without totally removing the installation?
I had Windows XP and Windows 7 32-bit dual boot set up on my system. I decided to do away with XP and install Windows 7 64-bit instead. But I can't fully migrate to 64-bit yet as some of my old software don't run in 64-bit. So I clean-installed Windows 7 64-bit after formatting the XP partition. But now I no longer get a boot menu to boot into Windows 7 32-bit. I can only boot into 64-bit. But the 32-bit partition is in tact. Is there any way I can get a boot menu with options to use both 32-bit and 64-bit versions?
Basically i would like to know how to have a dual boot on my PC, where when i start up my PC it automatically starts up the 64bit version of Windows 7 but if i choose i can easily change to the 32bit without a hassle.
2nd Question, if i make a dual boot PC i would have to split my HDD im guessing. If i would split up my HDD and save something while using the 32bit version how would i get the saved file over to the 64bit version? Do i have to use a USB or can i drag it into the 64bit part of the HDD?
I am trying to dual boot 7 64bit and xp 32bit I have 7 up and running on a 90gb ssd and I have two 500gb WD drives in RAID 0 where I am wanting to create a 60gb partition to run xp. I have setup my raid array in bios but for some reason the boot option is grayed out. I installed xp anyway and got it to boot but as soon as I start loading drivers or updates then it crashes mother board is a xfx750i.
I have Windows 7 Home Premium 64 bit upgrade currently installed on my pc, but I am having wireless internet installation problems. TP-Link WN851N adapter (No Win 7 drivers availabe, but it works fine with Linux Ubuntu 9.14).
My ethernet connection works fine.
So as a process of elimination (I am on holidays and heve to much spare time lol) I want to install Win 7 32bit in dual boot with Win 7 64 bit.
I have just purchased a new pc that came with Windows 7 Home Premium 64-bit, which wont run my company software, which was made in 1995, 16 bit. This 16bit software ran fine on my previous pc, which had Windows 7 Starter 32-bit. But the 64 bit Windows 7 version wont run it, I cant use Windows XP Mode on my version of Windows 7, need Pro - Ultimate Version.
I want to install and run the Windows 7 32-bit I have, on my new pc (I still have the installation disk) on a separate partition and keep the 64 bit version to. Is this possible to install both 32 bit and 64 bit versions of Windows 7 and then select which to run when the pc boots?
Im thinking I might regret. I was told its better to build ur own, so I did and nothing but problems! I had vista 64 / xp 32 bit bit and was having nothing but problems trying to get my video cards to work right! So someone told me to get Windows 7 and Ill have no problems. Wrong!
My problem now is that when I turn on the computer it doesn't give me the option to chose which operating system it just loads into Windows 7. Does anyone have an idea on how to fix this? When I hit the (my computer) option it sees Xp as the D drive. When I loaded Windows 7 I just threw the disc in and followed the directions. I didn't reformat anything cause the disc does it for u.
I use VPN-1 SecureClient to connect to my workplace and I hear that it doesn't play well with 64bit Windows 7. So I'm wanting to do all my non-work applications with Windows 7.And then when I need to do work, I'll just reboot under XP.
I am considering getting a netbook through an online company and with it would have installed 2gb memory, 500gb hdd and Win 7 32 bit Home Premium. For various reasons (accessing older hardware on the go etc...) I want to be able to dual boot from XP Pro (I have like 3 unused retail licenses) and the 7 home premium 32 bit that I might also upgrade later. Netbook doesn't come with media. Is there a way to do this? I have an upgrade disc that came with my desktop PC but, it is 64 bit.
I have another laptop and its a HP 2230s. I originally installed Windows 7 professional 64bit. But I have swapped the ram into my Lenovo ThinkPad. So the HP now has 2GB. I created a new partition and installed Vista Business 32bit on it. When I started the install windows .exe program in Windows 7, everything went well until it rebooted. When I rebooted, windows said something like:
Windows Boot manager:
The system cannot boot because of a recent change to files/hardware. (Something like that). Insert your windows disk.
So I just rebooted my laptop with the vista disk inside and installed. After, when everything was working, I wanted to go to the Windows 7 partition to un-install programs and copy some files over to the vista partition, the laptop just booted into vista.
I downloaded the easy BCD editior and visual BCD editor. (in the vista partition), I clicked the auto fix in visual BCD editor. It detected my windows installations. At the boot screen, I can select either Windows 7 or Vista. But when I select 7, the same error message appears.
Then I rebooted my laptop with a USB containing the Windows 7 (64bit) recovery tools. After, I don't have the message again. But when it goes to the starting windows animation, it stops halfway and it gets a BSOD. I tried debugging mode, it worked.
I found out that the larger partition, (Windows 7) is the C: drive. But when I boot into the smaller partition, (Windows Vista), the drive is also C:!. So I don't know what I could do.
I insert the windows 7 disk and repaired my installation, it just boots into windows 7. But when I insert the Vista disk and repaired my installation, it just boots into Vista!
I have 3 hard drives in my computer. One for Windows XP Professional, one for Windows 7 Ultimate and one just for storage. My question is can I change my Windows 7 installation to 64 bit and still be able to run XP?
I am running Windows 7 home premium 64bit. When the notebook boots up, I get two options: Windows XP Pro 64bit 2003 setup and/or Windows 7. How I could remove the unwanted Windows XP boot? which is the {identifier} of Windows XP Pro 64bit 2003 that I should delete?in MS-DOS command: bcdedit/enum I found
Whats the score with dual booting with raid 0? I guess i install the older OS(xp 32bit) first with the 32bit xp driver and then install windows 7 64bit on a separate partition with the 64bit driver. My real question is will this cause any kind of conflicts etc if using some of the drive partitions(1250gb drive numerous partitions) as communal drives. Is there anything i need to be wary of when running these two os at different "bits" within the same physical drives?
I've followed your steps and have created a partition of 50GB for installing XP Pro 64bit.
However, when I boot from my Windows C.D, it loads up the Windows files but then I get a blue screen error....
A problem has been detected and windows has been shut down to prevent damage to your computer.
If this is the first time you've seen this Stop error screen, restart your computer. If this screen appears again, follow these steps:
Check to be sure you have adequate disk space. If a driver is identified in the Stop message, disable the driver or check with the manufacturer for driver updates. Try chaging video adapters.
Check with your hardware vendor for any BIOS updates. Disable BIOS memory options such as caching or shadowing. If you need to use Safe Mode to remove or disable components, restart your computer, press F8 to select Advanced Startup Options, and then select Safe Mode.
i have a new work laptop with xp sp3 on it. I want to install w7 64 bit as a dual boot, but only have 1 physical drive. i cannot remove my current installation as it is pre-build from work, but can partition the drive etc. However on trying to install w7 64 bit I get a message saying cannot install windows 7 on efi drive with mbr, not gpt. Can I do what I want without screwing up my xp installation?
dual booting windows 7 home premium x64 with linux fedora 14 on dual independantly dedicated drives. i am a college student with moderate computer (windows) knowledge but am doing software development and would like to play around with some linux for a class. i have no prior experience with linux and have minimal knowledge of operation. i am currently running windows 7 and would like to keep it as my primary os. i do not wish to share media files across drives or os's, windows does that just fine as is and i dont want to get into a third drive. my current drive is a 1tb wd black caviar hdd. it is also currently 2/3rds full and the desktop is about 6 months old so i would rather not partition the drive for a dual boot. i would think that there are some other advantages for the os's operating independantly off their own drives other than if one hdd dies i should still have the other with its os still ok. i have read some topics about RAID configs with dual boot setups with dual drives like this but am not very familiar with RAID. is there a RAID config that would be beneficial in this situation? i currently do not have a RAID card. my tower internals are not very accessible and i dont like the idea of disconnecting drives depending on which os i want to operate.
I'm changing operating systems to take advantage of the 8g of ram resident on my new machine. Currently it's running XP in 32 bit mode. What kind of problems can and will I encounter by doing this and what is the best approach to be successful here.
I will be getting windows 7, and MS office for both computers. Mom will get basic office, I will one more advanced, the one with MS publisher. I was reading MS office site, that said get MS office 32 bit, because a lot of the extras do not work in 64 bit version.
can I run Windows 7 64bit on my computer, then add MS office 32 bit and run the 32 bit software from Windows 7 64? Or does both Windows 7 ( the OS) and MS office (the program) both need to be the same bit version?
i have the 64 bit win 7 installed in an alienware m17x r2 laptop. i have 4 gb mem installed. for some reason, windows is only registering 2.9gb installed. i have ran my mem diagnostics from the bios screen and both mem sticks come up as good. is there a reason i dont have access to my total ram?
Tech Support Guy System Info Utility version 1.0.0.2 OS Version: Microsoft Windows 7 Home Premium, 64 bit Processor: Intel(R) Core(TM) i7 CPU Q 720 @ 1.60GHz, Intel64 Family 6 Model 30 Stepping 5 Processor Count: 8 RAM: 2932 Mb Graphics Card: ATI Mobility Radeon HD 4870, 1024 Mb Hard Drives: C: Total - 223434 MB, Free - 67556 MB; Motherboard: Alienware, Antivirus: AVG Anti-Virus Free Edition 2011, Updated and Enabled
Currently, I have Windows 7 32 bit installed on my Dell Studio 15 laptop. I originally had Windows Vista, but upgraded to Windows 7 Professional 32 bit for free during an event on my college campus. My laptop is however, 64 bit capable, so I'd like to upgrade to 64 bit. I realize this entails a clean install and I'm ok with that, however I have no idea of how to do that! I don't have any upgrade discs because the upgrade was done for me at the event. I have located my product key by downloading an application online that found it for me. Now, is there a (relatively) pain-free way for me to install Windows 7 64 bit on my capable computer, even though its 32 bit right now and I lack installation discs?
How do i change from windows 7 32bit to 64bit?Do I have to reinstall, i have no windows 7 disc it came already on my computer.If i do have to reinstall how do i do it and what about my norton and other programs etc how to i save them?
This is just a personal opinion and others may very well disagree. But I think Windows 7 64-bit is better than 32-bit simply because of the ability to make better use of installed memory. A 32-bit machine is limited to 4GB minus whatever memory might be set aside for graphics, etc. Most folks see about 3-3.5GB of usable RAM on a 32-bit machine. If your machine is upgradeable (or came with) more than 4GB RAM then 64-bit is the way to go.Memory - Set Maximum Amount Used by Windows 7..As far as using older legacy XP programs you could try running them in compatibility mode. Compatibility Mode.
I know that one copy of windows 7 can only activate one computer. I have two, one already with windows 7 32bit installed and one without windows 7. I plan on buying a new one, installing windows 7 on my second computer and upgrading windows 7 to 64bit on the other. If I upgrade, will windows use the old activation key or require me to enter a new one, because that computer came with windows 7 32bit so I don't have the disc.
I have purchased a new laptop with Windows 7 64bit pre-install. It is replacing my old XP Pro 32bit laptop. What do I need to do to transfer files and programs from the older XP Pro 32 bit laptop to the new Win-win 64 bit laptop?
