Adding Unallocated Space To Primary Storage Partition
Jan 15, 2013
Previously my machine was dual-booting Windows 7 and Ubuntu. It worked fine with no problems until I decided that I didn't use nor want Ubuntu on my machine. Disk space was getting low for my primary partition and I decided it was time to let Ubuntu go. Anyhow long story short I cleared the two partitions that Ubuntu was using through the 'disk management' tool in windows. I didn't think at the time that GRUB would be stored within these partitions and that lead to the problem of being unable to boot anything.
I made and used a repair disc via another machine and then restored the bootsector code with it. That fixed the problem of being unable to boot. Now my problem is that I'm left with around 3-4 GB of wasted space in a partition. I was wondering if this 3-4 GB could be added to my primary storage partition? I've looked everywhere in the disk manager but I can't find anything there. I'm unsure as to if there is some 3rd party software available that could fix this? That 70GB partition shall remain undisclosed.
When I run out of disk space and Disk Cleanup only removes small amount of MB, can I expand my C: partition? Because I have 200 GB unallocated space on my HDD and it's unused.
I'm using Compaq Presario CQ40-627TUMy Laptop SpecIntel Dual Core Processor T4400 (2.2GHz, 80Mhz FSB,1 MB L2 Cache)- 2048MB 800MHz DDR2 Memory- 320GB 7200rpm Hard Disk Drive- 14.1' TFT WXGA High-Definition widescreen LCD panel with brightviewtechnologynd i'm using windows 7 Ultimate on boot system partition C, dual boot with linux mint. which mean i got four partition. one for linux mint. one for its swap space. one for windows 7. one for my data storage(movies,drivers,mp3,picture and etc).last few days i try to resize my C partition (120gb) to make it smaller to gain some unallocated spaces and resize the D partition because my D (almost 100gb) (ntfs/primary/data storage) almost full. i use easeus partition master v5.01.
After done resizing and restart i can't see any D partition. so i was worried that my data will disappeared. i try to look for it but there is no Drive D even on the easeus or diskpart. the only drive appears was C Drive.i remove my Linux Mint and its swap (60gb) and thinking that i could get some more free space and do some cmd prompt windows 7 repair fixmbr thing to remove the grub. then i use partition recovery to transfer those missing data from partition D to C Drive. (appears as unformatted)i try to use partition wizard home to resize it back to 300gb. and it works. but i cant make a partition. it will disappear just like that.i also try to use diskpart,command prompt diskpard, and paragon. but also not working. the C drive was shrink but theres no unallocated space and no D drive (the new create partition). i try logical partition,primary,ntfs and fat but also not working. even the unallocated space also gone. i use almost 4 3rd party partitioning software but still got no luck with it.example:i divide 300gb into 2 partition which exist the C partition 150Gb but the other one gone. i wish theres other way than format. i also done many time. doing check disk, partition table doctor, searching for bad sector. but no errors with my hdd.
Yesterday I tried making partitions in my hard disk, and I failed Here's what I did:
1. run compmgmt.msc
2. Shrink C: drive
3. my hard disk' capacity shrunk from 451GB to 260GB
4. an error window appeared ("I/O device error" I think)
5. it left me no unallocated space to create partition
using compmgmt I can't extend my hdd back to 451GB, so I used MiniTool partition wizard to restore it (btw, shrinking with MT PartitionWiz resulted the same, no unallocated space)
I have 500 GB harddisc on my laptop with three partitions. I wanted to split the 400gb into 300 + 100 GB. So, I went to disc management and shurnk the volume to 300GB. I saw 100GB unallocated space. But, when I try to create a new partition with that unallocate space, I get a message that 'media not writable' and the 100gb remains unallocated. I have used a software called 'MiniTool Partition Wizard Home Edition'. But, it couldn't apply the changes either.
how can I create a new partition with my 100gb unallocated space.
I bought a 3TB hard drive for my gf and did a fresh install of Windows 7. When I was creating the first partition the Win7 install auto created two more volumes, both labeled as Unalloated. I thought nothing of it as I figured I would be able to merge/create my second partion with the remaining space once Windows was up and running. However, to my dimay I can not create a partition on one of those random Unallocated volumes. I've tried to delete all partition but the one that my OS is running on and I've tried to create two then merger but when I right-click on the second (first one works) volume the option t create a simple volume is greyed out.
New to the forums and need some help here as I'm lost. I just got my new laptop and noticed that the C drive (O/S) was getting full and wanted to add more space. I deleted the recovery partition of 25GB so I could extend my C partition.
However, I do not have the option to expand my C drive, see the print screen link below:
I also tried using minitool partition wizard which looked to be successful but upon reboot I got an error.
I read up a bit on this on other threads but none of them are exactly specific to my issue.I need to expand my C partition by utilizing the free unallocated space on disk D (a separate disk) that I just made by deleting the only partition on there.I guess this is not possible through windows disk management tools but I didn't want to start downloading any 3rd party software for this before I got some guidance from here. lease take a look at the following screen and let me know if using the 238.38GB of unused (unallocated space) I can extend the C partition without having to delete that partition, having to backup the files on it or making images. I already backed up everything I had on the D partition and then went ahead and deleted it through the computer management tool.
I have Unallocated space at the very end of my hard drive, even after the 25gb Recovery Partition, this is due to copying my old hard drive onto this new one via Clonezilla, and it automatically keeping the unallocated space at the end. Can I either move the unallocated space around the Recovery Partition, or delete the Recovery Partition altogether? Sorry if I am being a little unclear.
I recently purchased a new motherboard. After reinstalling windows, I noticed that my primary partition is also on my Storage Drive. Is there a way to change it back to only the SSD?
I installed Ubuntu on my computer a few months ago and created another partition for it on my 1TB hard drive. I didn't really care for Ubuntu so I decided to delete the partition it was on. That might have been a mistake. Well, now there's 87.68GB of free space on my hard disk that I can't use and I don't know how to add it back to my c: partition.
There was another post about this a couple years ago, but I don't understand the instructions and am not actually sure if it worked. Can someone explain how to do this, please? I'm not completely computer illiterate, but I'm not familiar with partitioning disks. It was just the one time with Ubuntu.
I installed Ubuntu on my computer a few months ago and created another partition for it on my 1TB hard drive.
I didn't really care for Ubuntu so I decided to delete the partition it was on. That might have been a mistake. Well, now there's 87.68GB of free space on my hard disk that I can't use and I don't know how to add it back to my c: partition.
There was another post about this a couple years ago, but I don't understand the instructions and am not actually sure if it worked.
I have a set up with one SSD for windows 7 x64 and two Seagate Barracuda Green ST1500DL003 1.5TB HDD 3.5"
Without raid0 all is going well, when I raid0 the two Barracuda I have better performance but I have a huge unallocated space of 746.53 GB On Windows 7 disk management the I do not have any option for the unallocated space, as all options are grey out when I right click.
When I log off windows and delete the raid0, I can see all 2795 MB of the space, if I raid them again I end up with 746 GB space which I cannot add as a simple volume nor expand the other volume.
I just recently purchased a new internal hard drive, which will be used as storage alongside my main hd, and for some reason it has two unallocated spaces (see picture).I've looked around the forums and tried creating the partition on the first unallocated space and trying to extend it but the option isn't shown.
I'm using windows 7 home basic 32 bit.For some reasons I need to reinstall it a few weeks ago.At the time of installation I deleted 'system reserved' & 'local disk C' partitions & install new version of windows.After installation there is 3mb unallocated space.
I installed Windows 7 . during installation I made one partition (70 GB) out of all the unallocated space and left other as an unallocated space, I installed Windows then in disk management I couldn't make extended partition. Windows only allow me to made two more primary partitions. So I used MiniTool Partition Wizard to make partitions. But when I made an extended partition with three logical in it I saw two unallocated space (2 MB) after and before the extended partition. Is it usual?
I have a Getac B300 laptop running W7Pro on a single partition. Through a rather bizarre mix of nostalgia and my love for sheer simplicity, I somehow got it into my head that I wanted to run an XP Pro installation on the same machine.
The next station of this (surely flawed ) thought process led me to wonder whether I could do just that with the already existing Windows 7 installation. I got around to shrinking the C: partition, which netted me some 51 gigs of free space that I figured I could use to create a new partition on which to install XPPro. So far, so good.
As you'd expect by now, simply sticking the XP CD into the DVD drive and restarting the machine just won't work: I got the "XP can't see the hard drive" message. So, armed with Google as my friend, I ended up educating myself about how to use nLite to create a copy with integrated iaahci and iastor. Problem is, Having prepared three copies already, after I start the installation sequence and the XP CD installer starts loading files, I'm ending up with the message "the file iastor.sys could not be found," even though I did make sure to include the file that I downloaded from somewhere in the integration process.
So what am I missing here? What am I doing wrong? (I know that the whole concept is "wrong," but there you have it.)
Here are some of the specs of the machine in question:
my pc hard disc is 0f 500 GB.....the problem is that when i go to disk management option there is no unallocated space...which i can use to create new driveas my c drive is of 451 Gb...how to get unallocated space??
it contains only 1 system drive c which is 575 gb capacity and other system, hp tool, recovery and all are basi partioni shrunk C into two now i have 291 c and 283 unallocated but i cant make it or convert it into drive as it only allows dynaic drive which will make system unstable or may be i can't reboottell me the solution to use unallocated disk space so that i can use it as a backup
I startd installing ubuntu in my lappy......due to some reasons i just stopd installation and removed ubuntu disk from it.......at that time i lost nearly 150gb i mean 150gb of space remains unallocated........i tried to merge it,to create a new volume,to delete it....but of no use.
I just swapped out a failing 1Tb samsung HDD to a WD Black Caviar (the noisiest drive EVER!) and the additional drive space is unallocated, when I access disk management I see the drive, System, C, D, and 931 Gb unallocated. What to do with the unallocated space?
I have Windows 7 ultimate 64-bit installed on DELL desktop (Optiplex 990) i7 Core. I have two HDD: Disk 0 contains the operating system 500GB. and Disk 1 empty 1TB.
I want to make a partition on disk 1 to mirror the operating system partition and keep the remaining for data storage. I tried to do but I had the following error message: "All disks holding extents for a given volume must have the same sector size, and the sector size must be valid."
I have a Samsung 700Z5B-W01 new laptop. I was trying to do an install of Ubuntu alongside my Windows 7 but when I tried to do this, it just created 100 GB worth of unallocated space that I can't do anything with and it also made it to where my C: drive is only 50 MB's now.
I have been running a Dual-Boot Setup of XP Pro and WIN 7 successfully for some weeks while I get familiar with Windows 7. Recently I have almost exclusively been booting into WIN 7. In this D.B. Setup The booted OS appears as Primary Partition on the C: drive with the non-active OS as "Unallocated Space " on the D: drive. This all happens on the No 1 Hard Drive. No 2 Hard Drive has been partitioned into several Partitions, the First one as a Primary Partition with the remaining Partitions as Logical drives.
Today , when I booted into WIN 7 , there was no sign of the second hard drive and its Partitions even although both drives (Serial Drives) were recognised in the initial part of the Bios screen during this bootup. When I looked in Disk Management, I saw that the first Partition on the second hard drive appeared normally as a Primary Partition but that all remaining space on this drive was shown as "Unallocated Space". I then re-booted into the XP OS . This showed the second hard drive and all its Partitions normally, i.e. with its first Partition as the Primary and all subsequent ones as Logical Drives.
I currently just set up my new build. I decided to go with Western Digital Caviar Green 3TB for my hard drive. However, I split the hard drive into two parts: 2 TB and roughly about 770 GB unallocated space. I installed Window 7 on 2TB partition. Now, I decide to use the rest of 770 GB of unallocated space. I tried to use Computer Management, but it doesn't give me the option to create a new volume from unallocated space. Similar thing happened with EaseUS Partition Master. With Acronis Disk Director, it doesn't even recognize the unallocated space at all!!! So how can I create a new volume or even merge it with my C drive? Do I have to reformat my hard drive and split them again and do a clean installation again?
Note:I already checked, my BIOS recognizes my hard drive with 3 TB. The unallocated space is right after my C drive. There is only 1 primary MBR partition (C drive), and 100 MB system files right before it.
I recently formatted my laptop and re-partitioned it. I ended up making some Unallocated Space on the left of all the partitions. Here's a screenshot of the Disk Management window - I want to extend [Backup F:] with whole of the unallocated space. How can I do it?