i have a practically brand new ACER ASPIRE 4553 (1 month old, max) and I was experiencing some reboot failures and also having problems turning the computer on, how's that? Well, for example when rebooting the computer it did not turn back on (kept a black screen, no sounds, in other words wasn't booting). So I manually turned it off by holding down the power button and then back on, sometimes it took a couple of tries to make it work but usually that did the job.
The same logic goes for powering it on form the start.. Now, at this moment the computer won't boot up at any means, not that I know of.I noticed that the HDD light isn't blinking at all, So I though that maybe for some reason the computer could not access the HDD, the other LED indicators (< is that correct?!) aren't blinking either, actually they blink just one time when I hit the power button and then stop. The power button stays on.So I did some research and found that it could be a BIOS problem, the solution I found is for the Acer Aspire One notebook, therefore I couldn't figure out a way to make that work on the 4553, didn't even try 'cause I know how risky messing with the BIOS is.
i have just bought an Acer Aspire laptop with Vista and i would like to install Windows 7 ultimate 64 bit, i put the dvd in drive and tried hitting f11 and f10 but it just carries on going to vista,does anyone know how i can boot from dvd please?
i am having a problem with my acer aspire 6930 i think my hdd crashed recently, here is what happened i pressed power and the machine would not load to windows and with further check the hdd was not coming u in the bios so i replaced the hdd with a seagate 500gb sata, now this hdd is read just fine in the bios, i do to boot from cd and try installing windows 7, at first it looked like all was well until it passed over an hour and the install was nowhere near finished anyway this took 3+ hours and when it is rebooting to complete the installation, after it boots pass the bios it goes to a blank screen with a blinking line at the upper left of the screen, 5 mins after the line stops blinking 10 mins later it says starting windows 5-10 mins later the animated windows icon comes then that takes anther 20 mins to boot to the home screen, now i know this is not normal but cannot get any advise about it and i am forced to believe the motherboard may be faulty but i need advise in case i am missing something
I am trying to restore my sons laptop to the factory settings w/o cd and all that happens is a continous loop of restarting with an error message that says that windows 7 cannot continue. I have tried holding down the alt key while pressing f10 and still the continous loop occurs.
Not sure if this is where I should post this or not. A friend brought me their Acer Aspire one, I have tried to get it to boot, but it takes forever, then it gives a hi-low-hi-low beep that sounds like the European sirens. I put Windows 7 on a usb drive and set it to boot from the usb, but it still won't boot. It once came up with a option to repair the Windows 7, but it sat there for 10 minutes doing nothing, then started with the beeps again.
yesterday when activated my scotiabank online, i opted for phishing control software and all of sudden my os windows 7 sht down saying a problem has been detected and windows has been shut down to prevent damage to your computer. Check for virusus or recent hard disk or softtware change. check your hard drive and and make sure it properly configure and terminate.Again says run CHKDSK/F for harddrive corruption then restart your computer.i tried for windows recovery options..did not work....gone for safe mode and all options tried did not work.when starts safe mode or anything on that..all of sudden blue window appears with above message...i dont have acer CD..or windows CD..
Yesterday when I turned on my laptop windows wouldn't start and launched its error recovery. When I launched the startup recovery it gave me a black screen for 5 minutes, then an Acer desktop screen with nothing on it. The loading light will stay lit up for 5 minutes and turn off without the computer doing anything at all and stay at that screen for hours on end.
I have just come across a serious issue with my 4 year old Acer Aspire 5536 (I know its old but i like it and it still performs). Anyway when pressing the power button the fan speeds up the lights come on but the computer will not start. To get my computer to start I need to power on the computer and cover the fan vent for about 10 mins and restart and after i have done that it will run perfectly.
My Acer Aspire 5734Z always goes to a screen that says "Setup is starting services". it then says it will reboot and goes into this same loop. i cannot get out of this Loop. I do not have an Acer recovery disk but have tried a windows 7 home premium Repauir disk which has not made any difference.
my acer aspire 5250 shut down 3 days ago when i powered it up it says i need a boot disc i dont have the money to buy it is there any way to get my system back up with out the disc?
Yesterday when starting up my laptop, i realized it was running slow, i restarted the laptop to see if that woulwhen my laptop had proceeded to the "starting windows" screen, the laptop didn't show the normal loading bar, i left the laptop for over half an hour before it finally made it to the log in screen, has anyone heard of or had this problem before?
The model is 532h. The hard drive went bad so I replaced it with a brand new hard drive that's smaller in size (120GB vs original 160GB). I first cloned the recovery partition "PQSERVICE" to the new hard drive and then install it, ran alt+F10 but it shows "no bootable device". Alt + F10 worked with the old hard drive and the recovery ran fine but because the drive is bad it gave an error at the end. With the new hard drive the alt+F10 doesn't work at all. I checked in the BIOS and it's there. I changed the partition type to active but still get the same error. I finally use the recovery disk, wiped out everything and the recovery went through till the end (it said successfully) but after reboot I still get "no bootable device" error.
My Acer Laptop won't boot windows 7, when I turn on my laptop the Acer logo and "Press <F2> to enter setup" appears. Right after that it tries to boot and just restarts itself, it doesn't get to the windows logo it just flashes white at the top left corner and just restarts continuously this way till I manually shutdown. I've tried to access the windows recovery partition by hitting F10 but it doesn't work and yes this option is enabled in the bios. I've run ram checks and hard drive checks and they both checked ok. I tried using ubuntu os and get to its first menu on bootup but whenever I want to run from disk or usb drive the screen goes blank.
change boot option on acer aspire 5253-bz480 i have tried restarting the laptop and holding down each of the function keys none of these gives me boot up option,
My Acer Aspire 5820tz laptop will not work. The keyboard does not respond. The laptop sometimes goes to the Boot Manager when turned on, the boot manager flickers and is uncontrollable. Other times it gives off a loud violent beep sound. Once it went to login but the keyboard would not work so i could not login.
how do i get my acer aspire to boot, on screen msg is setup is starting servives and then theres abox comes on screen and says windows could not complete installation, to install windows on this computer, restart installation, and thats as far as it goes
I accidentally reinstalled the wrong Operating System Recovery CD on my Acer Aspire 5534 laptop, and I want to return it back to factory settings. How do I do I restore it back to factory settings?
I accidentally reinstalled the wrong Operating System Recovery CD on my Acer Aspire 5534 laptop, and I want to return it back to factory settings. How do I do I restore it back to factory settings
When i turn the computer on i get the screen : setup is starting service. Install Windows. The computer restarted unexpectedly or encountered an unexpected error. Windows installation cannot proceed. To install windows, click ok to restart the computer, and then restart the installation. I have contacted acer they tried to help with the ALT and F12. Nothing I have tried works.. They told me to order the recovery discs for $20.00. I did , and they dont work either... I contacted them back, and now they say to send it back to them and for $199.00 plus shipping, they will repair the computer..I do not have the money for that..I have the the system disc, the 3 recovery disc and the language disc , that I just ordered from Acer for $20.00.
When I press down f10 and ALT at the same time during boot up from the factory recovery disk when seeing the splash screen, nothing happens and the 'acer laptap just boots from the regular hard drive as usual.
I have an acer aspire one and when I turn it on it doesn't ask me to type my password even though I have set one. I have tried resetting my password but it still doesn't make a difference.
I already have windows 7 fom start on my acer aspire 521. Then it got slower, so I installed 2Gb memory. Now its getting slower again.So I want to fully reinstall the software from scratch. I do not have an recovery disk from the binning. So what is the procedure and do i have to reformat the c drive or can it be done without?I don't want the old registry and so on, because thats one of the problems I think.
i recently was using a product called ptedit32. In which i was trying to unhide my pq service to see what was in there. So i changed its boot from hidden to active.(0C was changed to 07) with the other three partitions being 07 as well. This has turned out bad for me now. It seems there is a mbr that is not being recognized. I turn the acer 0ne aspire d255e on and the machine goes to a screen that say can't load windows due to recent hardware or software changes.Status: 0xc0000225It also ask to have the installation disk inserted, of which there is'nt one and the computer doesn't have a dvd/cd drive anyway. It was all on the pq service, which is the hidden partition. I've tried flashing the acer pc as well from usb. and can't get that to work.
