Presario v6000 with windows XP professional. When I try to start windows I get a blue screen with white text stating that window terminated unexpectedly. Then it shuts down and attempts to reboot with the same result. I ordered a recovery disk from HP. when I attemted to install the; I received an error message stating the software does not support this system. I call HP and they claim it's a virus or a computer issue. How do I process to get my system working again? or did HP send the wrong disk?
i have a dell computer windows xp. Whenever i turn on my computer it log in and everything right but show no start bar or destop icon it just show a blue show screen blue i can get to task manger but when i try to open a program nothing happen
Recently, when trying to start up my computer, I keep getting a blue screen after it fails to start up. I've tried starting with "last best known configuration" and "safe mode," but both ultimately end with the blue screen and an error message. I've received two on various times trying to start the computer up, essentially stating
I have a laptop with Windows XP Professional SP2. I get the following error messages in my system recently, and there will be a blue screen that pops up for 2 seconds, i am unable to read the message but the system restarts, this happens frequently now and some times i am able to use my system and found a pop up message saying "system has recovered from serious error" and get the error codes.recent activity that had done is i tried to uninstall .net framework v1.1 in my system as felt that i had .NETframework v2 installed in my system so it wudnt be of no use in my system.is it related with it or anything else as i wanna prevent my system crash, Please provide me a proper solution.
Getting the blue screen on an XP machine after each solution i have tried. I have replace the ram, cleared the page file, ran chkdsk, and I was doing a repair install and I got the blue screen again. What else could it be. I used a hard drive utility and the hard drive is fine. all 4 sticks of memory can't be bad. I tried them one at a time. I need some help and thoughts.
For some strange reason I am starting to get a blue screen with all kinds of stuff on it that I do not understand. The only way that I could show it is by taking a picture of it.
Computer sudenly shut down, and after trying to restart I received the Blue screen with this error message: Stop: 0x0000007E (0x80000003, 0x805c49B8, 0xf79e02b4, 0xf79dffb0). I tryed to start in Safe Mode, Last Known Good Config. when I attempt to start inn safe mode I receive this message: PAGE _FAULT IN NONPAGED AREA. Stop: 0X00000050 (0xc4b12174, 0x00000001, 0x80537009, 0x00000000). I have Windows XP, and have not installed any new software or hardware anytime recently.
This morning when I booted up, I got a blue screen that had a message telling me something about memory (I think, was still asleep). it told me to start in safe mode.I did that then turned off. When it started back up it was in the advanced options window. I selected "Start normal mode" I have tried to get it to do it again so I could get the codes but cant. I know it showed many partitions plus the message and codes. I am using XP Home with my Dell Dimension desk top. It uses a Celeron 2.53 GHz and 512 Ram. Thank You for any suggestions. Also I delete temp regulary and defrag every week or so but don't know anything other than that as far as maintaining system.
I have a dell laptop inspiron8600 with Windows XP and SP2. I recently get the same blue screen error every time i start my computer.IRQL_NOT_LESS_OR_EQUAL STOP: 0*0000000A(0*F89181C0, 0*00000002, 0*00000001, 0*804D9BBA) I ran the dell dianostic test for blue screen errors but everything was fine. Does anyone know the reason for that problem and/or a solution for it.
I have Dell 8200, Windows XP Pro, I used computer however, it's starting to show a blue screen which says:A problem was detected windows has been shut down to prevent damage to your computer. Check to be sure you have adequate disk space. If driver is identified in the stop message, disable the driver or check with manufacturer for driver updates. Try changing video adapters. Check with your hardware vendor for any Bios updates. disable bios memory option such as caching or shadowing. If you need Safe Mode to restart your computer, press F* to select advance start up options, then select safe mode.
Is it possible to upgrade your motherboard without having to do a clean install of XP? A friend tried doing this by doing a repair and just gets a blue screen now.
Computer has crashed - coming up with only a blue screen and the following error message: STOP; C0000218 Registry file failure The registry cannot load the hive file System rootsystem 32configdefault or its log or alternate It is corrupt, absent or not writable. Beginning dump of physical memory - Physical memory dump complete. Contact your system administrator or tecnical support group for further assistance.
My computer had a turn yesterday and kept giving me the blue screen error on start-up, so using my windows disk I managed to run chkdsk. So I can get on now, but certain things won't run, like Media Centre, Firefox has forgotten my settings and also my iriver doesn't get acknowledged when I plug it into a USB port.So I am trying to run System restore to go back a couple of days.I can get into restore, and go through everything up to the point where you click 'next' in order to restore it.I click on next but nothing happens, it just stays there.
When i turn on,first Windows screen appears,then a blue screen blinks,then hp screen,then a blank page with cursor on the top left,then a screen with the message"we apologise for the inconvinience but Windows did not start successfully.there was a hardware or software problem.I tried to run it in Safe mode, Windows normally,last known configuration but no luck......Then someone suggested to Get into the Recovery Console by making a Recovery CD with ISO image but the machine is not responding to any of it.Is it with CD/DVD ROM drive or any major hardware problem???...I ran a self hard drive test and it seemed fine
I was playing a game and I rebooted my computer. When i went to start it it went to the a blank blue screen before the account screen in the beginning of XP. I know i can restore to new but i will have lost so much information that it would take about 3 months to retain it all back. It says it can not find operating system. I need help in a serious way. all advice and solutions are requested.
When I start the computer, it asks if for the choice of Safe Mode, w/ Networking, w/Command Prompt or Normally.
I've tried them all and if I try it normally, it won't get past the XP loading screen. It's loading and then it flashes a blue screen for a second and then restarts the computer again.
I tried pressing F8 at boot and selected 'Disable automatic restart on system failure' and this is what I get
I even tried using this http://forums.techguy.org/6669592-post28.html to get to chkdsk At boot, F12, chose CD/DVD, but still nothing, I even tried disabling boot from +HDD, FDD and LAN from the bios setup menu to see if it works and this is what I got, it just keeps going on and on unless I enable boot from +HDD
XP won't get beyond a 'blue screen' since I attempted to update the IDE ATA / ATAPI Controller drivers. The update went as planned, until I selected the best version. XP then restarted my computer and a 'blue screen' appears refering to 'atapi.sys' as being the problem.I can't get XP started in any form of Safe Mode by accessing 'F8' during startup. The only part accessible is the Bios.
I have a Gateway 450SX4,Ser.#0027460659.Desktop on Windows XP. I tried starting it in Windows Normally,and safe mode.All that comes up is a blue screen that says,STOP:c0000218{Registry File Failure} the registry cannot load the hive (file):systemrootsystem32Configsoftware or it's log or alternate.It is corrupt, absent or not writable.Begging dump of physical memory physical memory dump complete.
I've got an IBM R52 Laptop it's running Windows XP and is a few years old. Just the last couple of days I've been having trouble getting it to start - I get the Blue Screen and when I finally do get it going the System Error message. There are several such ERROR Events which say the source is Dhcp there are also some Event 57 ftdisk.If anybody has any ideas about what I may have done to create this problem, please respond. The only thing I can remember changing in the past few days is starting to use a USB headset. I noticed this afternoon that when I unplugged the headset instead of going to the Blue Screen again - the computer went forward as usual.
i am using a toshiba satellite with windows xp sp3. I got a blue screen and my laptop crashed right away. When i restart my laptop the start up took very long. Im not sure what i did. But i remember changing my antivirus from eset to panda then to eset again. Putting back eset didnt solve the very slow start up so i decided to unsinstall it again and now i dont know what to do. please help. i dont know if i got a virus or what.
Computer started running slow and then locked up for no reason. Upon trying to reboot, I got a boot disk error, then a ntldr error. After running my setup disks I get the blue screen Stop: 0x0000007f ( 0x00000)unexpected_kernel_mode_trap.
Can I start a bit vague here as I know nothing about computers.I have a Mesh computer running Windows XP. I upgraded to Vista but ended up with a reformat and reinstalling XP clean and the computer was running fine. For no reason at all (ie no changes were made), Windows suddenly wouldn't load and I got a blue screen with KERNEL-DATA-INPAGE-ERROR (or similar).There was a bit of a delay as I took out the stock Seagate Barracuda 250Gb SATA and couldn't get hold of a replacement so replaced it with a Samsung Spinpoint F1 750Gb which it wouldn't auto-detect for love nor money. My neighbour claims my RAM is OK and the Samsung detected OK in his machine.I therefore took out the Samsung and bought a new Seagate Barracuda 320GB SATA drive and fitted that. The BIOS auto-detected it and I tried to install Windows. It allowed me to create a partition but then proclaimed it couldn't format the disk. I then got a blue screen with PAGE-FAULT-IN-NONPAGED-AREA which variously blamed the partmgr.sys file and the setupdd.sys file.
When you press Enter to continue it says <Setup disk not recognised> or something like that. Sorry to be vague but I'm having to try and remember this in work.Now because the machine has had problems with two hard drives, I'm fairly sure it's not the HDD itself but much beyond that, I'm completely lost.MESH support haven't really been much help and have recently sent me a BIOS update file which I am lothe to use because I'll probably screw the whole thing up and I think I need to resolve the problem before adding any variables...or maybe just buy a new computer.Any pointers would be good. I have no technical knowledge I'm afraid and obviously no access to the internet from the machine itself. I have no boot disk either.
I just bought a brand new Western Digital 120g Hard Drive. I am trying to put it together with some other spare parts to make a computer. The mother board isnt too old, it a 1.2 gig pentium 3 I believe. When ever I first installed the hard drive, I tried to install windows. When ever windows is finished setting up, the computer restarts, windows starts to load, and then I get that awfull blue screen that reads "Unmountable_Boot_Volume" blah blah blah. I can get it into safe mode, but that is it. I have tried everything on this newsgroup, from loading the service pack, changing things around in the bios, chkdsk /r, chkdsk /p, fixboot c:, and a couple of other things. I also tried the lifeguard disk that came with the hard drive.
Ok this error will only pop up only about 3/4 of the time I attempt to go into Windows. Right after the windows boot screen finishes I'll get a blue screen of death for windows xp, and it says a bunch of numbers and stuff then at the bottom there is a file called tbcwdm.sys. This just started happening in windows, and I can't write the code down because the screen will dissapear in a matter of seconds and reboot the computer.
I currently own an older dell latitude cpx laptop, its fairly outdated, i know but im currently running it off of my wireless router, i have a d-link wireless-g adapter in my pcmcia slot, but when i boot my laptop with it, i get blue screen errors, but if unplug it and boot it up then plug in my adapter, it works perfect, i know its not a big deal to just plug it n after i boot up but i was wondering.
I tried to boot from the XP CD, and it does the whole blue screen thing until starting windows then it just hangs up. When I boot in safe mode, or attempt to, it gets stuck on system32driversagp440.sys.
i left my comp on to download last night but when I got up I received the message below and i always receive it now when i restart/reboot. i'm a computer noob so i don't know much about comps so can you please help me out and i tried reading about it on the microsoft site but still no closer to fixing the problem.
I've recently built a new computer and it works amazingly except for the fact I get a blue screen once in a while I start up my computer. I tried to find a way to take a picture or something for the blue screen but it restarts a second after the blue screen appears. I couldn't get much information on the bluew screen but I remeber it said something like "no_page_setup" or something similiar. If I don't get the blue screen, sometimes my computer just freezes on me
I have been having this issue with my computer where every 5 10 minutes, I keep getting the blue screen with lot of different messages each time. Some of them are: Driver_IRQL-Not_Less-Or-Equal Page_Fault_In_Nonpaged_Area NTFS_File_System IRQ_Not_Less_Or_Equal on the bottom of the screem it gives you all kind of different files Some of them are NTFS.SYS LMouke.SYS Usbuhci.SYS
